Hi there:
The crankshaft position (CKP) system variation learn feature is used to calculate reference period errors caused by slight tolerance variations in the crankshaft, and the CKP sensors. The calculated error allows the powertrain control module (PCM) to accurately compensate for reference period variations. This enhances the ability of the PCM to detect misfire events over a wider range of engine speed and load.
Conditions for Setting the DTC:
The CKP system variation values are not stored in the PCM memory.
Action Taken When the DTC Sets:
The control module illuminates the malfunction indicator lamp (MIL) on the second consecutive ignition cycle that the diagnostic runs and fails.
The control module records the operating conditions at the time the diagnostic fails. The first time the diagnostic fails, the control module stores this information in the Failure Records. If the diagnostic reports a failure on the second consecutive ignition cycle, the control module records the operating conditions at the time of the failure. The control module writes the operating conditions to the Freeze Frame and updates the Failure Records.
Conditions for Clearing the MIL/DTC:
• The control module turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
• A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
• A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
• Clear the MIL and the DTC with a scan tool.
Diagnostic Aids
The CKP system variation values are not stored in the PCM memory after a learn procedure has been performed. If the actual CKP variation is not within the CKP system variation compensating values stored in the PCM, DTC P0300 may set.
The CKP system variation learn procedure is also required when the following service procedures have been performed, regardless of whether DTC P1336 is set.
An engine replacement
A PCM replacement
A harmonic balancer replacement
A crankshaft replacement
Any engine repairs which disturb the CKP sensor relationship
If the CKP system variation learn procedure cannot be performed successfully, check for the following conditions and correct as necessary:
A damaged reluctor wheel
Excessive crankshaft runout
A damaged crankshaft
Interference in the signal circuit of the CKP sensor
A coolant temperature that is not within the Conditions For Running the DTC
The ignition switch is in the ON position until the battery is drained
A PCM power disconnect with the ignition ON may erase the stored value and set the DTC P1336
Hope this helps.
SOURCE: 98 sonoma dashboard light replacement
take the dash apart on the driver side and it will be up in the cluster panel
SOURCE: HOW TO CHANGE DRIVE BELT ON MY 98 GMC SONOMA 4
it may be easier to attach the breaker bar to the tensioner arm from under the vehicle to relieve belt tension
To install:
SOURCE: How do you reset your service engine light on your
you need a scanner to reset the service engine soon light but it will come back on until you fix the problem you need to check system to get a trouble code
SOURCE: need the location of knock sensor in my 98 gmc
The knock sensor is on the rear of the motor behind the left cylinder head.Hope this helps.Good luck.
SOURCE: I have a 98 GMC Sonoma. The headlights will not
well try this it would make you laugh if this work check your floor brake pull up on it all the way and see if it comes on when the park brake is on they turn the lights off and if there not up all the way it will keep it from coming back on. hope that works for ya.
426 views
Usually answered in minutes!
×