2006 Jeep Liberty Logo
Posted on May 25, 2012

Ac clutch not engaging checked freon level checked good all other checked good think it is electrical jumped cluch and did work so it is not problem I need help [email protected] I have a 2006 jeep liberty sport

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

  • Contributor 4 Answers
  • Posted on May 25, 2012
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Joined: May 25, 2012
Answers
4
Questions
0
Helped
937
Points
12

Sounds like you have either no power goin to compressor or comp. could be locked up.run a check by puttin selector on defrost it should kick in,if not ron a jumper from bat to compressor wire hook-up should make some noise if not clutch is probably bad if you definetly have coolant in it.you know ootherwise it wont

5 Related Answers

Anonymous

  • 335 Answers
  • Posted on Aug 21, 2008

SOURCE: 2001 jeep cherokee sport 4.0L

Is there power to the A/C relay? Did you receive the wiring diagram i sent to you?

Ad

Anonymous

  • 475 Answers
  • Posted on Feb 11, 2009

SOURCE: i have a 2006 jeep liberty and three lights are staying lit and

You need to take the jeep to a dealer or a good mechanic who can retreive the codes out of the computer. You may have a module problem but I will not guess without knowing the codes.

Anonymous

  • 6982 Answers
  • Posted on Jun 18, 2009

SOURCE: Neither turn signals work on jeep liberty 2006 sport

Signals are now controlled by a module on the right side of the steering column under the dash. Before doing anything yourself, bring it to the attention of the guys that did the rear...This problem can happen at any time but they may have disconnected a harness or ground while working, so give them a chance first to correct it.

Greg

  • 70 Answers
  • Posted on Sep 17, 2009

SOURCE: ac not working

1st you must check for correct refrigerant levels in ac system, must be done with a/c guages, you have a pressure switch that senses correct pressure in a/c system if you are low in refrigerant the a/c will not come on. if you have good pressures high side 70-95 low side 70-95 depends on ouitside air temperature, with the engine off then look at the switch in the high pressure line, jeep also has a fuse in the fuse box under the hood and a a/c relay please check those too. I hope this helps. (red is high side hose- small fitting plug , blue is low side- larger fitting If ac is working and compressor is on good pressure ranges from high side the red hose 160 to 230 depending on temperature outside; low side blue hose 27-46 low side depending on outside temperature, Wear glasses to protect your eyes. I hope this helps good luck

Iā€™m happy to help further over the phone at https://www.6ya.com/expert/gregory_8e6ba270263743ac

Anonymous

  • 1985 Answers
  • Posted on Dec 04, 2009

SOURCE: I have a 2008 Jeep Liberty sport it has 39600 back-up lights not

If you have tested fuses and bulbs with test light,and they check out,
the next step is to put you jeep in reverse with the key on,and use your test light to probe the wires before they enter the bulb sockets for power,if you have power replace sockets,if not check to make sure wires are still connected to back up light switch on trans,if you find no problem there,replace the switch

Testimonial: "Thank you for the info on my jeep. I brought it to my mechanic and he could not find where the new switch goes.I will bring it to the dealer."

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have 2007 chrysler pacifica the ac clutch won't engage so I did it manually but it won't stay on

The clutch is engaged when you have power going to it AND there is enough freon pressure in the system. Check the freon level, if low add some and the clutch should engage when the pressure is high enough, like 50 to 75 psi. If you have pressure, check the fuse and electrical connections for a loose wire.
0helpful
1answer

Air conditioner electric circuit

Try disconnecting battery for two minutes to reset the system. Then start the car and check a/c operation.
0helpful
1answer

Ac clutch

fuse could be blown or freon level is low in system. Ac units think of like a basketball with air loss over time likewise in an older ac unit with rubber seals deteriorating low freon level will not allow compressor to engage
6helpful
5answers

My ac compressor on my dodge 2500 want engauge?

This could be a few things. The freon could be low, one of the switches (high or low pressure) could be bad, or you could have a bad compressor clutch. You can test the clutch by checking for battery voltage and ground at the two pin connector with the A/C on if you have both power and ground, then the clutch is bad. You really should start by hooking up pressure gauges to the A/C ports to check the pressures, and these vary depending on ambient temperature and whether the A/C compressor is engaged or not. I am willing to bet that the freon is low though and may be just as simple as recharging the system.
Hope this helps. Good luck!
0helpful
2answers

A/C clutch won't engage

ur still way low in freon the compressor clutch is designed to disengage when low on pressure so as not to overheat and seize causing possible damage to engine two ways to engage clutch --one is to jump clutch and continue to fill or keep adding freon until clutch pulls in
1helpful
2answers

AC not working

The A/C system has a pressure sensor that detects the freon level in the system. If you lost freon, the clutch that engages the compressor will not engage. A good indicator is to turn on the A/C and watch the compressor/clutch assembly. If the pulley is spinning and the clutch is not, odds are you have a freon leak. Good luck!!
1helpful
3answers

Air conditioning

If there is no r-12 or freon in the system it wont come on. Try jumping the pressure switch. It's a 2 wire plug somewhere one the AC lines. Just pull it off and jump the wire end with another wire.If the clutch engages you need freon or R-12.
0helpful
1answer

1997 Eagle Talon AC button switch blinks AC won't work

If the button is blinking, this means the clutch is either worn out, or the clutch is not engaging because of an electrical problem. Check the electrical connection going to the AC, does it look alright? Is there any fluid inside the connector? I would replace the AC compressor if the clutch persists to not engage.

Iā€™m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

Not finding what you are looking for?

435 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...