Question about 2002 Jeep Liberty

1 Answer

The part time light is on - 2002 Jeep Liberty

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 74 Answers

Start car put it in neutral shift 4x4 lever into 4x4 low then drive a few feet. now shift main trans back to neutral then move 4x4 shifter back to 2wd high for normal driving then shift in drive and drive for a few min light should turn off..if nor disconnect battery for 15 min to reset computer and see if that does it. if that doesnt work you may need 4x4 linkage adjusted ..do you have a lift?

Posted on Nov 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does airbag fault code 13 mean for the 1995 ford taurus?


here you go

  • 2008 f 150: air bag light..over about 3 time then stays on. www.justanswer.com/ford/1x60b-2008-150-air-bag-light-blinks-times... 2008 f 150 air bag light blinks 1 times and than 9 times what is the problem? It does this over about 3 time then ... I have a 1994 Ford F150 with a flashing airbag ...
  • Air Bag Light Flashing, How to diagnose and fix - YouTube www.youtube.com/watch?v=FiO9wUb9FV4
    • BY CHRISFIX
    • 5 MIN
    • 768K VIEWS
    2014-01-21 · Video embedded · Air Bag Light Flashing, How to diagnose and fix ... 15- drivers side air bag circuit shorted ... Ford F150 Air Bag Light B1884 LFC 27 ...
  • 95 Ford Escort: airbag light blinks 3 times then 2 times www.justanswer.com/ford/1p7bw-95-ford-escort-airbag-light-blinks... ... 95 Ford Escort: airbag light blinks 3 times then 2 times ... 95 Ford Escort, airbag light blinks 3 times then 2 times.How do I fix this? ... the air bag module, ...
  • 94 Miata Has a Air Bag Light That Blinks Once, Pauses the ... www.2carpros.com > Warning Lights > Airbag Light 94 miata has a air bag light that blinks once, pauses the blinks three times. ... a air bag light that blinks once, ... fix then I am going to disconnect the air bag.
  • Lincoln Town Car Questions - My air bag light blinks 3 ... www.cargurus.com > Questions > Lincoln > Town Car My air bag light blinks 3 times then 3 more times ... the airbag light flashes 5 times then once. 3 ... light is flashing code 44 which is a right hand air bag sensor ...
  • Flashing Air Bag Light - Nissanhelp.com Forums x.nissanhelp.com > Nissan Models > Armada
    • 142 POSTS
    • FIRST POST: 2007-04-07
    2008-07-29 · First you need to find out what is the code store in the air bag control unit. Once you get the ... the air bag light on ... the light. It will start blinking in ...


  • http://www.bing.com/search?q=+air+bag+light+is+blinking+1+once+then+3+times&form=PRHPR1&src=IE11TR&pc=EUPP_HRTS

    Aug 01, 2016 | 1995 Ford Taurus

    1 Answer

    Malfunction indicator light not commicating


    Vehicle fault lights is caused by fuel emissions system more commonly, you at the time of fault lights to start vehicles, car, start, out after three times in the launch vehicle would you see if the trouble light or light, or light up you need in a timely manner to the store check the fault code, is a problem of engine or the sensor fault, or light may be occasional failure can need not in time to the shop to check the sohu auto q&a platforms,auto diagnostic tool.

    Mar 14, 2013 | Cars & Trucks

    1 Answer

    How do you fix timing on 96 nissan sentra


    For adjusting the ignition timing, you need a timing light.
    Attach the spark lead from the timing light to the number one spark plug.
    If the timing light is a powered type then
    Attach the power leads of the timing light to the battery - red lead to the + terminal on the battery and the black lead to the - terminal on the battery.

    Loosen the distributor so you can adjust the timing, start the engine and press the timing light trigger and aim the timing light on the timing marks on the crankshaft pulley. Adjust the distributor to the recommended timing mark for your engine.
    Turn off the engine, remove the timing gun and tighten the lock on the distributor.

    Feb 24, 2012 | 1996 Nissan Sentra

    1 Answer

    How do i set the timing


    Hello hpar..... you will need a timing light and a set of wrenches. Then:

    1 Remove the timing window cover from the top of the transaxle. Clean off any dirt or grime from the flywheel to expose the timing marks. Start the car and allow it reach normal operating temperature. Turn off the engine.
    2 Connect the timing light to the battery if necessary and then to the number one ignition wire located at the front driver's side of the engine. Restart the Taurus and let it idle for 2 minutes.
    3 Point the timing light at the timing window and determine the amount of adjustment needed. Loosen the mounting bolts on the distributor and rotate it slowly until the timing mark and the middle line on the timing light match.
    4 Tighten the distributor mounting nuts and recheck the timing. Turn off the engine and remove the timing light. Replace the number one ignition wire.

