Question about 1995 Isuzu Rodeo

1 Answer

I have v6 95rodeo,oil pressure is low,how can i removed the oil p

I heared a noisedta the top

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 21 Answers

Noise is normal dont worry . put oil stabilizer in it it might quiet down but they all have low oil pressure sinserly your mechanic

Posted on Jan 05, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 1995 Buick Century special four-cylinder, what are the symptoms of worn out pushrods?

You would hear a loud ticking sound up top
.The lifters would be making a bad topping sound up top. Take it down to the rockers and you would hear the cylinder that makes the noise.and see.

Oct 16, 2015 | Buick Cars & Trucks

1 Answer

Flashing top light 2008 vw convertible

Make sure you hear the beep after the top is down. The beep indicates the top is in full resting position. If you don't hold the button until you hear the beep, the light will continue to flash.

Apr 20, 2014 | 2008 Volkswagen Beetle

1 Answer

1992 porsche 911 cabrolet, top is stuck I hear the motors with the switch both ways but top will not move, sounds like top motor is free spinning

hello there
Is the top stuck on the top of the wind shield and does not lock in?
What motors do you hear?
Let me know..

Jul 16, 2011 | 1992 Porsche 911

1 Answer

Hi my convertible top isnt going back when i mash the switch all i hear is a clicking sound is that the fuse

The sound you are hearing may be the relay. You may not have power to the relay or you may have a problem with the motor that runs the top. Use a voltmeter or a test light and check to see if there is power to one of the motor wires when the switch is moved. If there is power then you probably have a bad motor.
Hope this helps... Dale

Apr 20, 2011 | 2001 Toyota Camry Solara

1 Answer

I have a 93 honda accord, the timing belt slipped so i had to replace it i set the cam top to top and the crank to top also set the balance shafts. car still will not start, when i try to crank it it trys...

the valves are bent if you lost the timing belt you need to do a compression test. the low cylinder needs a leakage test to see where it is losing compression you can get each cylinder on compression stroke and put air pressure in the spark plug hole and listen to the exhaust pipe if you hear it hissing the exhaust valve is bent for that cylinder if you hear through the throttle body the intake is bent on that cylinder if you hear it in the valve cover with the oil cap off then the rings are leaking

Dec 08, 2010 | 1992 Honda Accord

1 Answer

Convertible top wont open, i hear clicking i the

Check the relay near the motor. That is what is clicking, trying to engage.

Oct 25, 2009 | 1994 Audi Cabriolet

2 Answers

Mustang 2001 convertible top goes up but not down.

Sounds like the switch is bad. Also check the relays. You might have one for up and one for down.

May 23, 2009 | 2001 Ford Mustang

1 Answer

1992 porsche carrera convertible top won't open. It starts to open then you hear a crunching noise from one of the top motors behind the seat

Replace the top motors or check cables from motors to top. There are 2 motors one for each side of the top.

Apr 25, 2009 | 1990 Porsche 911 Carrera

1 Answer

Convertable top wont go down..I hear motor running

Your top motor is in the trunk on the drivers side wall behind the panel. Remove the two screws to remove the cover. Check the fluid level in the reservor. Check that no lines have come off of the pump and have someone pushing the top down button while checking. If this is not the problem, then it is a possibility that the e-brake connection is not working right.

Dec 09, 2008 | 1998 Volkswagen Cabrio

1 Answer

Metal creeking noise coming from above windshield

hree trips to two different dealers finally fixed it. Above the windshield there is a piece of molding that covers the top of the windshield. The clips holding that on were not clipped on properly and the piece was separating from the windshield at high speeds causing a medal creaking. Most likely happened when I had the windshield replaced.

May 14, 2008 | 2007 Mercedes-Benz CLK63 Convertible

Not finding what you are looking for?
1995 Isuzu Rodeo Logo

Related Topics:

334 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides