The window fell down and I need to get it out to remount it on the actuator, but I can not get the inner panel off the door.
An A4 chassis is not adjustable per say. The only adjustement to the camber is to shift the subframe unit left or right to make the 2 sides more equal possible. By shifting the unit after slacking the 4 bolts holding it to the chassis one side will become more negative and the other more positive as the 2 move together. There is a little adjustement in the ball joints but usually will make more problems to the caster when touched. By shifted the unit forwards and back you'll play with the caster a little too but not recommended. If it's still not in specs after doing this by alot you might consider something is bent.
On the side of the door, in the door jam their is a plastic cover, behind that is a screw. You have to loosen the screw a few turns and remove the outer (smaller) door handle. DO NOT remove the screw all the way or the assembly will fall apart. With that removed you can now see the inside because you removed that small fake lock assembly. Then with a pick you have to remove the small cable out the other part of the larger door handle. That goes to the lock assembly.
Also I don't know if you unbolted the door latch assembly. Those two big screws in the door jam under the small screw with the plastic cover that you had to loosen to get the fake lock assembly to slide out.
Thnx.
105 views
Usually answered in minutes!
×