Question about 2005 Chevrolet Impala

1 Answer

2006 Chevy Impala - Heater recently worked on by garage and "control unit" replaced. Now heater motor runs on high at all times irregardless of fan speed control setting and whtehr ignition switch os on/off or even key in/out of switch. Returned to garage and mechanic appears more confused than I. Can you please offer any suggestions?

Posted by on

  • 2 more comments 
  • Anonymous Mar 24, 2009

    fhjfjhkljL:

  • pjones1 Mar 24, 2009

    where is the blower motor resister at on the 2006 imapla

  • Anonymous Mar 21, 2014

    Heater fan suddenly came on full speed and will not stop even when the switches and ignition are off.
    This happened after the battery went flat and I had to jump start from a battery pack

  • Anonymous Mar 30, 2014

    fan contimuously on

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 261 Answers

The blower motor resistor is damaged probably in the process of removing the heater core replace the blower motor resistor, and please dont forget to rate me!!

Posted on Dec 02, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 chevy impala passenger side blows heat out continuously, driver's side works fine with heater & AC


You may find a reset will solve this annoying problem. The problem you have is the GM heater control unit has lost it's calibration, which can happen from time to time. The way to reset it is, start your car and turn your heater off, and shut off the car, pull out the keys. Then with vehicle off, disconnect the battery, (or batteries if it has two). Let sit for 10 minutes, then re-connect battery. Get in and start the engine, DON'T touch anything, let the heater control unit re-calibrate for at least 40 seconds, (by the clock), then try turning on the heater.
Good luck!

Jul 18, 2013 | Cars & Trucks

1 Answer

Kia Sportage 2006 . . heater blower motor resistor keeps failing. heater fan won't run


Have you replace the heater blower motor? It sounds like it is shorted.

Mar 05, 2012 | Cars & Trucks

2 Answers

My blower motor on my 2006 Sentra went out. Do I have to evacuate my A/C to replace this motor?


You mean the fan in the car? No you dont. It just blows air through the heater / cooler core.
Its very unlikely to be the fan itself. If its not blowing then check the fuses first.

There is also a voltage ballast which controls the different speeds. This is usually located in the airflow from the fan to keep it cool, and is about $15. Usually one speed still work if this goes out. High should work. [Look under the dash of passenger side in the air flow ducting, maybe behind the glove box. Look for a connector block with 3-4 wires comming out, held in by 2-3 screws. Dont run it outside the air flow, it may burn out real quick.]

Last, there may be a relay under the hood in the elec distribution box.

Jul 19, 2011 | 2006 Nissan Sentra

1 Answer

My 2000 chevy impala heater fan control doesen't work at all. everthing works,except when you turn the control on any setting the blower motor won't come on/? no blowen fuse.


the resistor to the blower motor is bad or the motor itself, the resistor should be right next to the blower fan a heavy gauge wire plugs into it, or it might even just be the wire, it is common for them to melt

Oct 21, 2010 | 2000 Chevrolet Impala

2 Answers

2006 impala heater motor blows like normal but some mornings it blows cold if we shut it off and turn it on a couple of times it will blow hot and work fine. the heat gauge is at half way when the engine...


this problem is caused by a sticking air temperature control blend door actuator or blend door, this door moves back and forth to get the desired temp, the actuator is electronic and prone to this type of problem, suggest u replace it.

Sep 23, 2010 | 2006 Chevrolet Impala

1 Answer

1997 Chevy S10 pickup Fan switch for heater runs on high only.


replace the blower motor resistor located on the heater box were the blower motor is located the wiring to the blower may go to it. This is very easy to locate if you buy the part first.

Jan 06, 2010 | 1997 Chevrolet S-10 Pickup

1 Answer

Blower fan runs high only on 2006 Ford Explorer


if you have manual control climate control then the system has a blower motor resistor . if you have automatic climate control then the system has a blower motor speed control. in eather case the part is under the dash in the heater box. depending on the system you have, buy the part and then look under the dash for like part, you will half to remove the under dash panels to be able to see. the part will be on the heater box somewhare.

Jan 21, 2009 | 2006 Ford Explorer

2 Answers

Heater fan motor wont run on high


Check or have checked the blower motor resistor. This is usually how they act.

Oct 25, 2008 | 1995 Oldsmobile 88

Not finding what you are looking for?
2005 Chevrolet Impala Logo

808 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...