- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Reset the Tire pressure monitoring system light. The reset button is located under the steering side under the finish panel. You have to bend down to see the button.
Operate the tire pressure warning system reset switch only after the inflation pressures of all 4 tires have been adjusted on the vehicle.
To initialize the system, press and hold the tire pressure warning system reset switch for 3 seconds or longer with the power switch turned IG-ON
Hi, the tire pressure monitor detects any changes in the tire inflation pressure.
Therefore, it must initialize and store it in its memory if the tires
or wheels have been replaced, re-inflated or the tires have been
rotated. You can re-initialize the system by following these steps:
1. Check and make sure that your tires are inflated to the correct pressure
2. Turn the ignition switch
to the ON position. If the low tire pressure warning light comes on,
push and hold the tire pressure warning reset switch (in the glove box)
until the warning light turns off and then release the switch.
3. Now press and hold the tire pressure warning reset switch until the low tire pressure warning light blinks three times.
4. Initialization is *not* completed until driving at the vehicle speed
of 19 mph or over for more than one hour. the tire pressure monitoring
starts when initialization is completed.
This (!) symbol is your
TIRE PRESSURE MONITORING SYSTEM (TPMS) warning light.
The manual has this to say about it:
This system monitors tire pressure. if the low tire pressure warning light
illuminates, check the tire pressure in all four tires.
Adjust the low tire pressure to the recommended cold tire pressure
shown on the Tire and Loading information label located in the driver's
door opening. After tire pressures are adjusted, the vehicle will need to
be driven at speeds above 16 MPH (25 km/h) to activate the TPMS and
turn off the low tire pressure warning light.
When you "fill" the tires they must be within 3 lbs of each other or the tire pressure warning light will come on. If the tires are "filled" correctly and the tire pressure light still comes on, you may have a tire pressure sensor that has gone bad. You would then have to take your car in to the dealer or tire shop to determine which tire sensor is bad.
This is your tire pressure monitoring system. Check the spare tire also. Some cars have a full size spare tire with a sensor in the tire as well. If all tires have the correct pressure then drive the car for a few minutes and see if the light goes out. if not then the vehicle will have to checked in a repair shop for further problems in the system.
there is a tire pressure sensor on each tire check the air pressure on each tire and recalibrate the system each time you put air in any of the 4 tires or if any of the tire gets low air.Its like teaching the system on the present tire air pressure.One thing more the valve on each tire are special valve that have electronic part inside so make sure you dont replace them with an ordinary tire valve.Recalibrating shld be done on workshops with the proper tool
check the tire pressures in ALL tires not just the 4 on the ground but the sapre also. If the pressures are all correct and the light is still on you may need to take it to a tire store such as good year or firestone or eve you local dealr to have the tpms SYSTEM checked out, (TPMS Tire Pressure Monitoring System)