Question about 1999 Toyota Camry Solara

1 Answer

01 solara fog lamp replacement

I removing the front bumper the only way to replace a burnt fog lamp? If so, what is the best way of doing it?

Posted by on

  • Toyota Ed May 11, 2010

    No, you do NOT remove the front bumper cover to change the fog light bulb.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 4 Answers

Nono... go in through the engine. Pop the hood and you can do it without detaching anything but the old fog lamp.

Posted on Jun 08, 2009

  • Mellville David Sep 12, 2013

    I need to buy new parts as mentioned

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bumper Removal


This video should help you. The bumper should not have to be removed.
http://www.youtube.com/watch?v=8ap1-CzG5Hc

Apr 27, 2013 | 2001 Toyota Camry Solara

1 Answer

How can I remove the fog light caps on my 2007 Eclipse so i can install the actuall fog light?


Most fog lamps are replaced on your back,
by reaching up under & behind the lamp
holder e.g. behind the front bumper fascia

Nothing to remove other than the lamp socket

Jun 29, 2011 | Mitsubishi Eclipse Cars & Trucks

1 Answer

I need to replace a foglamp bulb right side.I have fairly easy access to & can see the rubber housing for the bulb,but cannot figure out how to remove it.Do I need to rermove the entire assembly in...


Typically the fog lamp is located in the front bumper assembly. It's usually fairly easy to access and replace these.

Place the car is park, secure parking brake. Use a creeper to scoot under the front end of the car, look up into the bumper. Located the backside of the fog lamp holder. You would usually grab and twist counter clockwise about an inch, then pull straight out. Push in on the bulb while turning counter clockwise until it pulls out of the lamp holder.

These fog lamps usually have a little bit of cushioning grease in the socket. Do not remove the grease or connectivity problems will result with the new fog lamp. Push the new bulb in, turn clockwise until bulb stops turning, release hand pressure.

Installation is the reverse of removal.

May 25, 2010 | 1999 Oldsmobile Eighty Eight

1 Answer

How do I change my fog light bulb in my 1999 oldsmobile alero


YOU HAVE TO REMOVE FRONT SPLASH SHIELD TO REPLACE FOG LIGHTS.THEN YOU REMOVE THE TWO BOLTS RETAINING THE FOG LAMP TO THE BACK OF THE FRONT BUMPER REINFORCEMENT BEAM AND LOWER THE FOG LAMP.

Apr 30, 2010 | 1999 Oldsmobile Alero

1 Answer

How do I replace the Drivers side fog lamp (not just bulb) on my 2002 Audi A4 18T?


First remove the driver's side fog lamp plastic cover out from front bumper. After that you will find torx socket head panel screws from fog lamp. See picture below:

de0b0fe.png

Feb 06, 2010 | 2002 Audi A4

1 Answer

D40 fog lamp replacement


FOG LAMPS WILL UN BOLD FROM BEHIND THE BUMPER.THEN JUST UNPLUG AND DO THE REVERSE TO FIT THE NEW ONE

Dec 27, 2009 | 2006 Nissan Pathfinder

1 Answer

How do I replace the fog light assembly on a 2000 Olds Alero?


you replace the fog lamps by going under front bumper fascia.remove the pushpins and take down the splash shield to access the back of the fog lamps.then you remove two bolts retaining the fog lamp to the back of front bumper.besure to wear clean gloves.because fog lamps is halogen bulbs.if you touch with bare hands the oils from hands will make the bulbs over heat and blow out.

Dec 03, 2009 | 1999 Oldsmobile Alero

1 Answer

Replace front left fog light bulb on 2000 Volvo


no, just remove under covers to gain acess to rear of lamp ,this is where you can replace the bulb no need to remove bumper, thats just crazy anyway hope this helps good luck.

Oct 13, 2009 | 2000 Volvo S40

1 Answer

How do you replace the fog light bulbs on a 2004 buick regal?


Notes FOG LAMP BULB REPLACEMENT - FRONT

REMOVAL PROCEDURE
f98bf40.gif
  1. Remove the front bumper fascia deflector.
  2. Disconnect the electrical connector from the front fog lamp bulb/socket. CAUTION: Refer to Halogen Bulb Caution in Service Precautions.
01c84b0.gif
  1. Rotate the front fog lamp bulb/socket counterclockwise to release.
  2. Remove the fog lamp bulb/socket from the front fog lamp assembly.
4065803.gif


  1. Install the fog lamp bulb/socket to the fog lamp rotating clockwise until fully seated. CAUTION: Refer to Halogen Bulb Caution in Service Precautions.
b182709.gif
  1. Connect the electrical connector to the front fog lamp bulb/socket.
  2. Install the front bumper fascia deflector.

Jun 16, 2009 | Buick Regal Cars & Trucks

1 Answer

How do you replace the fog lamp on a 1997 dodge neon? As best as I can tell, you have to take off the front bumper which I hope is not the case.


To replace the fog light of the passenger side you need to remove the fog light bolt and pull out the fog light assembly, then you can remove the bulb and put a new one in.

To replace the fog light on the driver side you will need to remove the front bumper cover so you can remove the vacuum box that is in the the way of the fog light bolt.

To do so you need to remove the Torx (star) screws located in the front wheel wells as well as the bolts holding the plastic by the radiator. "CAUTION: DO NOT UNBOLT THE RADIATOR."

If any of the screws are rusted into place put some penetrating oil them to help loosen them up.

PLEASE DON'T FORGET TO RATE!!!

Mar 16, 2009 | 2002 Chrysler Voyager

Not finding what you are looking for?
1999 Toyota Camry Solara Logo

483 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...