Question about 2004 GMC Envoy

Open Question

SEE MANUAL-TAILGATE IN DIC

THE ROOF,TAILGATE,REAR WINDOW &REAR WIPER IS NOT WORKING

Posted by on

  • xuvman Feb 28, 2009

    I just bought a 04 Envoy XUV and the rear window won't go down with the inside switch, but does with the key. Also the roof won't open, nor will the rear wiper work? Any ideas?

×

6 Suggested Answers

  • 76 Answers

SOURCE: can't open tailgate and rear window

if you take off interior panel.....push out the dent with a bar....then try button if no work go back inside and you should see bars going down from handle to latch area...pull up on it and should pop the trunk

Posted on Dec 02, 2008

emissionwiz
  • 61037 Answers

SOURCE: 1987 toyota 4runner tailgate window stopped working

REMOVE THE REAR TRIM PANEL ON THE TAILGATE AND SEE IF THE MOTOR IS GETTING 12 VOLTS AND A GOOD CHASSIS GROUND CONNECTION, MANY TIMES THE WIRING HARNESS THAT GOES IN TO THE TAILGATE DEVELOPES A OPEN/BROKEN WIRE FROM THE REPEATED OPENING AND CLOSING OF THE TAILGATE, THE WIRE BREAKS INSIDE THE PLASTIC INSULATOR AROUND THE WIRE, SO IT IS NOT APPARENT ON VISUAL INSPECTION, REQUIRES THE USE OF AN OHM METER AND A VOLT METER.

Posted on Mar 30, 2009

Suraido
  • 195 Answers

SOURCE: renault laguna tailgate not opening all doors ok

Usually just one of the linking rods that got unhooked, or a doorlock motor that is now malfunctionning. You need to take apart the plastics and covers on the inside of the tailgate to have a clear view of the mechanism and pinpoint the rod that's not working, or pinpoint the motor for the doorlock to test it out. Be warned though, in some cases the tailgate needs to be opened to take the covers off. If you feel like they won't come off at all and don't see any screws left to take out, don't pry too much so you don't break it, and take it to the dealer to get them to open it up. It may cost a bit more, but at least if they break it while taking it off, they're gonna pay to replace it and they will also fix it.

Posted on Jul 07, 2009

  • 36 Answers

SOURCE: Toyota 4runner gate window, wiper, and keyless entry not working

make sure the back window is all the way up then try the wiper, if it still does not work then it is a sensor for the rear window (about $30.00) if you installed it yourself

Posted on Jul 21, 2009

c17hydro
  • 2984 Answers

SOURCE: my 2001 Town and Country's rear windshield wiper

Pretty straight forward.....here are the steps:

Please don't forget to rate--

Rear Window Wiper Motor Removal & Installation To Remove:

  1. Disconnect and isolate the negative battery cable.
  2. Remove the rear wiper arm.
  3. Open the liftgate.
  4. Perform the following to remove the liftgate trim panel.
    • If equipped, remove the lift motor link
    • Remove the upper frame molding
    • Remove assist handle screws
    • Disengage the hidden clips around perimeter of liftgate trim
    • Disconnect the electrical connectors.
  5. Disconnect the wire connector from the wiper motor.
  6. Remove the wiper motor mounting screws.
  7. Remove the wiper motor.
To Install:
  1. Position the wiper motor in the liftgate.
  2. Install the wiper motor mounting screws.
  3. Connect the wiring connector.
  4. Install the liftgate trim panel.
  5. Close the liftgate.

Posted on Jul 24, 2009

wyno62
  • 364 Answers

SOURCE: rear window wiper not working, also, AM radio stopped working

check fuses, when you turn on the rear wiper, can you hear it running, if so, sounds like the bolt has come loose or the teeth are sheared on the arm, remove the little plastic cover on the back and have a look. alternatively, if there is no sound, ensure the conection plug hasn't been unplugged accidently, I believe it is located behind one of the inside corner panels, there is another in the roof area, you will have to pull the rubber tubing/gromet out between the tailgate and the roof to check the connection. Good luck

Posted on Nov 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

02 liberty rear wiper dose not work plugin has power changed wiper motor still doses work


There is a nut under the black plastic bezel that needs to be removed. Here is the complete procedure for you to look at. Its possible that your arm isn't adjust at wiper motor...

REMOVAL
- Disconnect and isolate the battery negative cable.
- Remove the rear wiper arm from the rear wiper motor output shaft. (Refer to 8 - ELECTRICAL / REAR WIPERS / WASHERS/REAR WIPER ARM - REMOVAL).
- Using a small thin-bladed tool, gently pry at the notch in the base of the rear wiper motor output shaft bezel to unsnap the nut cover from the bezel (REAR WIPER MOTOR OUTPUT SHAFT NUT REMOVE/INSTALL). Be certain to take proper precautions to protect the outer tailgate panel and its paint finish from damage during this procedure.
- Remove the nut that secures the rear wiper motor output shaft to the outer swing gate panel (REAR WIPER MOTOR OUTPUT SHAFT NUT REMOVE/INSTALL).
- Remove the bezel and gasket from the rear wiper motor output shaft.
- Remove the trim panel from the tailgate inner panel. (Refer to 23 - BODY/SWING GATE/TRIM PANEL - REMOVAL).
- Disconnect the tailgate wire harness connector for the flip-up glass ajar switch from the flip-up glass latch connector receptacle.
- Disconnect the tailgate wire harness connector for the rear wiper motor from the motor connector receptacle (REAR WIPER MOTOR REMOVE/INSTALL).
- Loosen the two screws that secure the rear wiper motor mounting bracket to the top of the tailgate inner panel.
- Slide the rear wiper motor and mounting bracket forward far enough to disengage the two mounting screws from the keyed slots in the top of the tailgate inner panel.
- Remove the rear wiper motor and mounting bracket from the tailgate as a unit.

