Question about 2007 Volkswagen Touareg V10 TDI

1 Answer

Lights don't come on when i open the vehicle doors

When i open the vehicle doors the light do not come automatic.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 651 Answers

First, check your fuses. second, check the buttons that turns the lights on and off at the door frame, push them in and they should pop right back out. if not, spray a little wd40 on them and push them a couple of times to free them.

Posted on Nov 29, 2008

  • dan Nov 29, 2008

    also check the light bulbs, you might have to replace them.good luck

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Automatic door lock 1999 toyota prerunner


hi jerome
I have the procedure for Toyota auto lock, is worth to try it
AUTOMATIC LOCK SETTING
1) Step in the vehicle and make sure that all doors are closed completely
2) Insert the key into the ignition key cylinder.
3) Wait for more than 5 seconds.
4) After turning the key to the ACC position, turn the key from the ACC to the
ON position 5 times within 10 seconds (Last position : ON).
? Status Monitor LED will illuminate for 30 seconds.
Note : In case you implement 6 times or more by mistake,
action steps 6)-8) you made will be canceled.
Please retry from step 2).
5) While the LED is illuminated :
• Open and close the driver's door 2 times.
• Turn the key to the ACC position.
? LED will continue illuminating.
? Indicator lights will flash 2 times.
Ignition controlled door lock ON :
6) While the LED is illuminated:
• Open and close the driver's door 1 time.
• Turn the key ACC-ON-ACC 1 time (Last position : ACC).
? Indicator lights will flash 1 time.
? LED will extinguish.
Ignition controlled door lock OFF :
6) While the LED is illuminated :
• Open and close the driver's door 2 times.
• Turn the key ACC-ON-ACC 1 time (Last position : ACC).
? Indicator lights will flash 2 times.
? LED will extinguish.

Jan 28, 2014 | Toyota Camry Cars & Trucks

Tip

How to set & cancel theft deterrent system or how to set & cancel security...


Theft deterrent system (on some models)

Theft deterrent system is designed to deter vehicle theft. The system flashes the turn signal lights and turns on the interior light or the signal lights only (depending on the model), and sounds security horn and vehicle horn when it detects abnormalities such as follows:

• Any door or hood is forcibly opened.
• The batter terminal is disconnected and then reconnected
• The system control is disconnected and then reconnected.
• Abnormal impact is detected when the impact sensor function is on.

The system flashes the turn signal lights and turns the interior light or the signal lights only (depending on the model), and sounds security horn and vehicle horn if someone attempts to damage or break into your car.

Setting the system

You can set the system with or without the impact sensor function. For details, see "Canceling the impact sensor" below.

1. Turn the ignition key to "LOCK" and remove it.
2. Have all passengers get out of the vehicle
3. Push the lock (set) switch on the wireless remote control key once. At this time, the turn signal lights flashes once and the security indicator light comes on.

The system is set after 30 seconds. At this time, the security indicator light start flashing slowly.

Once the system is set, you cannot start the engine until you cancel the system.

The system will not be set in the following cases.

• When any of the door is open; security horn sounds for 1 second, close the door and set the system again.
• When the hood is open; close the hood securely.

Canceling the Impact Sensor

The impact sensor can be cancelled to prevent false alarms from being triggered incase of the following conditions:

• When parked in the noisy area
• The vehicle body or glass is subjected to a strong impact from the (such as in highly pressurized car wash).
• When transporting by a car carrier or ferry.

To cancel the impact sensor;

1. Lock the door by pushing the lock (set) switch on the wireless remote control key once, and turn signal light flash once
2. Then push the lock (set) switch twice within 5 seconds. At this time, the turn signal flash 5 times to indicate the impact sensor function is disable.

The impact sensor is deactivated as long as the system remained armed.

Canceling the system

The system will be cancelled by the following two ways:

• Turn the ignition key from "LOCK" to "ON" position.
• Unlock any of the doors by pushing the unlock (cancel) switch

If the turn signal lights flash 3 times, the system has been alarmed. Check to see if there is any abnormality with your vehicle.

If any of the doors is not opened within 30 seconds, all doors will be automatically locked and the system will be set.

When the system is set

Activating the system; When the system detects abnormalities such as follows, it flashes the turn signal lights and turns on the interior light or the turn lights only (depending on the model) and sounds the security horn and vehicle horn of 30 seconds.

• Unlocking any door without using wireless control
• Any door or hood is forcibly opened.
• The battery terminal is disconnected and then reconnected.
• The system control assembly is disconnected and then reconnected
• Abnormal impact is detected when the impact sensor function is on.

Reactivating the alarm;

Once set, the system automatically resets the alarm after the alarm stops.

The alarm will activate again under the same circumstances described in "Activating the system".

Stopping the Alarm

The alarm will be stopped by the following two ways;

• Turn the ignition key from the "LOCK" to "ON" position.
• Unlock any of the doors by pushing the unlock (cancel) switch.

The system can be cancelled by these ways at the same time.

If the battery becomes discharged due to the vehicle being unused, for a long time etc., when the battery is recharged or replaced, the system will activate the alarm. If this happens, immediately unlock any of the doors by pushing the unlock (cancel) switch, and the alarm will stop.

Testing the system

1. Set the system
2. Insert a wireless remote control key into the key hole on the driver's door handle, and unlock the door.
3. Open the door, and an alarm will sound.
4. Stop the alarm by pushing the unlock (cancel) switch.
5. Repeat this operation for the front passenger's door.

Good luck.

on Nov 08, 2010 | Toyota Pickup Cars & Trucks

1 Answer

1996 jeep grand cherokee no automatic interior lights


1. If you have the light switch in the wrong mode the lights will not operate when you open the door.

2. If the interior lights do not operate at all (ie you cannot switch them on and off manually)then you need to check the fuse for the interior lights.

3. When set to the correct mode, the interior lights will operate from a door operated switch so if the switch has failed the lights will either stay on or not operate at all when you open and close the door. Eventually these door switches fail with repeated use and need to be replaced. (Consider how many times the small door switch has been operated since 1996).

Dec 25, 2012 | 1996 Jeep Grand Cherokee

1 Answer

How to turn off automatic lights when door is open in a 1994 cadillac deville?


remove the fuse for the interior lights, or disconnect the switch( at the door jamb)

Mar 13, 2012 | 1994 Cadillac DeVille

1 Answer

I have a 94 Cadillac Sedan DeVille and I'm trying to locate a switch or sensor for auto-lights and door locks. The doors would lock and the lights would come on when i put the car in drive. Can somebody...


On some model cars this normal I own a Dodge truck that does the same thing .When I open my doors the interior lights come on then when I start moving my doors lock.On some vehicles the doors will lock and the daytime running lights come on automatically.Some vehicles also have an automatic setting on the light switch.Like I stated on some cars this is normal.

Feb 10, 2011 | 1994 Cadillac DeVille

1 Answer

How do you get the interior lights to come on when a door is open


Hi, viewer. The interior light is powered and controlled by the body control module or BCM. However, there is an on/off button beside the main headlight switch that overrides the interior lighting function. If this button is off, interior lights will not come on regardless of any door being closed or opened.

If this button is on, interior lights will come on whenever a door is opened. If you close all doors, and if the driver door is the last to be closed, the interior lights will stay on for about 30 sec and then the lights goes off automatically. In case you left any door opened too long, the BCM has an internal timer that will shut off the interior lights automatically when it detects that a door is still opened and the allowable time has elapsed. The BCM is programmed this way to protect the battery circuit and functions. : )


Sep 13, 2010 | 2008 GMC Acadia

1 Answer

Interior lights won't go off on 1999 surburban and automatic door locks don't work. Just purchased vehicle, all issues seem to be electrical in nature.


Sounds like a door switch is stuck open. My suggestion would be to pull all of the door switches and use a scrap piece of wire to "fool" the connection closed. Simply unplug the switch, and jumper across the terminals on the connector. If the lights go out, now go back and install each switch one at a time untill you find the one that's stuck open. Replace that one. $50.00 it's the driver's front.

Dec 09, 2009 | 1999 Chevrolet Suburban

1 Answer

If the head light doors don"t open the lights don"t come on how do I get the doors open


the lights should come on whether or not the doors are open,they are powered by the headlight switch at the same time the switch powers the lights

Dec 02, 2009 | 1991 Chrysler New Yorker

1 Answer

Dome light


dear friend-you have two interior lights in your vehicle,one in front operating the little spot lights and one in the centre of the car,at the back of this panel there is two buttons,the one is for on and the other for the doors,plse note that the door lites has a delay period,remove the key from the ignition to test.

Jul 19, 2009 | 2007 Hyundai Tucson Limited

1 Answer

2003 Honda Pilot lighting problem


the driver's door has a switch which tells the multiplexer control unit that the door is open and the control unit then switches on the lights. It sounds like the switch is not making contact when the driver's door is open. The lights work and the other door switches work--so it isn't a fuse or multiplexer problem.

Feb 22, 2009 | 2003 Honda Pilot

Not finding what you are looking for?
2007 Volkswagen Touareg V10 TDI Logo

Related Topics:

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

60960 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...