Have a service engine light on a anniversary edition lincoln....code is po412
Not a big deal to have MIL light on. P0412 is secondary air injection valve switching A circuit.
Try this first. Disconnect battery for 1/2 hour. then reconnect and drive car for 10 miles so computer can relearn engine controls. may run rough during this time. See if that turns light off.
SOURCE: 1997 lincoln Continental serpentine belt change
you need to find which pulley is the belt tensioner. use a socket and a breaker bar to lift the tensioner. once the belt loosen, slide the belt off one of the pulleys close to you. then slowly release the tensioner.
SOURCE: replace rear brake light bulb 1998 lincoln continental
pop the trunk and right behind where the lights are pull the carpet
down and their will be of the following depending on the trim.
You will either see the light sockets themselves that you can twist and pull to change the bulb, or you will see the plastic nuts/screws that you can remove to remove the entire assembly in order to access the bulbs.
If it's your 3rd brake light, the screws to access the housing are located in the upper part of the trunk
SOURCE: Diagram for 1998 lincoln continental
There should be a diagram of the route printed on the fan shroud or somewhere else under the hood of the vehicle.
SOURCE: 1998 lincoln continental security light on wont
Theft detection activated. that is the trouble code. Somebody tried to steal your car. Or the code was activated. Call dealer and try to get security code unlock information.VIN may be needed.
SOURCE: 1997 lincoln continental check steering assist light
Is the fluid full enough? there should be a dipstick to tell where the level should be. Also is the belt tight enough? Wires loose?
457 views
Usually answered in minutes!
×