Question about 1998 Mazda MPV

2 Answers

Car stalls changed spark plugs still wont start

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

1998 Mazda MPV Stalls While Driving Restarts Immediately To 30 Mins.

Posted on May 29, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 314 Answers

Not a lot to go on! Remove the distributor cap and see if turns when the engine is cranked. My guess is the timing belt is shot. Frankster016

Posted on Nov 26, 2008

6 Suggested Answers

  • 1 Answer

SOURCE: car wont start

these cars go through coil packs regularly as the packs overheat due to their position on the end of the engine. I have 3 lanos and have replaced all coil packs at around 90,000 k's.
Hope this helps.

Posted on Nov 26, 2008

  • 8 Answers

SOURCE: Car starts then stalls out...

could be to many thing to take chances with, but most commonly;fuel filter,gas line antifreeze or a crack in your air intake which would take your vacuum seal away, start with the least expensive and work from their. Worst case scenario pinched fuel line

Posted on Jan 19, 2009

  • 51 Answers

SOURCE: changed spark plugs and wires now car wont start

I know this might be obvious but the obvious is often the problem. Did you replace the coil wire that goes from your coil to the distributor cap? Also, double check to be sure that your wires are connected in the correct order. A little more clarification might help. Does it turn over? Does it just click? When you turn the ignition key then let off does the car clunk or make a wheezing sound?

Posted on Jan 30, 2009

  • 150 Answers

SOURCE: Change spark plugs and now car wont start.....1994 ford tarus

Do you have the "firing order" correct? In other words, is each spark plug wire going to the same cylinder it was on before you changed the plugs? If you have done nothing else but changed the plugs then this is the most likely problem.
If when you try to start the car it backfires through the exhaust or backfires through the intake. Then this " IS" the problem. Good luck.

Posted on May 23, 2009

  • 543 Answers

SOURCE: CAR WONT START,OBD SHOWED EGR AND MAF SENSOR

well the egr could be stuck open acting like a vacum leak,,,and causing the car to stall,,,you need a new egr,,,,check the wires and if any vacum hoses that go to it,to make sure they are good and connected first,if so replace the egr,,,,it could be false dtc for MAF sensor,,,

Posted on Oct 14, 2009

  • 138 Answers

SOURCE: my car stalled on me

How about the timing belt. Timing belt needs to be replace every 60K miles. Good Luck

Posted on Jan 07, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Changed transmission fluid on crv now car wont start


might be that you accidentally disconnected the crank sensor close to the transmission, this gives a no start condition without a check engine light on most cars...

Apr 19, 2014 | 2005 Honda CR-V

1 Answer

90 mazda 626 cranks but wont turn over


Have you checked for spark?

have you pulled a plug after cranking to see if it is wet?

does the engine sound like it is turning over faster than usual?

did it just not start or did it stall. Did this happen after you changed the spark plugs?

Apr 11, 2014 | 1990 Mazda 626

1 Answer

1990 buick riveria stalled and wont restart


check for spark from the coil then the leads to the spark plug .use a spark plug tester. then remove each plug one at a time .smell them for fuel .if ok change the plugs.

Dec 13, 2013 | 1991 Oldsmobile Cutlass Calais

1 Answer

91 mercury tracer 4 door sedan stalled while driving... wont start. Changed Spark plugs and wires and ignition coil. spark plugs are getting spark and the car is getting fuel. any suggestions?


You Know in the trunk is a fuel cut off switch i read in the manuel it will trigger even if u hit the smallest bump causing the car not to start before u mess with it please read up on it

Aug 12, 2010 | 1991 Mercury Tracer

2 Answers

My car wont start after i changed spark plugs and wires.


did u mix the plug leads up when u replaced them wrong firing order 1342

Apr 02, 2010 | 1994 Honda Civic

1 Answer

It started stalling out. I changed the fuel


all a car needs to run are 3 things

Make sure it getting fuel in the engine

Make sure its getting spark

make sure its getting air

that's it it may be a simple not getting fuel check your fuel pump than check your coils or plugs.

Sep 24, 2009 | 1991 Pontiac 6000

2 Answers

Will start up run for awhile then stall and wont restart


Hello, I would start with a general tune up. Spark plugs and wires, Fuel Filter, Oil Change and Filter Change, Air Filter Change, Some injector cleaner would not hurt eirther. Be sure to lubricate your high mileage car and also use a farily good oil for your motor as well. The run for awhile problem sounds like bad spark plugs. I would change your spark plugs, wires, distributor cap, and rotarty button.

May 20, 2009 | 1993 Honda Accord

Not finding what you are looking for?
1998 Mazda MPV Logo

Related Topics:

503 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...