zjlimited_494.gif

1 - BEZEL AND GASKET
2 - OUTPUT SHAFT
3 - TAILGATE OUTER PANEL
4 - NUT
5 - NUT COVER

What you will need to do is to remove the small plastic cap on the wiper arm by prying it off with a screw driver. Then remove the nut that holds the arm onto the shaft. Then get yourself a battery cable puller (from auto parts store) and pull the arm off of the shaft..

zjlimited_495.gif

1 - SPARE TIRE
2 - WRENCH
3 - FLIP-UP GLASS
4 - PARK RAMP
5 - REAR WIPER ARM
6 - PIVOT COVER

Jul 19, 2011 | 2002 Jeep Liberty

1 Answer

HOW DO YOU REPLACE THE REAR WIPER MOTOR ON A 2003 JEEP LIBERTY?


REMOVAL
  1. Disconnect and isolate the battery negative cable.
  2. Remove the rear wiper arm from the rear wiper motor output shaft.
  3. Using a small thin-bladed tool, gently pry at the notch in the base of the rear wiper motor output shaft bezel to unsnap the nut cover from the bezel .Be certain to take proper precautions to protect the outer tailgate panel and its paint finish from damage during this procedure.
  4. Remove the nut that secures the rear wiper motor output shaft to the outer swing gate panel
  5. Remove the bezel and gasket from the rear wiper motor output shaft.
  6. Remove the trim panel from the tailgate inner panel.
  7. Disconnect the tailgate wire harness connector for the flip-up glass ajar switch from the flip-up glass latch connector receptacle.
  8. Disconnect the tailgate wire harness connector for the rear wiper motor from the motor connector receptacle
  9. Loosen the two screws that secure the rear wiper motor mounting bracket to the top of the tailgate inner panel.
  10. Slide the rear wiper motor and mounting bracket forward far enough to disengage the two mounting screws from the keyed slots in the top of the tailgate inner panel.
  11. Remove the rear wiper motor and mounting bracket from the tailgate as a unit.
To Install just reverse steps

Jan 23, 2011 | 2003 Jeep Liberty

1 Answer

The rear window wiper blade in stuck in an "up"


frozen motor. remove a rear door cover, and turn on rear wiper and listen for motor noise, also check fuse

Nov 05, 2010 | 1994 Mercury Villager

2 Answers

Which fuse is for the rear window wiper and rear window defogger on 2003 Toyota 4Runner (V6)?


You Have one fuse for the wipers in the car. Left side of steering wheel and the back cover should list the fuses and location. The other box is located in the engine compartment above the battery. They should list the fuse locations under the compartment covering the fuses. Hope that helps

Jun 14, 2010 | 2003 Toyota 4Runner

3 Answers

2004 4Runner Rear Wiper and Defroster won't work


I just had the same problem. I have an '04 4Runner and my rear wiper, fluid wash, and defrost stopped working after it was recently serviced. If you had the battery cables disconnected recently here is the solution...Start the engine and lower the rear tailgate window all the way... close the rear window and then turn the engine off. Restart the engine and the wiper,wash, and defrost. should work again. It has something to do with the computer which needs to be rebooted. Good luck.

Dec 19, 2009 | 2004 Toyota 4Runner

1 Answer

Rear window wiper not working, also, AM radio stopped working


check fuses, when you turn on the rear wiper, can you hear it running, if so, sounds like the bolt has come loose or the teeth are sheared on the arm, remove the little plastic cover on the back and have a look. alternatively, if there is no sound, ensure the conection plug hasn't been unplugged accidently, I believe it is located behind one of the inside corner panels, there is another in the roof area, you will have to pull the rubber tubing/gromet out between the tailgate and the roof to check the connection. Good luck

Nov 19, 2009 | 2005 Subaru Outback

2 Answers

I have a 1987 4runner and the rear window stopped working. It used to work intermittently if I pushed on the tailgate or moved the main wiring harness going into the rear of the tailgate. Now nothing,...


I hade the same problem first pull the cover for the tailgate off and check the wiring for damage like cracked or broken wires if none than ckeck at the area where the wires bend there might be some broken wires if so ose small **** connectors to fix.

Sep 10, 2009 | 1987 Toyota 4Runner

1 Answer

Toyota 4runner gate window, wiper, and keyless entry not working


make sure the back window is all the way up then try the wiper, if it still does not work then it is a sensor for the rear window (about $30.00) if you installed it yourself

Mar 31, 2009 | 2000 Toyota 4Runner

3 Answers

1986 Toyota 4 Runner - Tailgate window wont go down (electric)


hi phil, dont know if it will be of help but we had this problem ,try making sure rear wiper blade is in the proper resting place,i know it sounds to simple but it was our solution in the end after a machanic spent hours and hours on our 94 surf plus££££s, hope this is your answer, good luck. regards Reg

Mar 18, 2009 | 1986 Toyota 4Runner

1 Answer

Tailgate door and window won't open


Check in your user's manual for your fuse location on the rear windshield wiper. These grand cherokee's have electronic actuators in every door. Inside these actuators they have very little motors and move everything via plastic. Very bad design flaw, as most of these actuators are 300-400 dollars to replace. You can find ones in salvage yards for 50 though. On your rear hatch, the door and the window are run by this actuator.

Aug 25, 2008 | 2001 Jeep Grand Cherokee

Not finding what you are looking for?
2004 GMC Envoy Logo

Related Topics:

216 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...