Question about 2003 Mitsubishi Outlander

1 Answer

Mitsubishi Airtrek (outlander) Question _wiper blades

How do tighten the driver side WIndow Wiper.
Mine appears to have come loose.

Cheers
Steve

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 651 Answers

Try tapping lightly on the base of the wiper with a rubber hammer. do not break your winsheild.

Posted on Dec 01, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Only my driver side windshield wiper isnt working


at the base of the wiper arm theres a small cap to cover the point where the arm is mounted to the mechanism,remove the cap and tighten the nut ,you may have to loosen and tighten this nut a few times to adjust the arc of movement of the arm,ie,it may move too far across and foul the other wiper or too far down and foul the window lip,a bit of trial and error should see it working as good as new,
its nothing to do with fuses or electrics of any sort its just a loose nut on the wiper arm mount is all

Dec 17, 2014 | 1996 Ford Windstar

1 Answer

1996 crown vic- drivers side wiper arm loose, blade will not lay flat when cleaning


Sometimes you need to bend the arm to put more pressure on the glass.

Mar 29, 2014 | 1996 Ford Crown Victoria

1 Answer

My car window wiper is hitting off the side but it is the right size and isn't loose?


has been moved or the one fitted is bigger that the one it was originally set to. take the cap off the wiper arm and undo the nut. then wiggle the wiper blade arm until it comes off. then put back on and leave an inch gap from bottom off the window to the wiper. tighten the nut up and check that it works ok without going over any of the rubbers on the winds screen. if it does re do it and lift it a bit more up. then it should be fine after driving over 30mph then.

Jan 05, 2013 | Vauxhall Cars & Trucks

1 Answer

Drivers side windshield wiper not moving


The bolt that holds the wiper on is loose. There is a little plastic cap at the other end of the wiper arm, the side away from the wiper blade. Remove the cap and tighten the bolt. That should get it going again.

Jan 21, 2010 | 1992 Plymouth Sundance

1 Answer

Rear window wiper not working, loose and hanging down?


Nut came loose and now has stripped the cone shaped wiper blade driver. replace the cone and replace the wiper in the correct plase and tighten the nut down. If the wiper does not work make sure the wiper blade is not stripped as well.

Sep 28, 2009 | 2006 Kia Sportage

1 Answer

Driver side wiper blade just flops around and you can move it by hand. how do i tighten it?


At the bass of the wiper arm there is a cover that snap over the bass under that is a nut which has come loose .Align your wiper by hand were you want it then tighten up the nut:)

Aug 06, 2009 | Chevrolet Blazer Cars & Trucks

1 Answer

One front wiper not working on Outlander 2003


if you open the hood look towards the base of the windshield, you should see the linkages for the wiper arms. make sure the linkages are all in-tact and nothing fell off. if the linkages are all good, see if you can move the passenger side wiper with your hand, if it moves freely or with little resistance check the nut/bolt that hols it on at the end of the wiper arm. see if the nut/bolt is loose. tighten if needed. also you can remove the nut/bolt and check the splines on the wiper arm where it presses onto the stud and see if they are wiped out.

Feb 19, 2009 | 2003 Mitsubishi Outlander

2 Answers

2005 Chevy Equinox Wiper blade hits edge of window


The 23 should work on the drivers side but you will need a 19" on the passenger side.
Hope this helps and let me know.
Regards,

Feb 18, 2009 | 2005 Chevrolet Equinox

2 Answers

Driver side wiper arm moves only a little


take the cap off the end of the wiper arm and tighten the nut

Dec 18, 2008 | 2001 Dodge Caravan

Not finding what you are looking for?
2003 Mitsubishi Outlander Logo

Related Topics:

257 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...