Question about 2000 Chrysler Grand Voyager

Open Question

Unable to find starter on 2000 chrysler grand voyager

I have had problems with intermittent starting for the past 2 weeks. Took to autozone and they said the battery was bad. replaced battery and having the same problem. It was suggested to check the connections at the starter, however after looking at the positive terminal and trying to follow to the wiring It gets lost. Where exactly should I be looking to find the starter? Sometimes it will start like normal and other times I just hear one click sound and after repeating it will fire up.

Posted by on

6 Suggested Answers

  • 44 Answers

SOURCE: Fuel filter on Chrysler Grand Voyager Diesel 2007

It is next to the starter.

Posted on May 29, 2008


brandyspoile
  • 61 Answers

SOURCE: heating doesnt work - no hot air in chrysler grand voyager

(check water/ antifreeze level first, make sure it's full, low water can cause it not to heat properly) it could possibly be either the thermostat- fairly cheap and easy to fix, great for DIY's- if that doesn't fix it, it could be heater core.

Posted on Dec 06, 2008

MrScary66613
  • 1990 Answers

SOURCE: serpentine belt chrysler grand voyager 3.3l 1997

http://www.mvreader.com/multiview/dayco/catalogSearch.php?autoCatalogSearch=1&make=CHRYSLER&model=TOWN%20%26% The Town and Country has the Exact same Motor, Here is the Link to the 3.3 Liter Belt Diagram. It is the First at the Top, Just read the Header. Please Rate My Response! Thanks!4ZYEV3

Posted on Feb 06, 2009

MNfisherman
  • 11896 Answers

SOURCE: WHAT IS THE DIFFERENS OF CHRYSLER GRAND VOYAGER

THERE ARE A COUPLE DIFFERENCES. IT'S ALL IN THE OPTIONS PACKAGE. GRANDS ARE JUST SLIGHTLY LONGER, THEY HAVE DIFFERENT MOTOR SIZES AND DIFFERENT OPTIONS PACKAGE.

Posted on Mar 31, 2009

  • 22 Answers

SOURCE: 2002 Chrysler Town & Country starting intermittent

I assume you've checked all connections from the battery and starter to make sure they are clean and tight. It is a little weird that you do not have trouble starting in neutral yet you get a clicking sound in park. My first thought would be the neutral safety switch on the transmission but you shouldn't even get a click in park if that is bad.

One possibility is the contacts in your starter have worn down and are causing too more resistance (explains the clicking). At the back of your starter is a metal cover that is held on by three tiny bolts (6mm). Disconnect the battery first! (You might have to remove the starter to get to this part) Remove this cover and pull out the plunger assembly. Underneath are two brass plates. Compare one plate to the other. If one is noticeably thinner then it could be the cause of the clicking. You will even see a round groove in the plate. You can buy the plunger and contacts from this website: http://www.nationsautoelectric.com/densoparts.html or you can opt to get a starter from your friendly auto parts store. The first picture shows the bad contact on the left. Notice the groove, the metal has become really thin there. 1e874da.jpgThis picture shows a pitted plunger assembly. Always good to replace it too.cd09a24.jpgThis picture shows all the new parts installed.207ff4f.jpg

Posted on Aug 20, 2009

  • 534 Answers

SOURCE: 1998 Chrysler Concorde 3.2L

Thoroughly check the battery to chassis to engine ground system is properly connected and in good order.
Check/replace any solenoid control relay if fitted -(slave relay interfacing between ignition start sw and starter motor engage solenoid).
Check condition and connections of any fusible link (or in line Maxifuse).

Posted on Oct 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chrysler grand voyager 2.8crd, failure to start after stopping, engine turns over , release key and try agin, sometime will start


Best guess would be the wiring in the ignition switch. From what you describe the problem is intermittent. A loose or broken wire or contact in the switch might explain this.

You will need to go to a shop to have this properly diagnosed and repaired as it may require removal of the steering wheel and air bag to get to the switch since it is on the steering column.

Other solution might include check for current at various engine components while key is on.

I hope this gives you some direction.

j

Aug 19, 2014 | 2000 Chrysler Grand Voyager

1 Answer

2000 grand voyager starter location


Hello! Here is a diagram of the starter location for your vehicle...Guru...Saailer





saailer_139.gif

Oct 20, 2011 | 2000 Chrysler Grand Voyager

1 Answer

I have a 2000 Chrysler Grand Voyager with 120,000 miles. This morning the engine would not turn over as I turned the key. There was just a 'click' sound, that's it. Radio is working fine, lights are on and...


It sounds like your starter is stuck. This is a simple thing to resolve. Take a piece of wood, or the blunt end of a hammer and gently tap on the starter, this should free it up. You should then be able to start it. If this does not resolve the issue, then you may have a faulty, or corroded wire to the starter, or a faulty starter and will need to have it replaced.

Apr 19, 2011 | 2000 Chrysler Grand Voyager

1 Answer

What side should I jack up to change a 2000 grand voyager starter 3.3 liter


The starter is buried on the back side of the motor. I would recommend borrowing some ramps and lifting the whole front end. If you can only raise one side the right side might give you better access to the solenoid connections and starter bolts.

Sep 09, 2010 | 2000 Chrysler Grand Voyager

1 Answer

Cant find a 2000 voyager starter


If you are standing in front looking at the engine, its level with your knees, 2 feet in front of you. If you cant find the starter, why are you looking for it?

Mar 11, 2010 | 2000 Chrysler Grand Voyager

1 Answer

2000 Chrysler Grand Voyager shut off and will not start back


sounds like the fuelpump might of gone bad the frist thing i would do is to have the fuel preasure checked.start there

Jan 17, 2010 | 2000 Chrysler Grand Voyager

1 Answer

Hi I have problem with Chrysler Voyager 2001 3.3l Automatic.The car would turn over from the key,I have checked the ign switch-sends a signal to the starter relay.The PNDR switch is operating,the wiring...


pin 86 and pin 30 at the relay should have power then your right about ground supplied from the ecu and the other goes to the starter solenoid check for battery voltage on those 2 pins 86 and 30 one fuse is under the hood and the other is under the dash.

Sep 29, 2009 | 2000 Chrysler Grand Voyager

1 Answer

I have a 2000 Grand Voyager my steering wheel center is not work


The problem you have is a bad clockspring . There's a recall from Chrysler that you can check @ this link http://www.chrysler.com/en/owners/ .
On the right side of the page you can see a link " recalls " , just enter the last 8 #s of the vin and check if the recall still open . If you never did this recall just take it to your local dealer to have them replace the clockspring on your mini van FREE of charge . Hope this help.

Jul 09, 2009 | 2000 Chrysler Grand Voyager

3 Answers

Chrysler voyager 2000 blocked by ''alarm set''


i have a chrysler grand voyager 2.5 2001 and the alarm goes of when driving or when parked can you help

Feb 10, 2009 | 2000 Chrysler Grand Voyager

Not finding what you are looking for?
2000 Chrysler Grand Voyager Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...