SOURCE: 2000 Toyota Camry LE Cannot turn key in ignition to start car
It sounds like your ignition lock cylinder has a problem. These can be replaced and keyed to match you present key by a locksmith. Call a locksmith for a estimate.
SOURCE: Key will not turn ignition switch.
try sanding down the key alittle - saved me a fortune on my 96 civic
SOURCE: How to remove ignition cylinder from Toyota Camry 1993
Here are step-by-step instructions for the removal and re-installation of your ignition cylinder on your Toyota. Hope this sheds some light on the subject and solves your problem. Have a great day!
CAUTIONSome
models covered by this guidemay be equipped with a Supplemental
Restraint System (SRS), which uses an air bag. Whenever working near
any of the SRS components, such as the impact sensors, the air bag
module, steering column and instrument panel, disable the SRS, as
described in .
On some vehicles, it may be necessary to remove the steering wheel and combination switch first.
To install:
SOURCE: key will not turn in ignition after battery replacement
The battery is either bad or the starter brush has chopped down bad.
SOURCE: ignition lock cylinder removal without key
take the pannelling off around steering wheel inset a screw driver in key slot brekaway barrel to release steering lock pin then at other end of barrel take out scre and pull on wiring harness to expose a plastic barrel that will allow you to start car with a screw driver ect and you would not have steering lock as pin has been removed
373 views
Usually answered in minutes!
×