Question about 1996 Ford F150 Regular Cab

1 Answer

Need to find a web page on how to to change the pick up coil

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 651 Answers

Go to put in vehicle information and click on repair info. follow steps. good luck

Posted on Nov 28, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do i change the pick up coil on my 89 chevy 1500

The pick up coil is in the distributor cap. Mark and remove the plug wires, remove the cap, remove the pick up coil. Fining order for 5.0/5.7 is 18436572. Counter clockwise.

Feb 12, 2015 | Cars & Trucks

1 Answer

Car starts when cold but not warm

I have had this problem in the past. It is a weak coil or pick up coil. When it is cold it will start and run just fine but when it warms up it will sputter and not run good at all. You will need to change the coil or pick up coil in ya distributor and it will run fine.

Dec 10, 2012 | Cars & Trucks

2 Answers

Changed coil in 1997 c1500. New coil wouldn't fire and now old coil won't fire. What could be the problem?

Check for 12v at red wire, if ok then replace ign pick up module ( usually green and yellow wires under rotor). or pick up coil. hope this helps !!

Mar 11, 2011 | 1997 Chevrolet K1500

1 Answer

I just changed fuel pump on this car . I drove it for twenty mile now it want start it will try but it want remain running . I changed fuel pump relay It didnt appear to help . Do you think it could be in...

That is a very good possibility and I would certainly suspect it to be the problem. Also, remove the distributor cap and look at the connector to the ignition module from the pick-up coil/stator and it should be white like it is shown in the image here of the pick-up coil/stator, and if it is dark in color or burnt looking then also replace the pick-up coil/stator or the distributor.

Pick-up Coil/Stator


Jun 12, 2010 | 1991 Mercury Topaz 4 Door

2 Answers

No spark

There's no emergence switch, if there was it would only be for fuel and not spark, there four thing to get spark,
ignition control module, ignition coil, distributor pick up assembly and spark plug wire's check for spark at coil, more then likely it's going to be your distributor pick up assembly, the pick up sit in side your ignition distributor, replace it and it will start, hope this was very helpful.

May 19, 2010 | 1985 Ford F 250

1 Answer

Engine turns over but no spark at the plugs. checked coil ok changed ignition moudle no luck changed rotor no luck. checked voltage from coil to cap getting 12vdc. checked voltage going to and coming out...

You can change pick-up coil, you need to remove distributor (mark where rotor is pointing first) Then you need to remove pin in cam gear on end of shaft to remove gear so you can remove shaft from housing. Then you can replace pick-up coil. Install in reverse. Note when removing distributor rotor will move to the right as you lift distributor out, move rotor to right of mark you made when installing distributor back in.

Feb 22, 2010 | 1990 Chevrolet C1500

1 Answer

How to change a pick up coil on a 1989 chevy 1500 350 5.7L

Have u changed out ur Ignition module ? Needle nose pliers to take off retainer clip.Detach negative battery terminal,remove Dist cap nd rotor. Detach pick up coil leads from module.

Oct 02, 2009 | 1989 Chevrolet C1500

1 Answer

I want to see a layout diagram of fuse block

Go to this web site: Pick owner guide on the left task bar then input your vehicle info and pick get owner guide,then pick owner guide 1st printing and your fuse info begins on page 137

Jun 15, 2009 | 1997 Ford F150 Regular Cab

2 Answers

2003 F 350 6.0 Diesel, Need a fuse charg that goes with the fuse box under my stering wheel

Go to this web site: Pick owner guide on the left task bar. Input your vehicle info then pick get owner guide. Pick owner guide 5th printing and your fuse info begins on page 176

Jun 14, 2009 | 2003 Ford F250 Super Duty Crew Cab

1 Answer

How do I change the air filter on my 2006 Ford F250 diesel truck?

You did not mention what engine you have but if you look in your owners manual starting on page 284 it shows you how to change it for either engine 5.4L gas or 6.0L diesel.

If you do not have an owners manual go to the web site below and pick owner guide from the left task bar,input your vehicle information then pick get owner guide then pick owner guide 2nd printing.

Apr 10, 2009 | 2006 Ford F-250 Super Duty

Not finding what you are looking for?
1996 Ford F150 Regular Cab Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides