Question about 1991 Pontiac Grand Am

Open Question

How to remove back seat in 91 Grand Am

How do I remove the entire back seat in a 91 Grand Am. I need the space for subwoofers. :)

Posted by on

  • pajoshhunter Dec 01, 2008

    No I do not.

  • Antonio Boscia
    Antonio Boscia May 11, 2010

    do you have fold down rear seats?

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove front seat 91 honda accord


look 4 body bolts ,possible (torx head) you should only have to loosen them unless you have a great need to remove seat ,seat belt will also have to be removed at floor and a good chance there will be electrical connections to on board computer -bcm or air bag srs .

Oct 02, 2012 | 1991 Honda Accord

1 Answer

There is a broken hinge to raise and lower the back rest on my driver side seat . How does that get repaired? Does the entire seat have to be removed from the car? Or is there another way to make the...


you will have to remove the seat and the cover to access the hinge, it may just be welded. If it cant be fixed, maybe find one in a salvage yard, If its not the right color, the covers will need to be changed.

Sep 09, 2011 | 1999 Plymouth Grand Voyager

1 Answer

How to remove fuel pump from a 91, grand prix se 2dr,...Is it in the trunk


most probably an in tank fuel pump, check under the back seat, there should be a blanking cover, remove it and hopefully u will see the fuel pump.

Jul 13, 2010 | Pontiac Grand Prix Cars & Trucks

1 Answer

I have a ticking noise coming from what I believe to be the crankshaft angle sensor. It goes in where the distributor use to go on the right side of the engine block. Is there anything special about...


No special rules or tools to replace. If you get a used part you will need to get a spacing shim that sticks to the end to correctly space it to the flexplate. Otherwise a new one should just unbolt and go right back together.

May 19, 2010 | 2002 Jeep Grand Cherokee

1 Answer

Wear is the batary on VW touareg 2 5 tdi


are you really ready for this..
if (typeof InitForm != "undefined") InitForm('lookup1','autodiv1','down');
Under the drivers seat. OK, let's add to this...

It's a tad more complicated. There are two plastic covers at the front of the seat on the floor. You need to lift both of them up. That exposes a fastener that will require a 10mm "triple square" male tool. This is similar to the familiar Torx (6 point star) fastener except it has 12 points instead of 6 points. This tool is available at many auto supply places, without it, you will NOT replace the battery. Remove both screws (they're TIGHT!!!), remove the plastic trim pieces from the rear of the seat slide assembly (carefully snap off) Tilt the seat back all the way forward, slide the seat forward almost all the way but leave space to miss the steering wheel. Now push back on the seat back and the entire seat will tilt to the rear exposing the battery box under the drivers seat. There are four clips that hold the cover on, unhook them, remove the torx screw holding the heater deflector to the battery box lid, remove the wire tie holding the wire to the top of the box and remove the box cover. Now you see the battery. Remove the gas vent plastic pipe from the front, remove the metal cover at the front left corner (10mm socket) it will not come out until you remove the (-) cable but don't just yet. remove the side clamp (10mm socket) and the battery is loose and free. It would be smart (but not required) to provide a 12 volt electrical source to the battery terminals as you replace the battery to help keep all of the radio GPS etc, settings. Remove the terminals, lift out the battery.

Sep 16, 2009 | Volkswagen Touareg Cars & Trucks

2 Answers

Looking for the jack on my 1993 grand wagoneer


You will find two release loops on the sides of seat Part closest to back rest comes up, back rest also folds down to give more rear floorspace.

Aug 01, 2009 | 1988 Jeep Grand Wagoneer

1 Answer

How to remove front bucket seats from 91 GTI


you will need a metric rachet and wrench to remove 4 bolts from the bottom of of the seat. the bolts is bolting down the rail which the seat is riding on. to get to the front bolt you need to slide the seat all the way back and to get the rear bolts, slide the seat all the way forward.
I hope that help a bit

Jul 10, 2009 | 1991 Volkswagen GTI

1 Answer

2005 Jeep Grand Cherokee rear seat removal


For the seat bottom, you just need to pull it up. The seat backs would have to be unbolted.

Mar 05, 2009 | 2005 Jeep Grand Cherokee

1 Answer

Cant put back seat back in grand voyager


Here's what you need. Put the seat in the back, about where it was before you removed it. behind the seat by the floor you have a latch handle on the left and right side behind the seat close to the floor. click the release buttond on the handles, and push them to the down position, hinging them to the floor. Good, now the seat should roll on the track that is attatched to the floor. line the seat up to the holes on the track and lift the latch handles back up. that should do it
Good Luck!

Dec 14, 2008 | 2000 Chrysler Grand Voyager

Not finding what you are looking for?
1991 Pontiac Grand Am Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...