Question about Ford Taurus

1 Answer

Will a 1990"s model ford taurus front end axel inter change with a ford taurus 1988. Oh that's driver and passenger side axels.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 491 Answers

It should as long as everything is the same. you could call your local parts store just to make sure and they will tell you

Posted on Nov 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Clicking in front passenger side of my 97 ford thunderbird lx


most likely it is you CV-Joint, it is a good idea to change out both sides. it is also cheeper to put a whole new axel in vs rebuid. does it do it worse while making sharp turns? thats the issue- if it gets too bad the axel can snap and the wheel can fall into the fireing wall leaving you stranded.

Nov 24, 2013 | 1997 Ford Thunderbird LX

1 Answer

Broken front passenger side axel


axel or tie rod end?? ` what make model and yr

Feb 12, 2013 | Cars & Trucks

1 Answer

I have a 97 AWD 5.0, I have a single clunck when i back up left or right. I had a leak in my rear pinion which I fixed and I checked the universals at the same time and they fell and look fine. I also...


Without knowing where the noise is coming from, you won't have much luck fixing it. If it happens when you are moving you may have to get someone to stand next to the truck and listen.

Sep 13, 2012 | 1997 Ford Explorer AWD

2 Answers

Poping,slipping noise,when you excerate fast.Sound come s from front driver side axle.


Most likely the cv joints, Its cheeper to change the axel out........If not that could be the wheel hub berrings,,,,,,,,,,,,,,,,,good luck

Feb 15, 2011 | 1998 Ford Taurus

1 Answer

Hello I am working on a 1990 toyota celica's passenger side axel. There appears to be a dampner in the middle. I do not see this anywhere on the replacement axels forsale. an idea's?


some of the older toys had a dampner or a balancer on them, most of the new ones are made of thicker metal and have no need rof a dampner

Sep 23, 2010 | 1990 Toyota Celica

2 Answers

Is the 1990 f150 4x4 have a solid front axel or what type of suspension


They usually will have a twin "i" beam with a solid front axel.

Jun 02, 2010 | 1990 Ford F150

1 Answer

Replace a font axel interseal


take your tire off, an your caliper an rotor, center bolt an what ever else hooks up to it, its a puzzle but take your time an you'll do it....

Jan 31, 2010 | 1990 Jeep Wrangler

1 Answer

Axel


the axel that goes in tramission at the end of the shaft there a snap ring try it of the snap ring hold the axel in the trasmission hit on the axel it will come out the trasmission maybe oil to will come out it normat the side that goes on the wheel side hit it with hammer put it back and recheck the trany oil level hope it FIXYA our post PLEASE DONT forget to rate this pierre

Jul 06, 2008 | 1991 Ford Taurus

1 Answer

LEAKING FRONT AXIL SEAL


take the wheel off , unbolt caliper and sling it out of the way with a bungi cord, take off the rotor, then you have too take the pumpkin cover off the axel diff in the front (drain fluid first) easy way to do that take out bottom and side bolts out then leave top 1 or 2 in but finger loose. pry cover off with a sturdy scrapper from side allowing fluid to leak out from bottom of cover. when fluid is done comeing out then take off cover. to take the axel out to replace the seal you have to push the axel inwards to remove the C- CLIP on the end of the axel shaft that slides into the inside of the pinion gear (use a extending magnet) keeps gear oil on your hands and from dropping it into the pumpkin housing. then all you have to do is slide the axel shaft out. then replace the seal .

Jul 01, 2008 | 1990 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...