Question about 2000 GMC New Sierra 1500

1 Answer

Gm new sierra 1500 4x4 chugging when light acceleration

Usually when rpm at 1000 to 1500 and in high gear and may be going up a slight grade just before the tranny shifts down

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Egr valve

Posted on Dec 09, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have an 03 Jeep Grand Cherokee v6 2x2 with 170k... I'm having a couple of issues... 1. Occasionally will have trouble with cycling through gears when getting on Hwy causing decreased, sluggish...


I would consider changing the vehicle speed sensor. When they go bad, they can really throw out a lot of bad data to the computer, resulting in unexpected behavior like you're experiencing. They're only around $20-$25. I hope this helps! :)

May 02, 2014 | Cars & Trucks

1 Answer

High rpm when warming - choke problem?


It is a little high but if the ambient temperature is very low it would be ok providing you understand that there will be a bit less economy. You can fine tune the choke to drop another notch on the accelerator cam so that it would idle at say 1500rpm and the gear engagement would be less harsh

Dec 23, 2013 | Cars & Trucks

1 Answer

Car chugging when accelerating


GM swears the plugs will last 100k miles, yet I have had to replace them as early as 30k miles.(That was on my wife's 05 Pontiac montana.) A word of advice: Don't get the fancy aftermarket double or triple platinum plugs. I had to replace those again 5k miles later. Went back to ac delco platinums and they're still working after 50k more miles.

Oct 05, 2012 | Chevrolet Aveo Cars & Trucks

1 Answer

The throttle is running at a high rpm about 1000 and throttle cable has some slack in it usually idles at about 700 rpm can it be adjusted or do i need a new cable its a 1998 gmc sierra 1500 5.7 litre


The throttle cable is probably ok. I would be more likely to suspect the idle air control valve/solenoid to be causing your trouble. Sometimes trouble with the EGR valve not closing all the way will cause this problem as well.

Feb 25, 2010 | 1998 GMC Sierra

2 Answers

Acceleration


Your clutch is goin g out on it.

Jun 29, 2009 | 1996 Volkswagen Jetta

1 Answer

Vibration on the floor underneath gas pedal


I would venture to say your exhaust is hitting your frame, or, you may need new motor mounts. The exhaust is what I would lean toward. If you can imagine your exhaust sitting under your vehicle, and the fact that the vehicle has a little age, the motor mounts probably give a little, causing the motor to move slightly on acceleration and deceleration, thus your exhaust is going to move, and may be vibrating on whatever its touching. Good luck.

Feb 25, 2009 | 2003 Volvo S60

1 Answer

2001 buick regal gs 3.8L


Sounds like a plugged catylic convertor. You might check with a GM dealer to make sure if it falls in the Special Policy coverage to get it replaced under warrenty, it has to have less than 120,000 miles on it though.

Oct 22, 2008 | 2001 Buick Regal

1 Answer

Sounds like a burst of Air when changing gears???? and Wurrrrrrr when accelerating???


first thing you need to do rule out vacuum to shifting module make sure there is no leaks you usually can detect by a hissing sound or high pitch whistle check your shifting module on your transmission providing transmission screen and filter has been maintained as for the second part gm powersteering pumps have a tendency to whir if a new belt has been installed until it breaks in

Jul 21, 2008 | 1999 GMC Sierra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

262 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

64286 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...