The RED airbag control light returns errorcode 47 (4 long flash periods, followed by 7 short ones) all time, whereas the YELLOW one in on all time if driver mate's seat is unused (if used, the YELLOW light is off). Reason?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
For a 99 626, the service information says that code '7' is for the passenger side airbag module. I know that your question says that you have a code '47', but the information has codes 1 / 2 / 3 / 6 / 7 / 11 / 12. It states "replace SAS module for codes not listed." The SAS module is the main airbag computer.
there are a quite a few problems associated with the airbag light flashing. The light will flash in long and short frequencies, this is a diagnostic code, e.g. two long flashes followed by six short flashes equals code 26, which is clockspring. Other codes are: 46 and 47 connector under seat, 3 power supply etc.
Where the handbrake lever is,it will be covered by a boot of some sort.Peel this back and beside the lever will be either a rod with a nut on it,or it will have a recess for a screwdriver.with the h/brake off,do the adjustment by tightening it.When it's right, the h/brake should have to be pulled so 7 'clicks' can be heard.Hope this helps
Well, for one you not suppose to put a baby seat in the front of the car. But anyways with an older airbag control system like that you cannot just disable one airbag, if you unplug the passenger side airbag then in an accident neither airbags will deploy.
This is either a problem with one or both of your airbags or the airbag connector located at the back of the glovebox has been disconnected for some reason. (ie. to prevent airbag opening when installing baby seat) (1999 miata does not have a baby seat airbag disabling sensor).
You should get your car inspected at your local mazda service to check if this is a wiring (plug disconnected) issue or one of your airbags is malfunctioning and needs to be replaced.
Flashing airbag light could indicate that either one of the airbags or both have a problem. Disconnecting the passenger's airbag has the same effect.
Warning! Do NOT attempt to do any kind of airbag/airbag wiring related repair yourself. Airbag problems should be addressed ONLY by certified technicians at your local Mazda service. (Airbag fixing requires for example that the car battery is disconnected, you MUST NOT attempt anything with the car battery connected).