Question about 2001 Chevrolet Astro

1 Answer

I took my van in for a basic turnup and oil change that was $264.

They only put the plugs they said more money for wirers where are my plugs located,and could i put the wirers my self on fixed income.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 94 Answers

If you remove the engine cover from inside the vehicle you will gain access to the spark plug wires and spark plugs. The spark plug wires come out of the distrubtor cap thats at the rear of the motor, the spark plug wires run to the left side of the motor and to the right side an end up attached to the spark plugs. Reolace spark plug wires one at a time so you dont mix them up, this is fairly easy the only difficult part is getting your hands in the small space in the engine compartment. Hope this was helpful.

Posted on Nov 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a Chevrolet 1999 Astro van RWD 4.3L , check engine light turn on with blinking at the same time.Code P0302 pop-up, I have given a complete Tune-up,change belt,tensioner and still check light st


DTC P0302: Cylinder 2 misfire detected. Probable cause:
1. Check for latest control unit software update
2. Faulty PCM or ECM
3. Faulty fuel injector
4. Ignition system fault. Check ignition module, coil, spark plugs and wires even if these are new replacements
5. Fuel system problem

Nov 23, 2014 | Chevrolet Cars & Trucks

1 Answer

Firing order for 95 chevy sports van g20 4.3L V6


if it is a vortec motor the wire numbers are on the cap 3 on one sid 4 on the other one of them being the coil wire

Mar 20, 2013 | Cars & Trucks

1 Answer

Need to know procedure to change the oil


locate the oil plug, under car. put pan under it to catch the oil.remove oil plug and let it drain. when all oil is out, replace the oil pan plug that you took out.after doing this remove the oil filter and discard it. put on new oil filter and tighten as much as possible only hand tight. then put in the new oil. check for leaks, and thats it. good-day !

Aug 06, 2011 | 1996 Pontiac Sunfire

1 Answer

I have a 1995 wrangler i was off roadin and i went thow a mud hole it was up to the bottum of the door i went thow it slow but win i got thow it i ran out of gas so i got it started and flew thow the water...


check your oil make sure the water didnt get into the internal of engine. if it didnt then yes when fuel ran out the sudden jult of the trans stoping befor the engine or vs versa can cuase the timming to jump

Aug 06, 2011 | Jeep Wrangler Cars & Trucks

2 Answers

I took my 2005 Dodge Caravan in for an oil change and it is making a knocking noise. I took it back and the mechanic said the oil pump went bad and now the van needs a new engine. Is this correct?


That very well could be-- if you lose oil pressure, this can ruin your engine. You should have seen a red "oil light" indicating that there was a serious problem, to accompany the knocking noise, which could be "rod knock" if you had very low (or no) oil pressure.
Make sure you have someone else verify before giving this guy thousands of dollars.

Mar 04, 2011 | 2005 Dodge Caravan

2 Answers

I want to change the oil myself but I have never done it before. I have a 99 Dodge Dakota with 150k. It has a 4 cyl engine. I know the basics but not much more than that. How much oil should it...


changing oil is pretty much the same, 5 quarts is all you need and don't waste your valuable money on synthetic, at how many miles already on the truck you don't want to use a different type oil because a lot of the gaskets will start to leak, hope this helps

Dec 29, 2010 | 1998 Dodge Dakota

1 Answer

Change the oil on a 2000 Dodge Caravan


Jack up pass side.Put cardboard, BIG piece under engine just in case. Using a pan to drain the oil in put under oil pan drain plug. Remove drain plug with socket wrench. Let drain 5 min. Check the gasket on the drain plug, if bad replace with new gasket .99 cents to replace gasket only on plug. Put plug back in DO NOT OVER TIGHTEN the plug. Slide drain pan with drained oil to the front to remove oil filter. Using a filter wrench remove oil filter. Let drain. When installing new filter put a little new engine oil on the rubber gasket on the filter with your finger. Screw filter back on tighten with filter wrench. Fill van with oil from front valve cover opening.

Nov 21, 2009 | 2000 Dodge Caravan

1 Answer

I changed distributor and wirers on 2000 dodge dakota 3.9 v6 2wd and crossed a wirer.How do i fix the problem.


Try going to your local library and find a manual for your 2000 dodge that would save you some money buying the manual unless having the manual for yourself is good.

Aug 31, 2009 | 2000 Dodge Dakota Quad Cab

2 Answers

Help


check or replace plug wirers. could be the coil pack .located @ other end of plug wirer

Dec 06, 2008 | 1996 Lincoln Town Car

Not finding what you are looking for?
2001 Chevrolet Astro Logo

Related Topics:

203 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...