Question about 2001 Chevrolet Venture

1 Answer

Electric window buttons not working

The driver side buttons will not bring the electric windows up or down. Is this a common problem and how can this be fixed. Is it easy to take the pannels off, I know it is not a fuse its fine but I need to know how this can be fixed?

Posted by on

  • Paul Hertel
    Paul Hertel May 11, 2010

    do you use a key fob to lock the door?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 62 Answers

Either your motor or the regulator needs to be replaced which means taking the door panel off. I would replace the motor if it doesnt work on either driver or passenger controls and the regulator if it doesnt work on just the one side. I hope that helps you out.

Posted on Nov 25, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Drivers window


does the motor make noise when pressing the window button? Your cable that brings the window up and down may have snapped. Open the door and take off the interior trip. See if there is a steel cable hanging around. Replace as need. Note it is better to buy the WHOLE assembly with the steel cable and the motor.

Dec 11, 2013 | 2004 Cadillac Deville

1 Answer

I have a 2011 camry. My rear right power window does not work from driver main switch. please help.


Most often when the car battery is removed for any purpose, most of the components are required to be re-learned again.Probably it needs to be re-learned as follows:Please sit on the rear right seat, press the window button to lower it. When it come down hold the button for not more than 3 seconds. Release the button. Then pull the button to bring the window up and hold it again for 3 seconds after it touches the upper rest, and then release it.
Now check the window operation by operating it from driver side button.
It is supposed to work fine. If not then check the driver side toggle switch, wire harness for looseness or discontinuity.
Regards,
Shadab Lodhi

Feb 03, 2013 | 1997 Toyota Camry

1 Answer

2005 Dodge Durango passenger window wont go down from drivers side switch


It sounds like everything else and the wiring is okay, only that button on the driver's switch is not working. I would try a new switch, if you see nothing wrong with the electrical plug for it when you take it off.
If that down wire was broken somewhere from the driver switch to the passenger door, I don't think the driver's switch would work for it either way, up or down. And same, neither would the passenger switch work. I think the button for down is not making contact somehow, and right in the switch.

Jan 10, 2013 | 2005 Dodge Durango

3 Answers

The driver side window button does not roll the window up or down, but the other windows work fine. Could the problem be in the button or the motor?


Its the window switch. I stopped getting "clicking" action on my driver side/driver window button, so I switched it with one from a back window (meaning I couldnt roll down the back one from the driver side control anymore. This was temporary. I went to the junk yard and of 12 98/99 devilles, all of them had the switch pulled already. It is a pretty common problem I guess. New aftermarket cost around $80. All you need is a screwdriver to get at it, plug in the new one and you are fine.

Aug 20, 2010 | 1999 Cadillac DeVille

1 Answer

2000 rodeo drivers side electric window goes up but not down?


pull the control switch out n clean contacts or try and spay contact cleaner on them

Jun 13, 2009 | 2001 Isuzu Rodeo

1 Answer

Pass.side power window won't work.


First be sure the window lock in the drivers side master switch is not LOCKED. This will prevent the windows from being rolled down by any other switch. (p106+)

Usually windows operate off a RELAY - not a fuse... and all the windows work off the same power relay.

Your Relay Part Number is 41-5021.
Here is the electrical schematic for your windows - showing the relay is common to all windows.

6713bdf.gif
CLICK HERE for a better pic.

If the relay is replaced - and/or tested good, You will need to remove the offending door's panel and verify the motor is getting 12VDC when you press the button for it to go down.

If there is 12VDC when you push the button, the motor is bad.

If there is NOT 12VDC when you push the button - the master switch or child lock bypass switch is faulty.

Click HERE for a PDF version of your owners manual

Under the ROADSIDE EMERGENCIES section (p.245) you will find a layout diagram of your fusebox.

P.248 instructs to pull DOWN on the fusepanel door to access... however your power window relay is located under the driver's side dash.



If the other windows work - there are 3 options to test/replace - in this order
1. Relay
2. Master Switch
3. Window motor.


Thanks for using FixYa - a FixYa rating is appreciated for taking the time to answer your FREE question.

Mar 20, 2009 | 1998 Mercury Villager

4 Answers

2004 Jeep Grand Cherokee driver side power windows do not work


I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.

Nov 25, 2008 | 2004 Jeep Grand Cherokee

Not finding what you are looking for?
2001 Chevrolet Venture Logo

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...