Question about Chevrolet Silverado 1500

1 Answer

Vent Acuator on 1994 Chevy Silverado

I have a clicking noise right before and just after I turn off my engine in my 1994 Chevy Silverado. From what I was able to find out it is my vent actuator. I have never replaced one of these before. Can anyone give me some directions and let me know how difficult it is. Thanks.

Posted by on

  • yadayada
    yadayada May 11, 2010

    When you say vent actuator do you mean the blend door motor?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I had the same problem and changed it myself. It was a job but can be done yourself. Some call it a Recirculation door actuator, some call it a blend air door actuator. If you look under the dash behind the glove box all the to the fire wall you can see it.There is 2 screws 1-top 1- bottom which you can see easily, the top one you cant see from bottom you have to take out the glove box to see. There is a plug that goes to the actuator, you can actually just unplug it to stop the noise, that will fix the noise and I know some people dont replace the actuator they just leave it like that. I had to go buy a air socket wrench to replace, the smallest one I can find. I wouldnt have done the job without it. Good luck hope this helps. Steve

Posted on Dec 16, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is mode acuator on 03 yukon


should be one above the gas pedal to the right side panel,and 2 others to the opposite side of counsel.I went through this on my 99' silverado.Have a garage mechanic do it as they need to be syncrinized. Jeff

Jun 20, 2017 | GMC Yukon Cars & Trucks

2 Answers

I have a 1994 Chevy Silverado and every time I turn on the ignition, the knocking noise begins from under the dash somewhere. If I remove the fuse to the a/c/heater it doesn't make a sound when I


Try starting the truck so it makes the noise.
Then switch the air control to "fresh".
If noise stops, it is probably the motor that closes flap to recycle the cab air.
It would be found under the dash, under the glove box, & would need to be replaced.

Sep 20, 2012 | Cars & Trucks

1 Answer

I have a 2004 chevy silverado and the heater will not switch off vent to deforst or anyother poistion. How do I fix it?


the blend door acuator is bad dealer can print this off for t=you so you can see where it is located

Jan 16, 2011 | 1999 Chevrolet Silverado 1500

1 Answer

Tapping noise near computer 1994 Chevy 1500 Silverado


air recir actuator motor shorted you can reach between blower motor and heater case and unplug a pain to replace

Oct 29, 2009 | 2004 Chevrolet Silverado 1500 Crew Cab

1 Answer

2000 CHEVY SILVERADO STUCK IN 4WHEEL DRIVE


Hi; If this vehicle has electronic vacuum or pushbutton four wheel drive, the vacuum acuator switch is probably defective.

Jun 16, 2009 | 2000 Chevrolet Silverado 2500

1 Answer

Clunk noise


Tranny, drive shaft, rear end,

Apr 25, 2009 | 1994 Chevrolet Silverado 2500

1 Answer

1994 chevy silverado wont TURN OFF


test the alternator thi keeps the truck running

Apr 09, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

1994 Chevy Silvrado Starter Problem


It’s your solenoid that is getting hot and the engagement washer inside is what is sticking. There is some heat shield material you can get from the auto parts store to shield you solenoid.

Jun 23, 2008 | 2000 Chevrolet Silverado

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

2,148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74418 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22082 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7254 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...