Question about 1988 Ford Thunderbird

1 Answer

Find eec location to exchange - 1988 Ford Thunderbird

Posted by on

  • warlock61
    warlock61 May 11, 2010

    are you looking to replace the processor?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Hello, located under glove box, behind right kick panel at edge where door hinge is.

Posted on Dec 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the eec relay located


Should be located in the engine compartment relay panel just aft of the airfilter box.there are 2 fuel pump relays one is the eec relay

Mar 09, 2016 | Cars & Trucks

1 Answer

Where is the ECU located on a 1992 ford explorer and what does it do?


What your Explorer has is actually called the EEC-IV. It is sort of like an ECU. The EEC stands for "Electronic Engine Controls". Your EEC-IV Does this:
  • Powertrain Control Module (PCM)
  • Throttle Position (TP) sensor
  • Mass Air Flow (MAF) sensor
  • Intake Air Temperature (IAT) sensor
  • Idle Air Control (IAC) valve
  • Engine Coolant Temperature (ECT) sensor
  • Heated Oxygen Sensor (HO2S)
  • Camshaft Position (CMP) sensor
  • Knock Sensor (KS)
  • Vehicle Speed Sensor (VSS)
  • Crankshaft Position (CKP) sensor

The EEC microcomputer circuit processes the input signals and produces output control signals to the fuel injectors to regulate fuel discharged to the injectors. It also adjusts ignition spark timing to provide the best balance between driveability and economy, and controls the IAC valve to maintain the proper idle speed.
The EEC is located in the engine compartment. Post your engine size and I can tell you where it's at.

Jul 22, 2013 | Cars & Trucks

1 Answer

Fuel pump relay location in a 1999 lincoln town car


It should be in a Powerbox under the hood along with the EEC relay and EEC diode. The plastic cover should be marked.

Mar 31, 2013 | 1999 Lincoln Town Car

1 Answer

How look like eec power relay 93 ford f150


Should be under the hood on the driver side. Little black plastic rail holds 3 relays. - eec, fuel pump, and a/c

Dec 29, 2012 | 1993 Ford F150 SuperCab

1 Answer

Where is the EEC relay in a 1992 F-250 with a 7.5 liter


I suggest to check underhood engine bay, according with this wiring diagram, look under EEC (Electronic Engine Control 1992) or PCM (Powertrain Contro Module 1996-1996)...

7_6_2012_11_20_57_pm.jpg

Fig. 22: Engine wiring - 1992-95 F-Series 7.5L (VIN G), 1996 F-Series 7.5L Federal (VIN G) and 1996 F-Series Pick-up 5.8L (VIN H over 8500 GVW) engines - ZOOM LINK DIAGRAM HERE (top left)


ALso, I suggest to check wiring circuit C185, located in THIS LINK DIAGRAM (top right)

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Jul 06, 2012 | Ford Cars & Trucks

1 Answer

Where is the pcm/ecm fuse located on a 1990 E-350?


EEC POWER RELAY LOCATED ON THE RIGHT FENDER APRON NEAR THE BATTERY. EEC IS ANOTHER NAME FOR ELECTRONIC ENGINE CONTROL WHICH IS THE ECM OR PCM

Nov 21, 2011 | Cars & Trucks

1 Answer

1996 FORD EXPLORER , MISS FIRE ON CYL # 2, 1ST REPLACED PLUGS AND WIRES, THEN THE COIL PACK AND LAST THE FUEL INJECTOR BUT PROBLEM STILL THERE, ANY HELP WOULD BE GREAT


OK,
Have you tried the following:


Ignition Control Module (ICM) REMOVAL & INSTALLATION NOTE: Only the EEC-IV ignition systems use an external ICM. EEC-V systems have incorperated the ICM into the Power Control Module (PCM).
  1. Disconnect the negative battery cable.
  2. Detach the wiring harness connector(s) from the ICM.
  3. Remove the mounting bolts, then remove the ICM. To install:
  4. Position the ICM onto the inner fender apron and install the mounting bolts. Tighten the bolts to 22–31 inch lbs (2.5–3.5 Nm).
  5. Attach the wiring harness connector(s) to the ICM.
  6. Connect the negative battery cable. Fig. 1: Ignition control module and mounting location on the 2.3L, 2.5L engine 89682g32.gif
    Fig. 2: Ignition control module used on all EEC-IV systems except the 2.3L engine 89682g33.gif
    Fig. 3: Ignition control module mounting on all EEC-IV systems except the 2.3L engine 89682g34.gif
prev.gif next.gif

Jul 11, 2010 | 1996 Ford Explorer

2 Answers

Where is the fuel pump relay located on 1998 mark8 lincoln


there is no per se fuel relay. it has a ccrm. constant control relay module, its located near the air cleaner box. I presume this is for a no start condition.

Oct 10, 2009 | 1998 Lincoln Mark VIII

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...