Question about 2002 Chrysler Sebring

1 Answer

My heat doesn't work on and speed

I got in my car today and turned it on to let warm up when i returned ten minuits later i noticed that there was not heat so i tried different setting but nothing just curious to what might cause this problem

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Chrysler Master
  • 1,779 Answers

It can be several things, 1st to check is coolant level. If the level is too low, it won't circulate thru the heater core, and no heat. 2nd, check the thermostat. If it's stuck open, your car will not heat up and u will not have heat. 3rd is the dash control that calls for heat. If u have trouble w/ the vacuum control when turning lever to heat, it won't open the valve to allow the hot engine coolant into the heater core. 4th a plugged up heater core, due to corrosion buildup, coolant can't circulate, no heat. That should cover the possibilities, start w/ the easy cheap stuff, and work your way down the list. Let me know what you find, and if this doesn't fix it, we can continue on.

Posted on Nov 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My heater blows hot for a couple minutes then turns cold. After turning it off for a few minutes and back on, it blows hot then goes cold again.


LET YOUR CAR WARM UP FIRST!! or you risk the chance of over heating and casuing engine damage. start your car let it warm up for 5 to ten minutes and then try the heat. also when you start you should NEVER have heat on right away. the heat that you feel comes from the engine. and if the engine is cold and you are trying to heat it up it will put stress on the engine and over heat. ALL cars have to wait for their heat. that's why you see peoples car running in the morning with no one in it. so when they do get in it they have heat. heat will not work until the engine is warm.

Oct 24, 2013 | 2002 Ford Taurus

1 Answer

Speedometer and Odometer not working at times, matches with engine heat cycle


Your vehicle speed sensor is mounted in the transaxle housing which is also subject to heating and cooling. The wiring harness to and from the speed sensor is also subjected to engine heating and cooling. Anybody that knows anything about electrical circuits can tell you that an electrical circuit's worst enemy is heat. You need to diagnose the vehicle speed sensor circuits like the code is TELLING you to do.

Jun 02, 2012 | 1998 Ford Windstar

1 Answer

Fan still running after car is shut off


which fan are you talking about cooling Fan for Radiator or Blower Motor Fan for heat/AC

Jan 02, 2012 | 2003 GMC Envoy

1 Answer

I have a 2000 pontiac grand prix with a digital climate control system. The heat quit working, it doesn't blow out any heat. Now that it is warm outside the air stopped blowing out any air. The digital...


I have a 2000 pontiac grand prix with a digital climate control system. The heat quit working, it doesn't blow out any heat. Now that it is warm outside the air stopped blowing out any air. The digital temperature on the climate control is not correct. When it states that it is below 30 degrees on the ext and it is warm outside the air wont be cold. Once it starts going above 30 degrees the air gets colder. Today the blower stop working all together. Was told it maybe the climate control unit was bad. You can hear the door opening/shutting when you switch the temp from cold to hot. But there was no heat blowing out whatsoever in the winter time. Could you please give me your opinion on whether or not it is the climate control unit or something else?

Jul 11, 2011 | 2000 Pontiac Grand Prix

1 Answer

I replaced the battery and the sirius radio doesn't work - it is stuck on aquiring signal for over 30 minuites. The owners manual says to wait at least 10 minuites and it should resync but it...


Disconnect the negative battery cable for 10 mins, then reconnect it and try. Sometimes it can lock out the Sirius unit, and by disconnecting the negative battery cable for 10 mins, clears out the whole system so it can be booted properly.

Thanks Jay!

Jun 26, 2011 | 2007 Nissan Murano SE

1 Answer

I have 03 Yukon Denali XL. When I drive longer than an hour on highway all of sudden all the warnig lights comes on, goes off a minuite later after 2 seconds black out. Reapeats same problem every 3 to 5...


Sounds like possibly a faulty ignition switch, They will cause symptoms very similar to that. Another thing 2001-2003s were known for are bad instrument panel clusters (dash assembly) usually the speedo gets pegged at a certain speed and stays there.

Jan 28, 2011 | 2003 GMC Yukon Denali

1 Answer

I need help!!! Today I was on my way to work and the odometer was flipping through numbers as if it were a glitch, and then going back to the correct reading. Yesterday morning, while on my way to work,...


I just got the same problem on a 97 ford expedition, I have to start working on it, more likely would be a malconection issue or the swich unit check for any burned wires. and also check both the positive and the negative conection at the batrery. that all I'll keep you posted.

Dec 13, 2010 | 1999 Ford Expedition

1 Answer

Starts nocking 10 minuits after running sound great the first ten minuits and the truck throws no codes


a 95 is only obd1 so problably wont get many codes. the oil is thicker in the first ten minutes or so, after it warms up the oil thins out. short of rebuilding the engine and/or doing a head job, try some lucas oil treatment or high tach. both are very viscous and help with thin oil

Oct 03, 2009 | 1995 GMC Sonoma

1 Answer

Engine light on.car choken up,not picking up speed,


if its runnjing well for first few mins then chokes up i would suggest auto choke isnt turning its self off ,the cause of this is a miriad of things and to try changing bits ad hoc so to speak will cost more than what it would do to have it in the nissan garage.But dont be surprissed if you need a new ECU unit (computer) but lets just hope its a sensor fault

Aug 12, 2009 | 2001 Nissan Altima

1 Answer

Car over heats on idle or very low speeds.


check your water pump. when has it been replaced last? There is normally a 'tell-tell' hole behind the fan, on the pulley shaft housing. If its weeping water, you should replace it.

If your water pump is original, they are typically made of aluminum (newer cars) and from electrolosis, will deteriorate.

Feb 16, 2009 | 1996 Pontiac Grand Am

Not finding what you are looking for?
2002 Chrysler Sebring Logo

202 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...