    Feb 20, 2011 | 1995 Ford Taurus

    1 Answer

    Where are the timing marks on ford ascape 2001 v6 3.0


    On the crankshaft:

    Timing Lights There are two basic kinds of timing lights--DC powered timing lights, which operate from your vehicle's battery, and AC powered timing lights, which operate on 110 volt house current. Of the two, the DC light is preferable because it produces more light to see the timing marks in bright daylight. Regardless of what kind is used, the light normally connects in series with the No. 1 spark plug using an adapter. Models that are more expensive sometimes use an inductive pickup, which simply clamps around the plug wire and senses firing impulses. Inexpensive models use alligator clips; one clamps onto the connection between the plug and the plug wire, and the others clamp onto the vehicle battery terminals. NOTE: Some timing lights will not work on electronic ignition systems, so unless you still own a vehicle equipped with points, check to make sure the timing light you buy will work. The biggest problem you will probably have when using a timing light is trying to see the timing marks on the crankshaft pulley. Before you time the engine, mark the appropriate timing indicators with fluorescent paint or chalk. Stay out of direct sunlight when you time the engine and buy a timing light with a xenon light, not a neon light. Timing lights that use a xenon tube provide a much brighter flash than those that use a neon tube do. Fig. 1: A modern electronic timing light. Note the inductive pick-up clamp. 88521p22.jpg

    Nov 12, 2010 | 2001 Ford Escape

    1 Answer

    I need to set the timing on my 2002 nissan altima


  • Tools needed: A timing light and wrenches.
  • Locate the crankshaft pulley at the front of the Altima's engine and clean it off to expose the timing marks. Start the car and turn off any accessories such as climate control, lights and the radio. Allow the engine to idle until it reaches normal operating temperature.
  • Turn off the engine and connect a tachometer to the distributor per the manufacturer's instructions. Connect the timing light to the battery and then to the number one ignition wire. Start the engine and verify it's idling at 1,000 RPM. Adjust the idle speed if necessary

  • Point the timing light at the crankshaft pulley to determine the amount of adjustment needed. Adjust the timing by loosening the distributor mounting bolts and turning the distributor until the crankshaft timing mark lines up with the middle line of the timing light.

  • Tighten the distributor mounting bolts and recheck the timing. Turn the Altima off and remove the tachometer and timing light. Reconnect the number one ignition wire.
  • Oct 07, 2010 | 2002 Nissan Altima

    1 Answer

    How to use a Matco Diagnostics Advance Timing Light


    Hook it up like any other timing light. The difference is that you can look at the timing mark and turn the dial n the light until the timing mark on the engine is at zero. Whatever the dial read, that is the timing. This is most useful when you want to look at total advance at higher RPM's where the timing gets into 20 or 30 degrees, which is more than is on the timing pointer on the engine. If you want to use it like a regular timing light, just set the dial to zero.

    Feb 23, 2010 | 1985 Buick Riviera

    1 Answer

    Service light, headlights blink 5 times on start


    sounds like there is a problem with the day time running lights my does the same thing but because i installed HID light so i no long have day time lights try changing headlight bulbs if not then its a short

    Jul 17, 2009 | 2002 Chevrolet Cavalier Coupe

    1 Answer

    CORRECT IGNITION TIMING PROCEDURE


    I don't know who posted that but yes you need to use a timing light. Unplug the coolant temp sensor and set the timing to what the underhood sticker says with a timing light.

    May 26, 2009 | 1986 Plymouth Reliant 4 Door

    1 Answer

    Airbag lights


    the left light yellow stays on . the right light flashes on then quickly 3 or 4 times .some times they go out for a while and then come back on

    Nov 17, 2008 | 1999 Mazda 626

    Not finding what you are looking for?
    2002 Jeep Liberty Logo

    Related Topics:

    390 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Jeep Experts

    yadayada
    yadayada

    Level 3 Expert

    61037 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    21949 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    6812 Answers

    Are you a Jeep Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...