Question about 2001 Oldsmobile Alero

2 Answers

We just changed the oil in my 2004 olds Alero. We don't remember how to reset the change oil dash light, can you help??

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

If it is the same as the 2001 Alero, open the fuse panel on driver side. Turn key in the ignition to ON.
Hold Tire/Oil reset button in until beeping and the light turns off. Then it is all set...

Should be the same for the 2004...

Hope this helps.

Posted on Dec 23, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 55 Answers

Try disconnecting the battery

Posted on Nov 30, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: resetting oil change dash light

Turn ignition key to the on position (with engine off). Depress accelerator pedal 3 times. Oil change light should blink and you should here a beep, light will go out. Turn ignition key off.

Posted on Dec 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do i reset the oil change light in a 2003 olds alero


turn key on (dont start engine) floor gas pedal 3 times 1,2,3. turn key off, now start engine it should go off, if not try it again.

Aug 03, 2011 | 2003 Oldsmobile Alero

Tip

Reset oil change light on 2004 Oldsmobile Alero or Bravada w/o (DIC) Driver...


I see alot of people cant figure out how to reset there oil change light on a 2004 Oldsmobile Alero/ Bravade w/o (DIC) driver information center. To do this follow the steps below.
Turn the ignition to ON, with the engine off. Fully depress and release the accelerator pedal slowly three times within five seconds. The reset is complete when you hear the chimes and the “CHANGE OIL” light goes out. If the light stays on and no chime is heard, you will need to repeat the reset procedure. Turn the key to OFF. If the “CHANGE ENGINE OIL” message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.
and its as easy as that and now you can change your oil on your own and not need a dealership to reset it for you.

on Aug 31, 2010 | Oldsmobile Alero Cars & Trucks

1 Answer

I want to reset the change oil light on 2004 olds alero


You need an OBII scanner to reset service lights. You can buy one from about $60 and up... OR you can go to an Autozone, Advance or any good auto parts store and they'll do it FREE

Feb 26, 2011 | 2004 Oldsmobile Alero

1 Answer

2000 olds alero oil change and check air pressure light is on , i changed the oil and cheched air pressure . tried to reset but light stayes on


Open the driver door on the car and locate the fuse panel on the SIDE of the dash. Remove panel and there will be a red reset button. Turn key to the ON position and press and release button. Press and hold button again, and you will hear a series of beeps signaling that it has been reset

Nov 09, 2010 | 2001 Oldsmobile Alero

1 Answer

How to reset change oil light


read below on how to do that


Oldsmobile Alero 2004
Turn the ignition to ON, with the engine off. Fully depress and release the accelerator pedal slowly three times within five seconds. The reset is complete when you hear the chimes and the “CHANGE OIL” light goes out. If the light stays on and no chime is heard, you will need to repeat the reset procedure. Turn the key to OFF. If the “CHANGE ENGINE OIL” message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.

if you need further information please feel free to let me know and i will be glad to assist you further. If this solution helped you then please feel free to rate the solution. Thanks, Midwest-tek

Aug 31, 2010 | 2004 Oldsmobile Alero

1 Answer

Reset oil light in 2004 alero


Oil lights can not be reset,but the oil change light can,,Turn the key to on,and push the accelerator 3 times slow ,with in 5 seconds,this will turn the oil change light off.If this was helpful,please rate thank you.

Jul 21, 2010 | 2004 Oldsmobile Alero

1 Answer

How to reset dash lights on oldsmbile alero after changing oil


turn the key to the "on" position and press the reset button in the fuse panel just inside the drivers door once the change oil light starts blinking press and hold the reset button until you hear a chirp sound and the light goes out.

May 01, 2010 | 2000 Oldsmobile Alero

1 Answer

Just had oil change and now the change oil light on the dash is on, what can I do?


Interesting how Olds system is reset-
Turn igntion on, but car engine is OFF, not running, Fully press and release gas pedal slowly 3x in 5 seconds. If you succeed, you will hear a chime and the light will go out. If it doesn't chime, repeat procedure to reset light.

Apr 20, 2010 | 2004 Oldsmobile Alero

1 Answer

Resetting oil change dash light


Turn ignition key to the on position (with engine off). Depress accelerator pedal 3 times. Oil change light should blink and you should here a beep, light will go out. Turn ignition key off.

Nov 30, 2008 | 2004 Oldsmobile Alero

Not finding what you are looking for?
2001 Oldsmobile Alero Logo

362 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...