I also have a 2005 pt cruiser and used to have the same problem. Turned out my spare tire was hanging too low to the ground. I just raised it up higher and the problem stopped. (:
SOURCE: 2001 pt cruiser hear a thump noise
there is a pivot point for your rear sway bar called the watts linkage that wears out the center bushing and will cause a rattle or clunk
SOURCE: where is the crank sensor located on 2005 chrysler pt cruiser?
the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or hot?
SOURCE: PT Cruiser 2005, engine light on.
Your vehicle’s computer system has self-testing capability. When the computer senses that there is a problem with one of the components or sensors it stores the correspondent trouble code(s) in its memory and lights up the "Check Engine" or "Service Engine Soon" light to tell you that there is a problem and you need to diagnosed and repaired it. The list of possible codes number in the hundreds. The code itself doesn't tell exactly what component is defective - it only indicates where to look, or what engine parameter is out of normal range. You or a technician will have to perform further testing to pinpoint cause and the proper repair. Even if you reset the light, if the underlying problem is not addressed it will come back on.
SOURCE: 2005 Pt Cruiser idles rough at stop lights/ poor gas mileage.
i hav a 2003 pt cruiser 2.2 crd touring it wont go over 3000 revs engine light cums on. error code p0243 i hav replaced wastegate solenoids cleaned egr valve cud it be the mass air flow sensor that has a problem thanx
141 views
Usually answered in minutes!
×