Question about 1993 Chevrolet S-10 Blazer

1 Answer

1991 chevy s10 pickup won't shift into park

When coming to a stio in the vehicle and shifting into park i have to shift back and forth between drive and park before it finally clicks and i know its in park...itls like it wont stick in the park gear...and when it finally does i have to mash down on the brake pedal really hard...just started doing this...however this is my 2nd 91 s10 and this is the 2nd time that this has happened

Posted by on

  • 1 more comment 
  • Anonymous Dec 11, 2008

    what are the linkages/cables and where are they...and how to lubricate them?

  • Anonymous Mar 25, 2014

    can the brake booster be adjusted

  • Anonymous Mar 25, 2014

    will not shift from park when you mash the brake pedal



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Chevrolet Master
  • 6,674 Answers

Has anyone tried lubricating & or adjusting linkages/cable?

Posted on Dec 11, 2008

  • JeffMohr May 25, 2011

    The brake lockout module is probably bad. It is located on the transmission where the linkage cable is attached to the shaft.



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My chevy s10 want shift out of park what can I do to fix it?

There is a switch on the brake pedal that you must fix. This allows you to shift out of park only after the brake is applied.
Assuming since it goes in Park that its an automatic otherwise if its a shifter on the floor there is an actuator under the rubber around the shifter which if you lift it up yiou will find that you can manually move the piece which allows you to move the shifter.

Mar 28, 2015 | 1996 Chevrolet S-10 Pickup

1 Answer

My chevy s10 4wd truck want shift out of park what can I do to fix it?

I would have someone observe the shift linkage on the trans as you shift it.

Mar 28, 2015 | Chevrolet S 10 Cars & Trucks

1 Answer

96 chevy s10 stuck in park

Sounds like a bent linkage or needs adjustmentent.
I think there is a rod that goes from the shifter to the transmission and this will have a set-screw which allows you to set the travel distance. Sounds liike it's bent or moved. If i'ts a cable then the cable is frayed [probably near the shift stick.

Apr 21, 2014 | 1996 Chevrolet S-10 Pickup

3 Answers

When I want to pass from park to drive, it is stuck to park. Motor is running normally. please help...

If the vehicle will not shift out of park, a brake light switch or shift lock solenoid is most likely the problem.

Aug 16, 2010 | Kia Sephia Cars & Trucks

3 Answers

My 2000 chevy s10 pickup doesn't want to shift

Check your master and slave, If your slave is not fully depressing the pressure plate it would be very hard to shift.

Low fluid would not cause this. However there is a bolt on the side of the trans that you remove and put your finger in to check the level. If you put your pinky in and no fluid comes out it is low.

The slave often goes on the chevy's. It is internal, you have to pull the trans to replace it.

Also a pressure plate that is collapsing can cause the same problem. You are pushing all the way down, but it is not releasing.
Hope this helps.

Nov 03, 2009 | 2000 Chevrolet S-10

1 Answer

98 Chevy K1500 is hard to shift out of park

loose selector rod or its worn & binding up
Check and adjust

Jul 20, 2009 | 1999 Chevrolet S-10 Pickup

1 Answer

1995 Chevy S10 Blazer will not go into park.

theres a shift cable if its floor model,linkage for column model.

Apr 25, 2009 | 1995 Chevrolet Blazer

4 Answers

1998 Chevy S10 pickup backup lights don't work

Yes it screws in on right side of tramission and you will need a 7/8 inch deep socket to remove it. You may be able to clean the old one once it is removed. There is a little ball thatgets dirty and may you can get by with cleaning it. Good Luck. Ed

Sep 06, 2008 | 1991 Chevrolet S-10 Blazer

Not finding what you are looking for?
1993 Chevrolet S-10 Blazer Logo

871 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides