Question about 2002 GMC Envoy

Open Question

ABS on Envoy 2002

ABS Light. At start up when have to push the break for the first time they act like they are hesitating and the truck doesn't want to stop as well.

Posted by on


5 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: abs sensors

If its the front sensors,you have to remove the backing plate to get to the sensors.Alot of time you have rust building up between the hub and the sensor,which pushes the sensor away from bearing and thinks its on a slippery surface.You need to clean that rust out from between sensor and hub.There are three bolts holding hub and backing plate in place,you have to remove these things to get to sensor.Hope this helps.

Posted on Mar 01, 2009

  • 1 Answer

SOURCE: I dont have an owners manual for my 2002 gmc envoy

it is in the fuse box under the hood. it is a 25 amp fuse. look at the wiring instructions under the fuse box cover.

Posted on Jul 10, 2009

  • 12744 Answers

SOURCE: ABS problem with GMC 2002 Sierra

its a low speed abs activation the problem is in the front sensors they need to be cleaned or replaced they [or one] probably has some corrosion on the sensor --[the 99 chevy tahoes had a limited recall over this issue and the fix was to remove and clean the abs sensor or if to corroded replace ] this problem doesnt set off an abs code or trouble light also sometimes the abs will activate by itself at under 4 mph without even touching brake

Posted on May 15, 2010

  • 3 Answers

SOURCE: I have a 2002 sierra gmc 4 x 4, when I come to a

it is your abs module i have the same truck and same problem i just pulled the fuse cuz the quote i got to fix it was just over 2000

Posted on May 25, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 2001 dodge 3500 dually diesel, and my brakes are acting funny i need help figuring this out. when you push on the brake pedale its like you are pushing on air sometimes then other times when you...

You have an ABS light on !!

Why wouldn't you have had it checked for fault codes
& had the problems resolved?

We have only had those dash lights & codes for
over 30 years, so no reason not to know the drill

Sep 02, 2013 | Cars & Trucks

1 Answer

2002 Yukon Hesitation when starting- No checking engine lights!!

This can be fuel pump related or just fuel filter related, spark plugs and injectors.
When engine is cold vaporization of gasoline is minimum. When fuel vapor is less than required and the fuel mixture is not ideal, ignition happens harder than it does under ideal running conditions of engine. When fuel pups is sweak, or filter is limiting, or fuel injectors are not injecting gasoline with improper pattern inside engine, or just becasue of corroded spark plugs, cold engine faces difficulties during first ignition.

PS: sometimes car starts and fails to start once more. this can be a sign of broken crank position sensor. FYI.

Nov 18, 2011 | 2001 GMC Yukon Denali

1 Answer

2002 grand prix, changed the MAF due to code, tried a TPS from a shops recommendation. Also replaced fuel filter, car still hesitates and acts like it has a wrong fuel air mix. The hesitation happens...

It makes me wonder if the new MAF sensor did not fix the problem in that circuit? Were the codes cleared after replacing it? And engine light stays off? Only way to know is have them or someone check for new codes again. The codes direct you to a circuit malfunction. That's why a new sensor doesn't always fix the problem.
It may be something else, but one place to start is have the codes read again. If, as you say, may be an air fuel mixture, you could have your fuel pressure checked to see if it is up to specs. At least eliminate that possibility. Good luck.

Nov 12, 2011 | 2002 Pontiac Grand Prix

1 Answer

2003 Landrover Freelander SE V6 == Service Engine Soon (not Check Engine) light has been infrequently flickering on/off for the past 8 weeks. While light is on, engine hesitates slightly.Vehicle would not...

If it won't start have a compression test done and see if one bank doesn't have compression . The intake cam is known for breaking at the front lobe

Nov 09, 2011 | 2002 Land Rover Freelander

1 Answer

My ABS light came on about 3 months ago. Around the same time my speedometer started jumping and acting erratic. Now it doesn't work at all. I haven't gotten my ABS fixed yet. Does the ABS have...

unfortunately it doesn't, it runs off of a different speed sensor.. these vehicles are known for the speedo going out their is a defect in the instrument cluster, and you will have to have the entire unit replaced. while working at a gm dealer, I replaced hundreds of them..

Jun 22, 2011 | 2003 Chevrolet Tahoe

2 Answers

How to reset change oil light in 2002 gmc envoy

On a 2002 Envoy you turn the key to run but don't start it. Then push and release the gas pedal 3 times within 5 seconds. The change engine oil light should blink for 5 seconds meaning you have reset the system. If it doesn't blink for you do the procedure again.

Feb 08, 2011 | GMC Envoy Cars & Trucks

1 Answer

2002 envoy abs light on and no blower for heater

The ABS light could be many things. I would bring it into a place that has a Tech II scanner that can talk to the ABS module and it will pinpoint where the problem lies. My problem was the contacts under the horn, so I honked the horn 3 times and the light went off. As far as the blower, if you don't have automatic climate control, it may be your blower resistor module on the blower itself, which is a common problem with these.

Jan 12, 2011 | 2002 GMC Envoy

1 Answer

2002 envoy stalled going down road started right back up but had no speedometer wouldnt shift and abs and brake light came on

I had same problem with 2005 Envoy XL 4.2L
After several trips to dealer with "No problem found"....I finally found a technician that determined my ignition switch was intermittently not reading the security chip in the key.
Replaced ignition switch and problem never re-occurred.

Aug 23, 2010 | 2002 GMC Envoy

1 Answer

1998 pontiac sunfire - battery light on, abs light on, air bag light flashing - what is wrong. Car is hesitating and pulled into driveway and it shut off itself and when try to start it will not start,...

Sounds like you have a low battery supply and the car would act up if it does not have enough electrical supply.
Check the battery and alternator for proper values.
Hope that helps

Jun 13, 2009 | 2002 Volkswagen Jetta TDI

1 Answer

Engine will crank but not start

i think is yr car abs module fault

Jan 12, 2009 | 2002 Volvo S60

Not finding what you are looking for?
2002 GMC Envoy Logo

Related Topics:

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides