Question about 2001 Hyundai XG300

1 Answer

Aceletation when push the clotch

The aceleration (rpm) goes up until 2500 0 3000 when i use the clotch..my car is standar. 5 second after i stop the car the aceleration goes down.
Thank for you help.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 26 Answers

This could be a sign of a vacuum leak, especially while driving. Have your car checked to make sure everything is fine.

Posted on Nov 27, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

High idle unless driving in gear, but if clutch is pushed in or car is in neutral rpm goes up to 2900


run fault codes to check for accelerator position sensor problems . Check for vacuum leaks. If cable accelerator then check that the return spring on the end of the cable is attached and not missing.

Feb 14, 2014 | 2004 Subaru Outback

1 Answer

Rpm does not drop below 1000


No,only on carburated engines it,idles down to the set point,on yours,it's fuel injected,pushing gas pedal won't kick idle down,should go down after a certain amount of time,does it automatically,If you start and drive a 5 mile ride and stop at a stop sign,it should idle at it's set point if there's no engine problems,which may be.5 to .7 on your tac.When you normally first start,it will idle between 1000 to 1200 rpm's,don't push on gas,let idle say 15 seconds,put in drive and go.

Jan 13, 2013 | 2005 Chrysler Sebring Conv

1 Answer

Check gauges signal , temp gauge stop work, when I acelerate everything goes normal again


My guess would be a short or problem with the printed circuit board in the cluster.

Jul 20, 2012 | Cars & Trucks

1 Answer

Oil gauge goes up when acelerating


thats normal. your pushing more oil with higher rpm's

Jun 17, 2010 | 2005 GMC Envoy

3 Answers

Reset change engine oil light


Information taken from: http://www.idavette.net/tech/oilreset.htm

[quote]
The "Change Oil" indicator is reset by using a sequence of Driver Information Center (DIC) key presses as follows:

1. Turn ignition "ON", but do not start engine. (ALDL pin "G" should NOT be grounded.)
2. Press the "ENG/MET" button and release, then, within 5 seconds, press it again.
3. Within 5 seconds of Step 2, press and hold the "GAUGES" button. While the button is held, the "Change Oil" indicator will flash.
4. Continue holding the "GAUGES" button until the "Change Oil" indicator stops flashing and goes out, indicating successful completion of the reset cycle. This should take about 10 seconds.
If it does not successfully reset, turn ignition "OFF" and repeat the procedure from Step 1.
[/quote]

Nov 16, 2009 | 1991 Chevrolet Corvette

1 Answer

OIL PRESSURE SWITCH CHEVROLET 4.3 1994 SONOMA /S 10


hook up a mechanical gauge and verify the pressure at idle is correct, I suspect the sending unit is defective

Sep 06, 2009 | 2001 Chevrolet Blazer

1 Answer

High rev when starting hyundai atos


Check the vacuum hoses, but sounds like the IAC or even the o2 sensors. The computer will pick up on the o2 sensors but not the IAC..Go to your local ADVANCE store and they will check on computer for free :)

Jul 26, 2009 | Hyundai Accent Cars & Trucks

Not finding what you are looking for?
2001 Hyundai XG300 Logo

Related Topics:

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

63291 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...