I have a 98 Plymouth Grand Voyager and want to check, perhaps rewire or replace the front speakers. Can I access them by lifting the top panel over the dash or the dash front? In either case, how do I do this?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The TCM transmission control module is on top of the front right wheel well, right in front of the powersteering reservour. You did not state what your problem was. There has been a some problems with wires and terminals opening up and losing contact. Take an ohm meter and check your connections before blaming the TCM. I have a problems with an open wire on my 98 grand voyager. I found the wire that is the problem but now can;t find a terminal so I can splice in a wire and put a terminal on it. I'm hitting the salvage yards tomorrow to try and get part or a whole harness to fix it.
1987-88 Plymouth Voyager Stereo Wiring
5 1/4" Dash
Left Front (+)
Left Front (-)
Right Front (+)
Right Front (-)
6" x 9" Tail Gate
Left Rear (+)
Left Rear (-)
Right Rear (+)
Right Rear (-)
If you are asking about lifting it out of the engine compartment like an older vehicle, like with an engine hoist, yes....this is the proper way to remove the engine from the Grand Voyager. If you are asking to remove the engine from underneathe.....like from under the frame, no.
You should have a few special tools ready. Fender to Fender Engine support. Transmission Jack A Lift would be real nice Once the Trany is out it will be easy to remove the pump. It's putting the new one back in that can cause you some real headaches.
Next to the battery & mount onto the upper frame at the front of the car an air filter housing with 2 self tapping bolts. Remove these and disconnect serveral hoses and lift back, Below this is the air filter housing itself. clips are on the side slip off, and replace filter.