Question about 1991 Nissan Pickup

1 Answer

1990 Nissan P/u with AT - no Reverse and shifts hard 1 to 2

Hi. I have 1990 Nissan Pickup V6 SE with AT. The truck has 160 000 miles on it. It won't shift into reverse. The shifter moves in to all positions and shifting cable works. It also does not want to shift from 1 to 2. It shifts when you accelerate and then I lift the gas pedal like you would shift manual transmission. Someone told me that this may be the servos on the throttle body but i cant find them on the truck or on the pictures or illustrations in the book. I have the Haynes repair manual but it says that this is too complicated for regular people to understand. I understand that the AT is shifted electrically so the servo might be responsible for shifting from 1 to 2 but is the reverse shifted mechanically.

Posted by on

  • 2 more comments 
  • rlkingo578 Nov 29, 2008

    Yes I'm willing to tear down the transmission. Do I have to take the transmission off the truck or can I just access it from the oil pan opening. I took the oil pan off last night. In the past I have repaired few manual transmissions but never automatic. If you can help me it would be great. Thanks

  • rlkingo578 Dec 01, 2008

    Ok. I understand that but do I have to take the transmission off the truck or can it be done just from oil pan opening. I could hopefully figure it out by my self how to repair it. It's just were to start. Thanks.

  • Jackson Hisey
    Jackson Hisey May 11, 2010

    The amount of instruction that I would have to supply would exceed the limits of this website and my typing.

  • Jackson Hisey
    Jackson Hisey May 11, 2010

    Are you willing to tear down the transmission yourself?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Nissan Expert
  • 99 Answers

If you are going to just replace the valve body then there is no need to remove the transmission. All other repairs will require removal of the transmission from the vehicle.

Posted on Dec 01, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 Nissan Pathfinder 4wd starts and runs fine but it will not go into gear to drive or reverse,what is the problem?


How To put a Nissan Into 4 Wheel Drive - YouTube

? 2:09
https://www.youtube.com/watch?v=IirIxH0WIVI
Mar 13, 2011 - Uploaded by suzuki230
Just a quick How To, on putting your Nissan into 4 wheel drive. ... to warn the newbies not to drive on hard surface while in 4WDthis can ... If you're having difficulty engaging the 4wd low gear, you can steer ... Hey man i have a 1991 nissan pathfinder SE im going to install a ... How fast can you go on 4L?.

Nissan Pathfinder Questions - automatic will not go into any ...

www.cargurus.com > Questions > Nissan > Pathfinder

CarGurusautomatic will not go into any gear - was driving and parked. now it wonit go into gear. ... Asked by avips Apr 14, 2010 at 04:02 PM about the 1993 Nissan Pathfinder. Question type: Maintenance & Repair ... 2002 Nissan Pathfinder LE 4WD.

Automatic Transmission May Not Shift Correctly at High ...

repairpal.com > Problems > Toyota > 4Runner
truck periodically will not shift into drive at initial start-up. Will very often shift ... 1990Toyota 4Runner- Automatic Transmission100,000Visitor. I have very similar ...

10 Most Common Transmission Problems



Jan 01, 2016 | Nissan Cars & Trucks

2 Answers

My 1995 Nissan pickup xe truck when I put it in drive it will not shift out of first and once I get to the speed of 25 miles a hr. it shifts into neutral until it goes down to appx. 15 mph then it kicks...


V6 or I4 engine? xe = i4?
bad tranny.?
low or too high ATF levels.
clogged bottom filter before pump, (shifts hot?)
RE4 trans is 4speed electronic
RL4 xxx trans is manual only
this side of your tranny has a tag is it RL/RE4 or or 3speed.

3 speed or 4 speed the FSM show four A/T used then .
there are 5 tranny total then ,4 AT (1 m/t)
on car diagnosis varies greatly by type.
fluid checks (if electronic the Tcm blink codes (DTCS)
pressure checks. for weak pump.
that stall rpm tests.
here is one used on your car
http://www.bulkpart.com/Merchant2/graphics/Catalog-pdf/RE4R01A.pdf

Oct 16, 2013 | 1995 Nissan Pickup

1 Answer

My gears grind when shifting, especially reverse... HELP PLEASE!


clutch could be worn out ?
how many miles since it was replaced ?

Jun 28, 2012 | 1988 Toyota Pickup

1 Answer

My 1995 nissan p/u v6 4x4 manual trans makes a sandpaper-type-grindng noise in 1st, 2nd, 3rd, 5th and reverse, but is quiet as a church mouse in 4th gear. No vibrations; no shift problems (up or down); no...


the noise is probably a lower counter shaft bearing, the reason you don't hear it in 4th is because 4th is the only gear that does not use the counter shaft. there is no easy way of fixing it it is the first part installed when the trans. is assembled and the last thing removed when the trans. is disassembled.....SORRY

Nov 16, 2010 | 1995 Nissan Pickup

2 Answers

Reverse went out?


sound's like you may need to replace your tranny, check the linkage on the tryny, bolts do loosen up sometimes. good luck

Dec 20, 2009 | 1990 Toyota Pickup

1 Answer

1990 Nissan 300zx w/ shifting issue


well Im sure theres a ton of miles on it-do u perform reg maint like checkin fluid level-u may need the throttle cable ajusted that hooks to trans-band n clutch could be out of measure too--trans hydra-valve system could be worn--see all these things effect the way the fluid makes the gears move--a pressure test can confirm an aging trans

Apr 03, 2009 | 1990 Nissan 300ZX

1 Answer

94 nissan pickup se how to reset check engine light


disconnect the negative battery cable re hook it back on.. this is only a temp solution if there is a problem it will come back on in the next 100 miles

Jan 30, 2009 | 2007 Nissan Murano SE

Not finding what you are looking for?
1991 Nissan Pickup Logo

468 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

64286 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...