Question about 2007 Volkswagen Rabbit

Open Question

2007 VW Rabbit headlight is out

How do you replace the bulb on a 2007 VW Rabbit for the headlight? I looked inside and the suspension clip that holds the bulb assembly in place has wires all around it.

Posted by on

5 Suggested Answers

SOURCE: REPLACING A HEADLIGHT BULB 1999 SAAB 9-3

http://www.ehow.com/video_2630_replace-car-headlight.html

that might help

or

1st remove the plastic cap that covers the back of the bulb

then just twist the rest off to the right..something like that..im gonna work on it tommorow

Posted on Sep 04, 2008

  • 10865 Answers

SOURCE: how 2 change head light bulb on a 2000 z24

To change the bulbs in the headlights,(on a 2002 Z24) you need to remove the plastic splash cover the extends the width of the car over the headlights by removing the plastics pins that hold it in . Pull up on the center of the pins to remove them. Once the cover is off, remove the two bolts that hold the headlight in, then place a screwdriver into the slot for the parking light lens to pop the clip loose that holds the lens in place. The headlight assembly can then be removed, once the wire harness is unplugged from the bulb. There is a round retainer that locks the bulb into place. Rotate the retainer counter clockwise and remove the bulb. Don't touch the bulb surface as oil from a person's hands can cause premature failure. Just reverse these dirctions to reinstall the rest of the parts. This may sound difficult, but it really isn't. I hope this helps out some fellow z owners.

Posted on Feb 17, 2009

Rebgagnon
  • 382 Answers

SOURCE: Need to replace a headlight assembly for a 2006 Subaru Outback.

No, you just remove the radiator grill and the side marker light and the headlight housing bolts and it comes out. Not a real hard job and is Real straight forward. Good luck and have a good day.

Posted on Mar 29, 2009

  • 1986 Answers

SOURCE: how do you completely remove the passenger side

Go here for pic by pic instructions

http://forums.vwvortex.com/zerothread?id=1251418

Posted on Oct 14, 2009

tecnovative
  • 360 Answers

SOURCE: License plate bulb replacement on a 2002 Buick

Hi, my name is John I will do my best to assist you.

The entire tail/backup lens assembly has to be removed from the trunk lid as shown in the drawing attached. There will most likely be some nut's or clip's on the assemblies mounting pins on the inside of the trunk lid.

  1. Disconnect the tail/back up lamp harness connector from the body wiring harness.
  2. Remove the tail/back up lamp assembly from the rear compartment lid.
  3. While supporting the tail/back up lamp assembly, unplug the tail/back up lamp harness grommet from the rear compartment lid and remove the tail/back up lamp from the vehicle.
  4. Remove the license plate lamp bulb from the lamp housing.
  5. Installation is the reverse of removal.

tecnovative_128.gif
If you have more specific questions please post comments to this thread and I will endeavor to monitor new activity and respond as soon as possible. I recommend that you "bookmark", or "add to favorites" this page for your convenience.

Posted on Feb 15, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I reinsert the pin that holds the high beam headlight in place on a 2009 VW Jetta


remove the wire terminal to the bulb first and roll the black cover back so that you can get to the spring clips holding the bulb in. lift the bulb out and then the black cover will pull of the end of the bulb

Dec 02, 2014 | 2009 Volkswagen Jetta

1 Answer

Daytime Running Lights on 07 Volkswagen Rabbit 2.5


I asked my VW friend. He said that bulb was only intended to keep the headlight area slightly lit up in the event the main light burnt out.
Some sort of safety feature.
He also said DRL's were not an option on his 2009 rabbit

Nov 06, 2013 | 2004 Volkswagen Passat

1 Answer

How do I access the rear tail light bulbs on a 2007 VW Rabbit


You have to pry open the carpet to exposed the assembly. Use a 10mm socket to removed the two nuts that hold the housing from the body. Once you get that done, you open the compartment and removed the bulb. Replaced and proceed the same way you removed it in reversed order.

Sep 03, 2010 | 2007 Volkswagen Rabbit

1 Answer

What are the steps to change the brke light on a 2007 VW rabbit?


pull away the carpet/fibre matting from inside the boot/trunk area to get to the lamp carrier,remove faulty lamp/replace.....

Apr 14, 2010 | 2007 Volkswagen Rabbit

1 Answer

Want to replace headlight bulb on my 2007 cts tell me how


Hi, lift the bonnet, remove the round plastic cap behind headlight, there will be a clip holding the bulb in place, remove clip, take out the old bulb and replace, good luck.

Feb 23, 2010 | 2004 Cadillac CTS

1 Answer

Replacing my headlight bulb in my kia amanit 2004


  1. Open the hood of your KIA Amanti and look behind the headlight that has gone out. Locate the round knob on the back of the headlight.
  2. Turn the knob counterclockwise 1/4 of a turn and gently remove it from the back of the headlight. Carefully remove the electrical cable within the headlight housing that is attached to the back of the headlight bulb.
  3. Locate the metal clip that holds the light bulb in place by pushing the clip arm straight in and sliding it down. Remove the bulb from the headlight housing.
  4. Replace the old headlight bulb with new bulb. Secure it by sliding the metal clip up to hold the bulb in place. Reattach the electrical cable and replace the round knob to the back of the headlight housing.
  5. Turn on the headlights to verify that they are in working order.

Nov 03, 2009 | 2004 Kia Amanti

2 Answers

Where is the air filter on 2008 vw rabbit?


the air filter is in the engine cover.. the engine cover is also the air filter box.. you have to pull the cover off.. then flip it over and there are 4 screws holding the airfilter.. losen those screws then take the air filter out, replace it and put the screws back on.. then gently put the cover back ontop of the engine. make sure you fit the four holes with the the four studs exactly.

Jul 06, 2009 | 2008 Volkswagen Rabbit

1 Answer

Driver side headlight bulbs burned out on 2003 VW Golf


There is a light cover in front of the battery... take this off and then look for the metal clamps holding the light housing in.  (I say clamps, but they're more like glorified paper clips on either side of the fixture.)  Press in on each side, pushing the clamps towards each other and pull the fixture out.

Nov 21, 2008 | 2003 Volkswagen Golf

Not finding what you are looking for?
2007 Volkswagen Rabbit Logo

Related Topics:

1,484 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

yadayada
yadayada

Level 3 Expert

70387 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6880 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...