Do i need to remove fuel tank to drill mounting holes for seat base mounting ?
SOURCE: 03' grand am fuel pump removal
no you need to remove the tank sorry hope it help fixya our post thanks pierre
SOURCE: rear struts replacement
It's kinda hard to explain on line but I think you need to remove the rear seat back which you might have to remove the sitting portion to get that out. Once the seat back is out of the way most of the parcel shelves slide foreward. I've done this on some newer BMWs and the plastic on the sides needed to be removed also. If you could post a picture of the whole rear shelf area I could probably help you more.
SOURCE: replacing fuel pump need to remove rear seat need to know how
First you will need to releave fuel pressure......
next remove the rear seat cushion to gain access to fuel pump access panel.....
Removing Fuel Pump....
SOURCE: fuel pump - 2003 Pontiac Grand Am
2003 Grand Am GT,You have to drop the fuel tank,remove heat shield,remove all lines,electrical plug ins,then you are ready to do straps,be sure to go get extra nut and bolts for straps (2) of them had to cut off old ones,once straps are off depending on how much gas is in the tank used jack to lower tank,fuel pump was a twist off with locking mechanisms on top of tank,used a rubber malet and screw driver to loosen,pull out after diconnecting plug ins etc,replace blue plug in for harness to fit new pump,was recommended since it could corrode,lifted tank back up connected wires,lines etc,put key in on position 3-4 times for pump to pump,car started 1st time,my first fuel pump took my son and I 2 1/2 hours,new pump $250.00 wire harness $15.00 and two new nuts and bolts $3.25
SOURCE: how to remove rear seat from 2001 Audi allroad
Not 100% sure on yours but normally you'll either have a couple of bolts way down under seat cushion at front, near floor, or in some cases, you have to push seat cushion back toward rear window, hard & lift, to pop it out of notched catch under it.
59 views
Usually answered in minutes!
×