Question about 1996 Chevrolet Blazer

1 Answer

Wont shift out of reverse,but the shifter moves up and down freel

I went to back up,put it in reverse,then pulled down to drive but indecater stayed ir reverse.no matter where the shifter is the truck wont start.

Posted by on

  • Anonymous Mar 17, 2014

    ITHANK SENSOR

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

Your linkage on the transmission must be off. try having someone move the shifter while you watch the linkage arms under the car on the trans to make sure its all intact. it could be a loose or broken bolt on the trans causing it to not disengage from reverse this will cause it to not start.

Posted on Dec 14, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Car wont start and rolls backwards even though it apears to be in park


Sounds like the shifter is stuck in reverse or drive since it will roll.
I would set the parking brake and have someone watch the shift lever on the transmission to see if it and the shifter inside is still connected.

Feb 20, 2014 | 2006 GMC Envoy Denali

1 Answer

I was backing up and when I went to shift from reverse to drive it wouldn't shift or go into any gear and after putting into park it wouldn't move at all


My personal experience is that your gear shifter has an electric actuator, allowing it to move through the gears. However, if the the voltage is NOT supplied, your gear shifter won't move...My Mercury had a fuse that wouldn't indicate it was broken until power was applied, then the shifter wouldn't move. This is a difficult circuit to find.

Feb 18, 2014 | Cars & Trucks

2 Answers

Gear shifter is in Park, but dash reads it's in Reverse. Car won't turn over because it is in Reverse now.


You have to locate where the park ignition switch is located. Some are on the transmission and some are in the column under the dash. It probably got moved.

Nov 24, 2013 | 2008 Dodge Caliber

2 Answers

How do you adjust the shift cable on a 1995 gmc jimmy, wont go into reverse or park.


On the 1995 Jimmy, the shift cable can come loose on the mount on the side of the transmission where the cable meets the trans. When it slips, the alignment goes off and causes the driver to not be able to put the trans into park. If you take a long stick you can push the shift arm on the trans to the park position and your trans will go into park.....what you (and I) really need to know is how to take the shift cable mount apart and reset it.

Aug 05, 2012 | GMC Jimmy Cars & Trucks

1 Answer

20001 vw jetta tdi automatic transmission problem


Ok , so you got home , parked it and when you started it up the next day and shifted it into reverse... backed out... and went to shift into drive , it stayed in reverse ?
Have you checked to see that the cable has not disjoined itself from the shifter to the trans.?
Are you able to engage Park?

Nov 10, 2011 | 2001 Volkswagen Jetta TDI

1 Answer

Car wont shift into gear. Gear shift moves but gears don't


It sounds like the lever from the gear shifter has come loose. I would first look at the shifter from under the car. You can also remove the boot (or console) from inside the car and check the linlage. Most linkage is held on by a small clip or cotter pin and somethime they don't stay in place anad the linkage slides off the arm..

Jan 14, 2010 | 1998 Honda Accord

1 Answer

My 01 pt cruiser wont go into reverse


Shift linkage bushings under the air filter box are probably gone.
http://www.boogerracing.com/boogerbushings.html

Sep 29, 2009 | 2002 Chrysler PT Cruiser

2 Answers

Nissan maxima wont shift into park


There is a little button in front of the shifter. I pushed on this while moving the shifter back and forth. It immediately went down and I was able to put he car in park and then pulled out the key.

Jul 04, 2009 | 1993 Nissan Maxima

2 Answers

Won't shift into gear.


99 passat wont shift into reverse from park...locked up

Jun 06, 2009 | 2003 Volkswagen Passat

2 Answers

1988 suzuki samurai WONT MOVE


First thing just try to push or pull the 4x4 lever if you get it to move and it feels like it went into some gear try to drive the truck.If this works look on the shifter for the 4x4 and put it in 2 wheel drive (H2 is two wheel drive,H4 is 4x4 high,and L4 is 4x4 low range).Make sure you have the clutch depresed when you try to move the 4x4 lever.If you try this stuff with no fix try and look for clutch adjustment on the transmision you may need to adjust it or your clutch is bad.

Aug 30, 2008 | 1988 Suzuki Samurai

Not finding what you are looking for?
1996 Chevrolet Blazer Logo

Related Topics:

290 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...