Question about Toyota Paseo

1 Answer

When going throught the gears forward sometimes it takes more muscle to change particularly 3 to 4 or 4 to 5 ..... sometimes it is easy to change gear and sometimes it seems to take more effort ....kind of seems like it gets stuck in gear

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 393 Answers

Try double clutching(come out of 3rd then push clutch twice b-4 going to 4th. if this works your clutch slave may be weak or pressure plate is worn. Try shifting from 1st-3rd if engine revs like your in neutral replace clutch. when going 1st-3rd engine should catch and cause vehicle to buck&stumble. (check level of clutch master cylinder)

Posted on Nov 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Audi 500e 1992 model 5 cylinder automatic not chaning gears In drive it pulls away in 3 then does not change forward or gears down


This could be stuck in what is sometimes called "limp Home Mode"
I have found a common problem is the earth wire from body to engine has stopped making a good contact so take lead off and make sure both ends are clean from dirt oil etc and make a good connection on surfaces with a wire brush or sand paper and reattach
Good Luck :)

Oct 15, 2016 | Audi Cars & Trucks

1 Answer

Cadillac cts troubleshooting


Most like you need to flush the transmission and I would put one quart of Lucas transmission fluid in too. It will help with changing of gears.

Feb 01, 2014 | Cars & Trucks

2 Answers

Sometimes the R gear in my gear box dosen t work in my bmw ci 323 model 2000


hi. is this a manul shift trans?? if yes, then it is an easy fix. really it is. remove shifter knob and boot to gain access to the shifter assembly, you should be looking at the top of the transmission, remove 3 to 4 bolts holding the shifter in. slowly lift the shifter out of the trans, there should be a plastic "bushing" between the shfter and the shifting rod, its probably destoryed thats why reverse is hard to get, it adds more "throw" moving the shift rod of the trans more forward and firmly into gear.

Aug 12, 2010 | 2000 BMW 3 Series

1 Answer

Takes too long to change gears especially from 1-2. does not have the muscle to take off


My Jeep Grand Cherokee 4x4 takes a long time before it changes gears, how can I fix that. Its a 1998.

Mar 03, 2010 | 1997 Jeep Grand Cherokee

1 Answer

Have a 1996 f-350 7.3 power stroke w/auto trans, shifts fine from 1st to 2nd then in and out from third back to 2nd ,took to transmission shop trans fine but no power going to trans also odometer jumos...


HI, I have a 350, brand new in one of my old skool muscle cars with a 350 trans that used to be a drag car trans.
We changed the gears in it to street gears (4:11 to 3:55 gears) and every once in a while it will not go to the high gear, so I pull over, put it in park then back to driving and it works beautiful each time!!!!
Nothing is wrong with this car at all, brand new engine and trans in a oldskool muscle car!!!
*** The point to the story is; nothing mechanical is "PERFECT", only God's creations right. ;)
So the moral is more than likely the problem is from the area of the "engine to the trans"(that junction) and I will say your trans gears may have problems, one look doesnot make it true!
Get a second mechanic to look at the trans inside...
Also, if you have too much fluid in the trans it will all be floating in trans fluid and will give you the same effect in any gear....

Dec 29, 2009 | 1996 Ford F350 Crew Cab

3 Answers

88 Toyota Pickup, has become difficult to shift in to gear. Once in gear (1,2,3,or4th) very smooth. I believe must be something up front in the clutch linkage. Possibly? Can get into, but takes awful...


if your linkage was bent it wouldnt shift into all gears easily.sounds like you need to blead your slave cylinder to your clutch.10mm wrench and bleed it like your brakes same type set up.

Nov 24, 2009 | 1988 Toyota Pickup

1 Answer

Hi. second gear is hard to engage. Dealer sugested using synthetic oil, which I did, got a bit better, but still hard to engage the 2nd gear. Any ideas???


Yes the Dealers dident want to tell you that the answer to your problem is because only the 1 gear is doing it that the 2nd gear scrinco is no good and binding up and has to be changed
That means gear box out and stripped down and a new 2nd gear SCRINCO fitted as it should be like all other forward gears nice and easy.
But if still under warranty then thats why they dident tell you.. let me know how you go Ron

Oct 23, 2009 | 2007 Mazda Speed 3 Hatchback

1 Answer

1998 Chrysler Voyager Transmission problem


FYI, My 99' just had a rebuild put in it $2000. Lent it to family, and even before they left I was worried that mileage etc, was just about time for it to go. I had no warning signs, just something in the back of my mind said "anytime now". They made it to their destination 3 or 4 hours away, no problem all the way,then next morning running into town for groceries, spit, sputter clank, bang, done ! Piece came right out through the top of the transmission casing , big hole & a gear laying on top of the casing. Needless to say, they felt bad, but I just had a premonition it was time. That's why when those things act up, don't play around, get it diagnosed a.s.a.p. Trying to get through the week, can cost you big time. Here's to hoping yours is an easy, inexpensive fix.

Apr 21, 2009 | 1998 Dodge Grand Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

257 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...