Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Jun 07, 2012

Camshaft sensor 2008 chevrolet colorado 2.9 litre engine

Where is the location in the engine compartment?

5 Related Answers

Anonymous

  • 37 Answers
  • Posted on Mar 19, 2009

SOURCE: locate camshaft sensor 2002 chevy trailblazer

Assuming you have a 4.2L engine here is the location.
b3031ef.gif

Hope this helps out,
if so please rate my answers.
Brett

Ad

AzVip

  • 114 Answers
  • Posted on Mar 22, 2009

SOURCE: Camshaft sensor location

The cam sensor on the 4.7 is located toward the forward edge of the right cylinder head (passenger side). This has a 3 wire connector, tan/with yellow tracer is sensor signal, black / light blue tracer wire is sensor ground and the orange is the 5V supply.

Anonymous

  • 2 Answers
  • Posted on May 05, 2009

SOURCE: 1996 Jaguar XJ6: Diagnostic (Check Engine) Camshaft Sensor A

If your car is a 4.0L there are no camshaft sensor. Only crankshaft sensor and timing sensor. Dont know your problem but if your car is not running it is very common that the crankshaft sensor is faulty. It is fairly easy replaced and located just above the crankshaft wheel atthe front of the engine. It is mounted with one 8mm boult.

Anonymous

  • 85 Answers
  • Posted on Dec 31, 2009

SOURCE: Where is the camshaft position sensor on a 2000 Ford Explorer?

in the rear like where the dist would normaly be

Anonymous

  • 335 Answers
  • Posted on Oct 04, 2010

SOURCE: where is the coolant temperature

Hello and welcome. here is a picture of the coolant sensor. the coolant sensor is mounted just below the thermostat housing in the intake manifold.





2eb9d84.gif

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Location on 2008 f450 camshaft position sensor

https://www.youtube.com/watch?v=0sUb5CbI6ok

The Camshaft Position (CMP) Sensor is mounted on the cylinder head, front, beneath timing belt cover. The Camshaft Position (CMP) Sensor is located in the right side of the engine compartment at the rear of the valve cover, near the intake manifold. https://www.autozone.com/repairguides/Audi-Cars-1999-05/Component-Locations/Camshaft-Position-CMP-Sensor/_/P-0900c152801c0f2d



0helpful
1answer

Locate camshaft sensor 2008 3.6l malibu

Which one ?
Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake
0helpful
1answer

Location of cam and crank sensors on a 2010 colorado 4 cyl.

camshaft sensor should be next to camshaft magnet on front of engine. (LH9) crank sensor on right side of engine
0helpful
1answer

2004 Chevrolet Colorado 2wd 3.5l engine p0017 check engine light. Changed all sensors related crankshaft sensor, camshaft sensors, solenoid sensor with the screens, light is still on with the same...

Did you have all the codes removed from your trucks computer..you must have them removed via your testing port and do a new test...garage mechanic can do this for you or if you have a OBD2 " on board diagnostic " tester you can follow the instructions on the device...good luck..
1helpful
1answer

Location of camshaft position sensor on 2009 saturn aura

2.4L cmp sensor exhaust located upper rear of the engine near camshaft cover. 2.4L cmp sensor intake located upper front of the engine near the camshaft cover. the 3.5L cmp sensor located right side of engine compartment above the timing chain cover.below power steering pump.3.6L cmp sensor located right side of the engine near the front and rear.
1helpful
1answer

Where is the camshaft position sensor located

As your standing in fron of the car. the exhaust cam sensor will be on the passenger side right below the valve cover kind of tucked in were the water pipe and the power steering pump are. The intake cam sensor is on the drivers side of the front of the engine just below the valve cover and kind of right behind where the serp belt comes across that area.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

1helpful
1answer

2006 Cobalt 2.2 litre has check engine light come on, then "engine disabled"

That code dsoesn't 100% mean the sensor is defective, other factors can set it. See list below.
Possible causes- Camshaft Position Sensor harness is open or shorted
- Camshaft Position Sensor circuit poor electrical connection
- Faulty Camshaft Position Sensor
- Faulty starter motor
- Starting system circuit
- Dead (Weak) battery
P0601 CHEVROLET - Power Control Module Internal Fault

Cause: Faulty PCM. (Powertrain control module)
0helpful
1answer

Where is bank2 for cam shaft sensor?

Bank 2 is the opposite bank from the engine bank that contains number 1 cylinder.
Not finding what you are looking for?

1,065 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...