Question regarding this problem is. if the engine code p0171 has anything to do , preventing the engament of the tranmission overdrive on this toyota tacoma 2000.( we know the code p0171 refers to bank one running lean) the engine was chek for possible vacuum leaks,fuel pressure ,maf sensor,exhaust leaks and the o2 sensor was replaced.the engine runs fine , but this code comes on after it is erased.can you tell if this is possible for this engine code to affect the trans overdrive engagement.
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones). click here to download the app (for users in the US for now) and get all the help you need. Good luck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
A code P0171 may mean that one or more of the following has happened:
The MAF (Mass Air Flow) Sensor is dirty or faulty Note: The use of "oiled" air filters may cause the MAF to become dirty if the filter is over-oiled. There is also an issue with some vehicles where the MAF sensors leak the silicone potting material used to protect the circuitry.
There could be a vacuum leak downstream of the MAF sensor
Possible cracked vacuum or PCV line/connection
Faulty or stuck open PCV valve Failed or faulty oxygen sensor (bank 1, sensor 1)
The knock sensor fault may be preventing the transmission from shifting to OD. The main engine computer also sends commands to the transmission computer. Your transmission valve body is controlled by electronics.
You don't say if it is a 4 cyl or 6 cyl engine. The code means the O2 sensor is telling the computer the engine fuel mixture is too lean and the computer can not make the injectors provide enough extra fuel to make the sensor go rich. Reasons can be a faulty cooling thermostat, low fuel pressure, vac leaks, exhaust leaks, and other engine problems.
Speed sensor. cheap to purchase and easy to change. This will solve the problem of speedometer and not shifting into overdrive. Check engine light may go out or the codes will need clearing by disconnecting the battery for some time.
sounds like an electrical problem with the transmission ...these transmissions are fully electronic and the gears are engaged by servo valves these are controlled by the computer.... if there is any problem with the engine or a few other things it will be put into safe mode and it wont engage overdrive ..it may need to be scanned to see if any codes exist in the auto trans ecm..
P0171- mens the MAF sensor is dirty and needs cleaned. You can get MAF cleaner at your local auto parts store. The MAF is located in the air intake just after the air filter
P1130- is more than likely a result of the previous code. It is in regard to the feul/air mixture ratio. A dirty MAF can cause this code.
Also, if you are using an aftermarket oiled air filter, it would be the cause of the P0171 code.
The first and last code are your start and stop so you can ignore them the P1130 and P1150 are your two front oxygen sensors( pre cats ) bank one and two. Depending on your millage it sounds like it is time for a little maintence. Normally they should be changed at or around 60,000 kms