Question about 1991 Ford F150

1 Answer

I have not heat in my windstar. air seems to work there is a clicking noise coming from the heating system when levver is moved to the heating side but not when moved back to the ac side. thermostat was changed recently. This is a 1999

Posted by on

  • 1 more comment 
  • bigmama48 Dec 02, 2008

    2001 ford windstar heat don't work nor dose the milages tip and it also the computer reads error on it.

  • yadayada
    yadayada May 11, 2010

    Please post your problem one time.

  • Anonymous Mar 22, 2014

    big clicking when the ac selector is moved

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had the same problem with my ford explorer. I can not recall the name of the part. However I think they call it a heater ductdoor. Check with any of your local parts store and I'm sure they can give you the proper name for the part.

Posted on Dec 16, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a clicking noise under dask on passenger side.


if you can reach the heater box. see if you can "feel" anything moving in the area of the air mix door, if the controls are the rotary style, it is somewhat common for the controls to be bad. There are no conventional cables with this system, it electrically controlled...

Mar 04, 2015 | 1999 Chevrolet Silverado 1500

3 Answers

Fan/ventiation system has clicking noise; movingheating/cooling slider reduces or stops noise ; no or reduces warm air. 2000 windstar


Automobile ventilation systems usually use a cable that connects a motor to a flap that blocks or permits air to pass to certain vents. There is also a flap which permits or blocks air from passing through the heating coil or a/c unit. A screw may have come loose cause the cable to slide without moving the vent flap, causing the flap and cable to be misaligned. Underneath or behind the dashboard is where all of this is located. Some vehicles it is easy to access and fix the cable/flap/screw problem, such a pickup trucks. Have a mechanic look at your ventilation system, as if the problem is a loose screw, it is a very easy fix, and shouldn't be too expensive with an honest mechanic.

Jul 10, 2010 | 2000 Ford Windstar

2 Answers

Heat selector malfunction


Where is the clicking noise coming from, the engine compartment or the dash panel? Probably not the heat selector switch, so I'm willing to bet the thermostat is sticking and not opening, which is lesding to you not having heat and the clicking noise you are hearing. Replace the thermostat.

Mar 10, 2010 | 2000 Ford Windstar

1 Answer

The front heat selector for my 2003 windstar does not work, it is loose and all I get is cold air, the rear heating works fine.


I have a similar problem with my 2000 Windstar. Mine makes a clicking noise/thumping noise when I move the temp. control. I was told it is the "Blend Door Acutator" which makes sense. The little actuator must have a stripped gear, and is not working as it should. I am in the process of removing mine to get at the "blend door" to try to set it to the heat side for now. It is not above the radio as someone had suggested, mine is located in back of the radio.

Dec 09, 2009 | 2003 Ford Windstar

4 Answers

NO heat in front of 2001 windstar van. Thumping


Blend air door may be stuck. I removed a pencil from a heater box before. It had fallen from the dash, down through the defrost vents and jamed the door.

Nov 13, 2009 | 2001 Ford Windstar

2 Answers

2003 winstar no heat


Check the operation of the temperature control door. It is located in the center of the dash behind the radio. Look up between the gas pedal and heater case. It is white in color Move the temp knob while watching the actuator. If it is clicking it is bad. Good luck.

Oct 12, 2009 | 2003 Ford Windstar

1 Answer

Noise when moving heat contol lever accoss no heat sometimes 202 windstar


Check the temperature control actuator. If the noise is a clicking sound it is the actuator.

Oct 05, 2009 | 2001 Ford Windstar

1 Answer

Lexus rx 300 Air suspension fault


No air or heat comes out of the floor vent

Mar 26, 2009 | 2003 Lexus RX 300

1 Answer

Heating problem in a 1999 ford windstar


This noise is the blend door electric stepper motor, this motor controls the door inside the heating ducts that diverts air across the heater core to heat the van, either the bleen door is warped from heat and stuck, or the blend door motor is defective, in order to fix this the dash assembly must be pulled to gain access to the motor and the door.

Dec 02, 2008 | 1999 Ford Windstar

5 Answers

1999 Ford Windstar 3.8 no heat


If you have a knock or clicking noise behind the radio, it is the blend motor. The blend door is spring loaded and the gears in the blend motor are "stripped". The door is spring loaded so that the door is closed to the heater core. About 2 hours to replace and a lot of bending and stretching. You don't have to remove the dash, but all of the trim, radio, and controls will need to come out.

Nov 12, 2008 | 1999 Ford Windstar

Not finding what you are looking for?
1991 Ford F150 Logo

160 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...