Question about 1995 Mercury Grand Marquis

1 Answer

'95 mercury grand marquis enviro unit will not send heat. Fan ,ac,and breakers all good.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 651 Answers

Might be your thermostat, also make sure the fluid level is correct. it only takes a small amount of low coolant to drop the heat.

Posted on Nov 28, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1994 Mercury Grand Marquis temp gauge reads hot


Check sending unit, Ford/Mercury put out a TSB, technical service bulletin : Article No. 95-13-2 07/03/95, on erratic temp sender units.
You troubleshoot as follows :
  1. Turn ignition switch to On or ACC position.
  2. Connect a 10 ohm resistor between gauge lead and ground. The centerline of pointer should fall within the band around the H mark.
  3. Connect a 73 ohm resistor between gauge lead and ground. The centerline of pointer should fall within the band around the C mark.
  4. If gauge tests within calibration, replace sender.
  5. If gauge is out of calibration, replace gauge.

Mar 16, 2013 | 2000 Mercury Grand Marquis

1 Answer

Cooling fan keeps running on my 2003 grand marquis Fuse Good Relay Good. where is the temp switch ? what else con I look for Thanks Jeff


If your using the a/c or heat mix, defrost settings the fan is going to continue to run, the temp sensor is on the front of the intake manifold.

Feb 19, 2011 | 2003 Mercury Grand Marquis

1 Answer

The serpentine belt routing diagram for a 95 mercury grand marquis. What belt do I need to bypass the AC pulley?


Rather than by pass the AC pulley You can actually buy a dummy pulley. It has the same position and size as the the AC pulley but has a frame instead of the AC assembly. In this way you can remove the A and keep all belts etc. the same. The following site has a diagrams for the '95 marquis belt route:- http://www.bestvalueautoparts.com/Replacement_Parts/MERCURY/GRAND_MARQUIS/Illust_c_Belt_Routing.html

Oct 27, 2010 | Mercury Grand Marquis Cars & Trucks

1 Answer

Need belt diqgram for 86 grand marquis


1986 MERCURY GRAND MARQUIS - V8 5.0L 302ci GAS FI N F

Belt Routing Diagram / Fan, Alt. & P.S., w/o 70, 100 Amp Alt., w/o A.C.

6691605.jpg




Belt Routing Diagram / Fan, Alt. & P.S., w/70, 100 Amp Alt., w/A.C.

60eb665.jpg


Hope this help (remember rated and comment this).

Mar 23, 2010 | Mercury Grand Marquis Cars & Trucks

1 Answer

2004 Mercury Grand Marquis with auto air condition. Blower does not come on AC / Heat still works but no air. I have replaced the blower motor, relay and fan control module but with no luck. Am I missing...


check for fuses. If some other defective stuff that you replaced broke the fuse then you may need to repower the system by replacing the fuse or a relay.

As for the air, do you mean no blower for both heat function and A/C function? An Owners Manual would show location for fuse and relay for blower. A web-search with term like "2004 Mercury Grand Marquis fuse panel or
blower relay location" could help.

Last, do not know if blower resistor relay was known good quality. This part is tempermental. Sometimes takes tap from broom or snowbrush handle to wake it up. Sad part is that after warranty there is little benefit from a used to new part. Should have been a National recall on this part.

Jan 19, 2018 | 2004 Mercury Grand Marquis

1 Answer

Ac or heat wont blow


Needs a blower motor resistor if the fan only blows on one speed. It is located underneath the firewall on the outside, near where the passenger exhaust system is. You need to take the passenger side cat converter off to get to it.

Jun 02, 2009 | 2003 Mercury Grand Marquis

1 Answer

Where is the heater core valve in a '95 grand marquis


it is usually in line in the heater hose from the block to the heater core. it looks like a mushrom with a linkage on it.

Nov 27, 2008 | 1995 Mercury Grand Marquis

Not finding what you are looking for?
1995 Mercury Grand Marquis Logo

Related Topics:

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

fordexpert

Level 3 Expert

5626 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...