Question about Isuzu Hombre

1 Answer

My transmission is starting to slip how do you change the transmission filter

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 324 Answers

You will have 8 to 16 bolts on the transmission pan, you have to drop the transmission pan and the filter will be hte first thing you see, it should just pull out of the tube so you can pop the new one in.

some are held in with a 10MM screw.

Posted on Nov 26, 2008

6 Suggested Answers

  • 141 Answers

SOURCE: 1999 cougar automatic transmission is slipping

If the fluid was brown or gray when you changed it, I am afraid you are a little too late and have already sustained internal trans damage.

Posted on Jan 11, 2009

  • 1 Answer

SOURCE: 156,000 mi./automatic transmission slipping/slow to change gears

Nope. There is a drain plug on the transmission case. It is a simple drain and fill. Odyssey transmissions do not have a filter.

Posted on Sep 10, 2009

RonPark
  • 855 Answers

SOURCE: my transmission is slipping when accelerating from

The forward clutches are going bad is the most likely problem. To repair the trans should be rebuilt.

Posted on Oct 08, 2009

Testimonial: "That's what I was afraid of, a total rebuild. "

tragedy lok
  • 266 Answers

SOURCE: The transmission seems to be slipping. How can

changing the fluid and filter would not hurt at all in fact adding a bottle of lucas som times gets people another 10,000 ive seen it happen give it a shot you have nothing to loose but the 30 dollars on parts and labor assuming you would be doing the work

Posted on Dec 23, 2009

ftw1952
  • 10319 Answers

SOURCE: 1992 park ave transmission slips fluid and

It probably did not slip before the fluid was changed I so the clutches are worn out and need to be replaced The worn fibers were still in the old fluid causing the fluid to be thicker filling the voids much better to shift. Now once drained and new fluid installed it slips

Posted on Apr 27, 2010

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Counselor


IF your transmission is truly slipping then changing the fluid is not going to help. It won't hurt but it won't help. I am wondering, are you sure the transmission is slipping. It will have a check engine light on and a trouble code if it is slipping.

Apr 20, 2014 | 2003 Buick Rendezvous

1 Answer

98 crown vic transmission slipping


Change the filter and fluid. This car if the transmission is original should have a torque converter drain. Drain the torque converter also,it gets almost all the fluid out of the transmission. Doing this the car will require almost 12 quarts of fluid. Worth a shot. I change mine at 25000 mile intervals.

Oct 31, 2012 | 1998 Ford Crown Victoria

2 Answers

Transmission slips after engine warms up


It isn't when the engine gets hot, it is when the transmission fluid gets hot that the slipping starts, due to wear of the clutches and gears inside the transmission.
First, check the fluid level to make sure it is full. If it is low, bring fluid level to full and see if that helps.
About all the owner can do with slipping automatics is trying a transmission fluid and filter change to see if transmission revives and stops slipping. The bottom pan is removed, fluid (about 6-8 quarts) is drained, and a new filter is installed before the pan is replaced with a new gasket, sealed up, and fresh fluid added. Sometimes it helps. Sometimes the transmission is worn too bad to help, and you are left with looking for a replacement transmission.
Check the fluid level first. Good luck.

Jun 08, 2012 | Chevrolet Cavalier Cars & Trucks

1 Answer

Transmission slips out and when you stop and start it will only go about 15 mph if you shut it of wait a few minutes then start it transmission goes till gets hot again


The transmission probably needs a fluid and filter change. Do not use the quick lube places to flush the transmission as they do not change the filter.

Dec 02, 2011 | 1992 Buick LeSabre

1 Answer

Transmission started slipping in final drive.


I am a ford tech and once this transmission starts slipping in OD u are going to need an overhaul, changing the fluid won't correct the problem.

May 27, 2010 | 2004 Ford Taurus

1 Answer

2001 Dodge Grand Caravan. has been making a loud whining noise for about a week. started slipping last night. seems to get worse when going from a complete stop and when shifting into gears. other than...


MOST LIKELY HAS A PLUGGED TRANSMISSION FILTER.
TORQUE CONVERTOR CLUTCH FAILURE COMMON.
CHANGE TRANSMISSION FILTER AND ROAD TEST.
IF NOISE IS GONE AND RUNS NORMALLY, CHANGE TORQUE CONVERTOR AND RESEAL TRANSMISSION.

May 19, 2010 | 2001 Dodge Grand Caravan

1 Answer

Trans just started slipping 2002 Dodge Stratus with 54000 miles no signs of problems before do you check trans level in park or drive?


You allways check the transmission fluid level in car after the car has a few minutes to worm up. If you have not had the transmission fluid and filter change in a long time then you need to do it. The fluid and filter should be changed every 30,000 miles to keep you from having problems. Hope this will help you.

May 15, 2010 | Cars & Trucks

1 Answer

1996 honda civic lx Automatic transmission startting to slip


try having the transmission filter and fluid changed.

Jun 17, 2009 | 1995 Honda Civic

1 Answer

Transmission slips


Look usally when they start slippin,,, its gettin close to getin a rebuild,, but not always ,,it could have old transmission fliud in there. you can change the transmission fliud ,, thats should help,see it could be cloged up,, change fliud and the filter in tranny,, ,,cheaper than a transmission,, ,goodluck

Oct 05, 2008 | 1996 Jeep Cherokee Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

214 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...