Question about 1984 Chrysler LeBaron

1 Answer

Engine misses I have a 1984 Chrysler Lebaron that misses when running. It starts up strong when started first thing in the morning, but quickly starts missing and running rough then dies. It starts out slow and takes a while to gain speed. The mileage is only about 15 mpg. I replaced the plugs and plug wires.

Posted by on

  • jwhipple2003 Dec 04, 2008

    How hard is it to change a head gasket in the 1994 Chrysler New Yorker? I don't want to pay $1500 to have it fixed. Do you think it's worth fixing or just get rid of it?

  • Anonymous Mar 24, 2014

    went to start the van in the morning it was about 30 degrees out it started but sounded like there was a miss in the motor but ran. i let it run for 6 mins and it ran fine after that all the way to work. Then on break went to start it was about 34 degrees and did the same thing. then when i got off work it turned over and acted like it was gonna start but didnt. now it sounds like its not getting any fuel but you can smell it and it still turns over


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 109 Answers

You could have a blown head gasket in between two cylinders.or you need to change your fuel pressure regulator,you might need a new fuel filter..

Posted on Dec 02, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

No start, if you jump across starter will start. I replaced starter relay but no difference.

Try replacing the starter solinoid too, or if that does not work you may have a wiring issue.

Aug 24, 2013 | 1984 Chrysler LeBaron

1 Answer

93 lebaron died while running, now clicks when being jumped.

From what you describe, my guess is that eventually you will replace the starter

Apr 24, 2013 | 1993 Chrysler Lebaron

1 Answer

I checked the spark from the coil and got one spark thats all

The first thing you need to do is run a fault code test on the electronics, to do that go here.

Nov 07, 2012 | 1984 Chrysler LeBaron

1 Answer

My 95 3L Lebaron Dies when the car is stopped. It starts then dies immediately, after many cranks with lots a gas it will run. Only happens when cold.

I'd use a gage and check proper fuel pressure, key on engine off. My info says 48 psi.
How long since over-all tune up?

Apr 16, 2017 | 1995 Chrysler LeBaron

1 Answer

Wiring diagram for 1984 Chrysler LeBaron ignition system

Try repair manual here

Oct 23, 2010 | 1984 Chrysler LeBaron

1 Answer

How to replace a 1984 Chrysler Lebaron ignition switch

the ignition switch is located under the dash on the steering column and is simple....
disconnect connector, remove to screws and replace switch

if however, you mean the ignition tumbler, the place where you put the key, then it a lot tougher

Jun 04, 2010 | 1984 Chrysler LeBaron

Not finding what you are looking for?
Cars & Trucks Logo

208 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides