According to my haynes manual for Landrover 200tdi, G - S reg,1989-1998 it goes as follows,
Stage 1:- Tighten all bolts to 30lb ft or 40Nm then
Stage 2:- Angle tighten a further 60 degrees then
Stage 3:- Angle tighten a further 60 degrees again.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
For the 12 Pointed Head Bearing Cap Sub-Assembly Bolts Start from center bolts and tighten in a clockwise rotation working out Step 1 all bolts 22 Nm or 16 ft lb Step 2 all bolts 44 Nm or 32 ft lb Step 3 all bolts 45 degrees additional clockwise rotation using an angle indicator. Step 4 all bolts 45 degrees additional clockwise rotation using an angle indicator.
Hexagon Head Bearing Cap Sub-Assembly Bolts 1ZZ-FE Engine 18.5 Nm (14 ft.lb) 2ZZ-GE Engine 18 Nm (13 ft.lb)
Connecting rod: 1. Apply a light coat of engine oil on the threads and under the heads of theconnecting rod cap bolts. 2. Install and alternately tighten the 2 connecting rod cap bolts in several passes. Torque: 1ZZ-FE: 20 Nm (204 kgf-cm, 15 ft. lbs.) 2ZZ-GE: 30 Nm (306 kgf-cm, 22 ft. lbs.) If any of the connecting rod cap bolts does not meet the torque specification, replace the connecting rod cap bolts. 3. Retighten the cap bolts by 90 more 4. Check that the crankshaft turns smoothly.
hi.im a mechanic from the philippines.the torque of all your cylinder head for your nissan sentra 1997 is 60 nm.apply 30 nm of torque first on all the cylinderhead bolts then torque it agian directly to 60 nm. i also drive and repair nissan cars.