Question about Buick Park Avenue
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
there is a pic under the hood that showes the corect way to run the belt. over and under diferant pulleys. figure out the corect way it goes and use a breaker bar to pull the tenchenor so you can slide the belt on, then let go slow and your done. the soring holds the pulley at the exact right tension. you can do this it's not that hard... good luck
Posted on Jul 09, 2009
SOURCE: 91 buick park ave.
Well, that can be a ton of things. Usually it means: A. its not getting enough air, or any air. B. Its not getting enough gas. It could be a problem with the Mass flow Sensor- which can be cleaned or replaced-, or maybe a bad fuel pump or bad fuel lines or something. Either way the problem sounds like it just can't run because it can't get enough gas.
Posted on Aug 16, 2008
Remove or Disconnect
Door handle trim plate.
Remove or Disconnect
Posted on Mar 14, 2009
Order the exterior door handle AND the clip that attaches the rod to the exterior handle from your local dealership ( any part in the salvage yard will have at least as much wear as the one U are replacing ) Also order a can of touch up paint matching your car. After you have the parts and have painted the new exterior handle, roll down the window and remove the interior door panel. ( instructions have been posted at 'replace door lock buttom' ) Two nuts, one on each side, hold the broken handle in place and must be removed ( DON'T loose them ). Loosen the rod from the clip at the top to allow a bit more room, But take note on the way it is attached ( you will need to reattach the rod to new handle ) To install new mechanism put the new clip on the rod, carefully place the gasket and the new handle in place and install nuts to secure. Test the door handle and make sure it works. Reinstall interior door panel.
Posted on Aug 24, 2009
i have a 98 buick park avenue
i got a problem running it. it start but when i hit the break pedal some light comes out the direction signal and it shuts off i check all the fuse
Posted on Aug 13, 2010
Tips for a great answer:
Oct 30, 2015 | Cars & Trucks
Sep 30, 2013 | 2002 Buick Park Avenue
Mar 27, 2013 | 1997 Buick Park Avenue
Feb 16, 2013 | 1999 Buick Park Avenue
Jul 28, 2012 | Buick Park Avenue Cars & Trucks
Jul 08, 2011 | 1997 Buick Park Avenue
Sep 09, 2010 | Buick Park Avenue Cars & Trucks
Jun 27, 2010 | Cars & Trucks
1,106 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: