Question about 2001 Pontiac Bonneville

1 Answer

How do you change the rear reading lamp bulb

How do I replace the bulb inside of the rear reading lamp of my 2001 Bonneville? do I just prier off the plastic len?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

  1. Using a thin bladed tool, carefully pry the lamp lens from the overhead console.
  2. Using a thin bladed tool, carefully pry the metal shield inward until the retaining tabs clear the notches.
  3. Remove the metal shield.
  4. Remove the courtesy lamp bulb.

Posted on Nov 26, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Left rear tail light not working on 2001 dodge stratus


If that's the only light not working, the bulb probably needs to be replaced. To get the lamp housing out so you can change the bulb, open the trunk and pull back the liner on the left rear side - there are usually a couple of plastic fasteners that need to be removed to pull back the liner. You should now be able to see two or three fasteners (plastic or metal) that hold the lamp assembly to the body. Remove these and pull the lamp assembly out to the rear. Remove the bulb holders from the lamp assembly by twisting them a quarter turn counter clockwise, then remove and replace the non-functioning bulb. Reverse to reassemble.

Oct 08, 2016 | Dodge Cars & Trucks

1 Answer

How do you replace the rear brake light for a 2001 VW beetle?


hi,
you will need to remove the tail lamp.
standing behind the vehicle, with the trunk open , inside on the affected side you will see a small plastic cover, remove this and under neath is a nut. remove the nut. now you have to gently prise the tail lamp out(taking care with paint work). start at the outside of the lamp. once removed, changing the bulb is straight foward. you will see the lugs for refitting the lamp.

Jul 26, 2010 | 2001 Volkswagen Beetle

2 Answers

Have no rear parking lamps or dash lights when


In that car the fuse for the rear lights is also the same fuse for the dash lights. They did that so you would know when your tail light were out. Replace the fuse.

Apr 03, 2010 | 1995 Pontiac Bonneville

1 Answer

How do you replace reverse bulb on 2001 deville?


2001 Cadillac DeVille V8-4.6L VIN 9
BACKUP LAMP REPLACEMENT
REMOVAL PROCEDURE
1. Pull down the rear compartment lid trim. Refer to Compartment Lid Trim Replacement - Rear in Trunk/Liftgate.
2. Disconnect the electrical connector.
3. Remove the fasteners that secure the backup lamp assembly.
4. Remove the backup lamp assembly.
5. Remove the bulb assembly.
6. Remove the bulb.
INSTALLATION PROCEDURE
1. Install the bulb into the bulb socket.
2. Install the bulb assembly into the backup lamp assembly.
3. Pull the wire harness through the body and seat the grommet.
4. Install the backup lamp assembly to the rear compartment lid.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the fasteners in order to secure the backup lamp assembly.
Tighten
Tighten the fasteners to 4.5 N.m (40 lb in).
6. Connect the electrical connector.
7. Install the rear compartment lid trim.

Sep 11, 2009 | Cadillac DeVille Cars & Trucks

1 Answer

How do I remove the cover on a 2002 325i BMW tail light wiring? thanks


Do you need to change a bulb or are you changing to custom lamps. If it is bulb replacement open trunk/boot (depending where you live ) the access for the tail lamps is at the rear corners of the trunk, If you are changing lamp lenses or assembly remove the screws( same location ) at lamp corners

Jul 09, 2009 | 2001 BMW 325

1 Answer

2005 town & country reading light


i have the same vehicle... I will go out when the sun comes up and find out for you. I think it will let me post again to this question

Jun 17, 2009 | 2001 Dodge Intrepid

2 Answers

NEED TO CHANGE BULB BUT CAN'T SEEM TO FIGURE OUT HOW TO GET INTO CASING


First open the rear liftgate (not just the glass). This will expose the two screws that secure the housing of the lamp to the body (it also exposes the connector plug which, obviously, you should unplug). After removing the two screws, separate the rubber housing from the LED lamp itself....and there you have it!
The third brake light might be a sealed lamp, so the entire brake light must be changed. you can't just replace the bulbs.
I hope this helps.

May 21, 2009 | 2001 GMC Yukon XL

1 Answer

HOw do I change the tail light 2001 Taurus?


pop the trunk and where the tail lamp assembly is pull the carpet back from the inside you shold then be able to see some nuts that hold it in place remove those pull out the assembly replace bulb then install assembly back on vehicle ... hope this helps

Mar 27, 2009 | 2001 Ford Taurus

1 Answer

Hi, I have a 2002 Pontiac Bonneville and I don't have the Owners Manuel. I wanted to know how to change the Brake Light. I noticed when I open the trunk that electrical wiring is sealed. It looks like I...


I replaced mine - it is easy - this is right from the manual
open trunk, turn screws located inside of trunk counterclockwise (on the inside where the tail light is), remove the plastic piece, pull carpeting away remove the 3 nuts holding the lamp in place and the lamp will pull out. Press the release and turn bulb socket counterclockwise to remove it.

Dec 05, 2008 | 2002 Pontiac Bonneville

2 Answers

Right turn signal not working, front, back or dash indicator


First check the fuse of the indicator ,it may have been blown ...



Good luck...



Nov 12, 2008 | 2001 Pontiac Bonneville

Not finding what you are looking for?
2001 Pontiac Bonneville Logo

Related Topics:

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6880 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...