Question about 2001 Jeep Grand Cherokee

1 Answer

Wining at speeds of 25mph to 45mph! Noise lightens over 50mph!

2001 Jeep Grand Cherokee quadra drive. Recently had front wheel bearings changed after similular problem. The difference was loud wining at 50mph or higher!

Posted by on

  • yadayada
    yadayada May 11, 2010

    Where is the noise comming from? front or rear end.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 393 Answers

Ck fluid level of diffs, and transfer case

Posted on Dec 09, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace Front Wheel Hub Bearing 2002 Jeep Grand Cherokee 2 wheel drive


Removal
  1. Raise and support the vehicle.
  2. Remove the wheel and tire assembly.
  3. Remove the brake caliper, caliper anchor, rotor and ABS wheel speed sensor.
  4. Remove the cotter pin, nut retainer and axle hub nut.
  5. Remove the hub/bearing mounting bolts from the back of the steering knuckle. Remove hub/bearing from the steering knuckle and off the axle shaft.
Installation
  1. Install the hub/bearing to the knuckle.
  2. Install the hub/bearing-to-knuckle bolts and tighten to specification.
  3. Install the hub washer and nut. Tighten the hub nut to specification. Install the nut retainer and a new cotter pin.
  4. Install the brake rotor, caliper anchor, caliper and ABS wheel speed sensor.
  5. Install the wheel and tire assembly.
  6. Remove the support and lower the vehicle.

Apr 22, 2012 | 2002 Jeep Grand Cherokee

2 Answers

I have 94 Jeep Grand Cherokee 4x4 and I cannot drive it more then 50mph on the high way because starts to jump as if I have a flat tire it feels front right side and I have to stop then I can continue...


Typically it sounds like wheel balancing, although the speed at which it starts is just on the low side (normally 60-65 mph), but not impossible, and combine that with shock absorber problems it is quite possible.

Apr 27, 2011 | 1994 Jeep Grand Cherokee

1 Answer

Whouling niose when speed increses and decreses on my jeep grand cherokee 1998


You need differential carrier and pinion bearings. Jeeps had many problems with the differentials in these years.

Jun 02, 2009 | 1998 Jeep Grand Cherokee

1 Answer

1999 Jeep G C Quadra Trac keeps getting stuck in 4 wheel drive.


universal joint on the driveshaft may do this !
check transmission fluide as well.
good luck

Mar 31, 2009 | 1999 Jeep Grand Cherokee

3 Answers

2001 Jeep Grand Cherokee Limited is squeaking


duse the howl go away when you trun a conner ?if it duse its a wheel bearn. as for the squeak its hard to pin point. try finding some one how duse mud run they would be ableto help you with the howl noise. have a nice day

Mar 31, 2009 | 2001 Jeep Grand Cherokee

1 Answer

Turning sharply in parking lot vibration or rubbing feeling in the steering also in reverse on 2001 grande cherokee with quadra track 2


1st let me make sure I understand your Jeeps 4 wheel drive. I believe the quadra trac system is a full time 4 wheel drive, there is no 2 wheel drive setting, only a separate 4 Lo (for very slow speed). If this is correct, the problem is, the quadra trac system you have is supposed to compensate for any variations in wheel speed, whether it's driving in the snow, or cutting the wheels sharply to park on dry pavement. What u describe is typical behavior of a part time 4 wheel drive system. The problem is, your full time 4x4 should be compensating for this, and it's not. So, let me know if the above info about your 4wd is accurate (no part time 4wd setting, no 2wd setting, only full time 4wd and 4Lo setting. If it is, the system is not compensating for changes in the wheel slippage correctly.

Mar 21, 2009 | 2001 Jeep Grand Cherokee

2 Answers

2004 Jeep Grand Cherokee makes a whining noise over 50mph


i just had the same problem and the dealship fixed it right away. that sound can be annoying. $1500 was way to much to pay. i paid $49 dollars to have a diagnostic. the only thing that needed to be done is for the wheel bearing to be greased. the problem was solved.

Jan 28, 2009 | 2004 Jeep Grand Cherokee

Not finding what you are looking for?
2001 Jeep Grand Cherokee Logo

576 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

70374 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...