Question about 1986 Toyota Land Cruiser

1 Answer

High CO on state emmision testing

I am trying to get my 1986 60 series land crusier to pass texas state emmisions test

Posted by on

  • Anonymous Feb 25, 2009

    1988 NOVA,WILL NOT PASS EMMISSIONS,HAVE DONE CAT COV,OXY SENSOR,NEW PLUGS,NEW ROTOR,WILL NOT PASS?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

High CO is caused by too much fuel. The carburetor needs adjusted or rebuilt.

Posted on Jan 25, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the cause of water dripping out exhaust pipe and engine smoking excessively?


Cold weather right? Dripping is the water condensing from the exhaust gases. The "smoke" is more than likely water vapor, just like your breath in cold weather. If you have smoke (black) in warmer weather, you have an excess fuel problem and won't pass emmision tests. If blue smoke you have oil leaks into the coubustion chamber. Also will not pass emmisions test.

Mar 04, 2015 | 2003 Ford Explorer

1 Answer

Emission problem


Until the system performs a full self test, this is referred to as an "OBD 2 drive cycle test"

Mar 04, 2014 | Cars & Trucks

1 Answer

Why is my land rover discovery failing emmisions due to the computer not ready?


You are having a comms problem. Follow thie link below and see if it helps. http://www1.snapon.com/display/3871/LandRover_vcs.pdf. If this one fails you might have a problem that is normally VAG, the radio. Go to www.rosstech.com and search for "aftermarket radio"

Oct 03, 2012 | 1997 Land Rover Discovery

1 Answer

What can i do to my 95 land rover discovery to fix high HC readings so i can pass my emmisions test?


Start by having a fresh oil change and drive it until the engine is hot as poss before the next attempt.

Aug 24, 2012 | Cars & Trucks

1 Answer

I have an 06 cobalt ls and my battary died and i got it jumped to get to the garage and get it emmisions and inspected.. but when they ran the emmisions test it passed everything but the OBD2 failed do to...


Unfortunatly you will have to complete what is called a drive cycle - it is the only way for the computer to recognize all aspects of the state of the vehicle. It sucks but you have to do it - take it from a mechanic that had to take hours getting a test to pass

Mar 15, 2011 | 2006 Chevrolet Cobalt

1 Answer

97 Buick Lesabre, had emmisions test done (which it passed) as soon as leaving emmisions test check engine light came on. Any ideas what may have caused this?


Stop by any good parts store (Autozone, Advance, etc) and have them do a FREE OBII scan. It will read all your fault codes and more than likely light came on because of emission test. But have them read the faults and reset your light.

Feb 23, 2011 | 1997 Buick LeSabre

1 Answer

High CO emmisions from my Volkwagen Golf


you need to run a specific cleaner in your gas, it cleans the cat, also it is called HT-1 and is made by MALCO PRODUCTS it runs about $45

Aug 26, 2009 | 1997 Volkswagen Golf

2 Answers

1996 jimmy failed an emission test


Did you change the air filter. The fuel filter will have no impact on emmision's but the air filter is a very common problem.If you usually drive it at low rev.'s then before you send it for emmisions test you will need to put it in a low gear and floor it for about a mile the reason is when it is being tested the engine is reved up to around 3500 rpm and any build up of unburned fuel or oil in the exhaust system will put up the emmisions reading.

Aug 19, 2009 | 1996 GMC Jimmy

1 Answer

Spark plug failing Fix and emmision test says still misfiring


try changing the o2 senser that will cause the car to run rich or lean

May 16, 2009 | 1998 Ford Windstar

1 Answer

Wont complete scan to pass emission test


When you rest your codes there is a series of tests your ECU has to go through before you can pass emissions. this is done some people can reset the code and go before its sets the code again. on the 96 you can have 2 tests not complete for it to pass. basicly you have to drive the car a couple days for the tests to pass.

check the readiness tests wait until only 2 have not passed. then you should be good.so drive and check.

Michael
ASE certified
PLZ rate.

Feb 09, 2009 | 1996 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

157 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

66744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...