Question about 2000 Pontiac Grand Prix

1 Answer

Change front bulb

I know how to change headlight bulb but not sure how to get to it on a 98 grandprix gt

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 341 Answers

You get to it from the engine compartment. The is a retainer that you simply twist to remove the old lamp. The old lamp will be able to be pulled apart from the wiring socket. Reverse this to install. Type 9007 bulb. Cheapest at Walmart.

Posted on Dec 01, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replacing front headlight lens on 1985 Toyota Tercel


    How to change a Toyota Tercel headlight lamp - YouTube

    ? 4:06
    www.youtube.com/watch?v=B9dj0o5KIxc
    Apr 22, 2013 - Uploaded by NewEnglandgardening I replaced both headlight lamps on my 1996 Toyota Tercel. ...How To Install Replace Headlight and Bulb Toyota Corolla 98-02... Rear brake shoe replacement Toyota Tercel 1991-1998 Paseo Drum brakes Install Remove ...

Sep 27, 2015 | Toyota Cars & Trucks

1 Answer

2004 Pontiac Grand Am GT Headlight Bulb Changing


you have to remove the marker/signal light assemblies by prying them forward, careful of the paint, they are held on by clips

May 11, 2010 | 2004 Pontiac Grand Am

1 Answer

Need to change the headlight bulb, how do i get to


Hi, this is very easy on most gm's you simply find the wire heading the ligh you wish to replace unscrew the fastener make sure you go the right was and read the owners manual unplug the light and reverse the operation

Jan 17, 2010 | 1998 Chevrolet Malibu

2 Answers

Replace headlight


Instructions to change a headlight bulb on a chevy colorado or a GMC canyon : Make sure you have plenty of time , if you rush you will have problems so go slow and do it right the first time. > disconnect the parking light connections on the top of the parking lights . > carefully remove the grill by sliding the four plastic tabs on the top of grill while gently pulling , then just pull the grill off being carefull not to pull to hard . there are two snap connectors behind the parking lamps and three more along the bottom of the grill. > with a 10mm socket remove the two bolts that secure the headlights. slide the headlights forward . > this will give you enough room to change the bulb. I removed the connection first. I also put a clean sock on one hand to help handle the bulb without touching the new bulb. trust me on the sock, it helps. > line up the bulb prongs and rotate clockwise until you feel it snap. inspect the new bulb to insure it is properly installed and all three prongs on the bulb are now hidden. double check the bulb though the lens to made sure it is not cocked. >when reinstalling the headlight take a good look first to notice the two tabs on the bottom of the light . the tabs go in first then hold the light up and tight while you reinstall the two 10mm bolts. double check this to make sure both tabs are in . do not overtighten the bolts. check the lights . > use a flashlight to help align the grill push connectors snap in the bottom of the grill first then behind the parking lights then finally snap the four connectors along the top of the grill. > Thats it !!! take your time and you will have no problem. take care , Dave Dave's method might work but I just changed the low beam headlamp bulb on my 2006 Colorado in less than one minute with no tools needed. A simple 1/3 turn of the bulb socket from the back, (to the side of the radiator) and the bulb was out in my hand. Detailed directions came with the 9006 GE Bulb. Ron

Oct 29, 2009 | 2006 Chevrolet Colorado

2 Answers

How do I change the low beam bulb(drivers side) on 2005 Pontiac Grand Prix?


Upside down L shaped bracket that is bolted to frame just behind headlight assy. Unbolt bracket, lift bracket straight up to unlock headlight assy. Headlight assy should easlier fall forward to replace any of the 3 bulbs

Sep 26, 2009 | 2005 Pontiac Grand Prix

1 Answer

How to replace 1998 Ford Contour headlights (with diagram)


Step 1
Remove your Contour's front grille. You can do this by raising the hood and removing two screws that are located on top of the grille.

Step 2 Remove the headlight assembly. The headlight assembly is held into the front of your Contour by three screws. Two screws will be located on top of the assembly, and one on the bottom.

Step 3 Replace the headlight assembly, if necessary. If you are only changing individual bulbs, make sure you replace the correct bulbs. Each assembly holds three light bulbs, including the bright, dim and turn signal bulbs.

Step4 Replace the headlight assembly and reattach the three screws to hold it in place.

Step5 Replace the front grille of your Contour and the two screws that hold it onto the front of the car.


  • It is usually a good idea to replace bulbs together (in pairs). This will allow the bulbs to wear at the same rate.
  • If you choose to replace only the individual light bulbs, do not touch the new light bulbs. The contact of your skin on the bulbs will cause the light bulbs to burn out much sooner.

Let me know if you have any further questions.


Benjamin

Apr 26, 2009 | 1998 Ford Contour

1 Answer

1999 pontiac grand am headlight glass is foggy-how do I clean it?


You can use a product called goof off or a bug abd tar remover to get the area clean. To change your light bulb you can open your hood and between the radiator and the front end assembly see the back of the light socket. Turn it to the right and it should release. Make sure when you replace the new bulb not to touch the bulb in anyway with grease from your hand or dirt this will case the halogen bulb to burn out. So once you have replaced this just repeat the steps to reinstall.

Apr 18, 2009 | 1999 Pontiac Grand Am GT

1 Answer

Removal of headlight housing to replace lowbeam bulb.


found this online- haven't tried yet though--
How do you change a headlight bulb on a 2003 Toyota Celica GT? Under the plastic covering the headlight there is a lot of fog and condensation and I want to clean it off, so how do I take off the plastic that covers the headlight?
  • 9 months ago
Seem to be seal is wear off
already on the front cover
The way to open that
1. There is four screws at the back of
the headlights and unscrew them
2. Pull the headlight and dry it
by wiping or heat of the sun or
anything that can release the fog
3. Buy silicon and seal the headlight
gap with silicon and let it dry for a hour
This will help kept away fog
and condensation for sure

Aug 24, 2008 | 2003 Toyota Celica

Not finding what you are looking for?
2000 Pontiac Grand Prix Logo

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...