Question about 2006 Ford Econoline Cutaway

1 Answer

Location of crank sensor for a ford 2003 van e 150


Posted by on

  • warlock61
    warlock61 May 11, 2010

    which engine size?



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 66 Answers

Right hand front bottom of engine if it's a gas engine

Posted on Jan 04, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2003 ford e150 stalled out crank no start let rest for 10 min restarted ok

Could be crankshaft sensor,take too long to show a code.

Jun 15, 2016 | 2003 Ford E150

1 Answer

1993 ford van E 150 will crank over but not start. has compreseion and fuel and spark and timing is on. What else could be issue

Pull a plug wire, stick a screw driver in the plug wire socket and hold the metal shaft of the screw driver about 1/8 inch from the block. Get someone to turn the ignition key to start and while it is cranking see if you get a spark. If not, look under the front of the truck and locate the "crank trigger" located on the front of the block and going to the area of the crank ballancer. If it looks dirty, the get some contact cleaner and squirt it good and use a tooth brush to clean the trigger and surrounding area of the ballancer where the trigger makes contact, then try starting again.

Dec 15, 2014 | Ford Cars & Trucks

1 Answer

2003 Ford Windstar: Ambient Air Temperature Sensor Location

There is currently no recall on the 2003 Ford Windstar which cites a transmission problem. The 2003 Ford WIndstar was recalled on May 3, 2012 because of a defect in the suspension and front control arm.--------------------------------------------------------------------------------------------
Multi-cardiag M8 CDP

Jan 10, 2013 | Cars & Trucks

1 Answer

Where's the location for O2 sensor bank 1, sensor 1 on a v-8 1997 E-150 ford van

Bank 1 is the side that has cylinder #1... Sensor 1 refers to the sensor that is BEFORE the catylitic convertor. On your vehicle it is the PASSENGER side.

Aug 08, 2011 | 1997 Ford Econoline

1 Answer

Where is an "02 sensor heater circuit bank 1

the O2 bank 1 sensor 2 its located on the passenger side after the catalyst converter, you will see two sensors in this side of the exhaust its the second sensor

Feb 10, 2011 | Ford E-150 Cars & Trucks

1 Answer

Looking for torg specs on tire lug nuts on a 15passenger van f350

Hello there
Wheel Nut Torque Specifications
Make/Model Description Years Torque Make/Model Description Years Torque
FORD (continued)
E250 Van 8 Lug, 9/16" 2008-88 140 -160 ft lbs
E350 Van 8 Lug, 9/16" 2008-88 140 -160 ft lbs
Escape - 2003-01 98
Excursion - 2003-01 160
Excursion - 2000 148
Expedition - 2003-01 150
Expedition 19mm Hex 2000 100
Expedition 21mm Hex 2000 150
Expedition - 1999-97 100
F Super Duty Pickup 10 Lug, 9/16" 2003-99 165
F Super Duty Pickup 10 Lug, 9/16" 1998-96 140
F150 Pickup - 2003-01 150
F150 Pickup 19mm Hex 2000 100
F150 Pickup 21mm Hex 2000 150
F150 Pickup - 1999-88 100
F250, F350 Pickup 8 Lug, 9/16" 2003-01 160
F250, F350 Pickup 8 Lug, 9/16" 2000-99 148
F250, F350 Pickup 8 Lug, 9/16" 1998-88 140
Ranger, Windstar - 2003-87 100

Feb 01, 2011 | 2008 Ford F-350

1 Answer

Replacing a crank sensor

I highly recommend you to buy the manual book of your van, thats the best thing you do. The book may cost $20.00 or more now.

Nov 04, 2009 | 2003 Dodge Caravan

1 Answer

Second time this month it won't start....cranks and cranks but wont start...10 mins later i try again and starts right up 2002 e-150 ford van 4.6.....47,500 m

have another person help with this.Tapping one at a time on the black relays (located in the power distribution box in the engine compartment while you are cranking the engine. BE CAREFUL of moving engine componets !!!

Oct 01, 2009 | 2003 Ford E150

1 Answer

Want to change my O2 sensor .where is it located?

it is located in the engine pipe just down from the exhaust manifold which is bolted to the cylinder head cheers MAL

Mar 18, 2009 | 2003 Ford E150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

748 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

77514 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

5627 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides