Question about 1997 Honda CR-V

1 Answer

All passenger door power windows are not working

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Hey,

I know this might sound stupid, but have you tried turning off the master window switch? From the driver seat, you should have control over the 4 windows plus there is a switch that controls if you want to allow the passengers to use the control of the windows

Posted on Dec 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove the right front door panel on a 2004 buick le saber


Did you test it or are you guessing just because it won't open or close ? How To Install Remove Front Door Panel Buick Lesabre 00 05 1AAuto com both right an left are the same .
Power Windows System Components
The following components are used to control the power windows:
?€¢
Driver Door Module (DDM)


?€¢
Passenger Front Door Module (PDM)


?€¢
LH Rear Door Module (LRDM)


?€¢
RH Rear Door Module (RRDM)


?€¢
Driver Door Switch Assembly (DDSA)


?€¢
RH Front Power Window Switch


?€¢
LH Rear Power Window Switch


?€¢
RH Rear Power Window Switch


?€¢
LH Front Power Window Motor


?€¢
RH Front Power Window Motor


?€¢
LH Rear Power Window Motor


?€¢
RH Rear Power Window Motor


?€¢
Class 2 serial data circuit


?€¢
Power door serial data circuit


?€¢
PWR WDO 30 Amp Circuit Breaker


?€¢
DRVMDL Fuse (10 amp)


Driver Door Switch Assembly and Driver Door Module logic, Driver Door Module internal driver operation


?€¢
PASS MDL Fuse (10 amp)


Front Passenger Door Module logic and internal driver operation


?€¢
RRDR MDL Fuse (10 amp)


Left Rear Door Module and Right Rear Door Module logic and internal driver operation


Do you know about computer controlled power windows ?
Power Windows Operation
The vehicle is equipped with power windows controlled by the door modules. Each passenger door window can be operated, either from a switch built into the driver door switch assembly (DDSA), or from a switch mounted locally to its associated door. The driver door window can be operated only from the driver door window switch built into the DDSA.
When a window is operated from the DDSA, the DDSA interprets the window switch signal as a specific window switch request and sends the information to the driver door module (DDM) via the power door serial data circuit. The DDM examines the request and checks to see if it has received any class 2 serial data messages from any of the other vehicle modules (i.e. ignition switch position) prohibiting the movement of the window. If the window being operated is the driver door window, and if no prohibitive class 2 messages have been received, the DDM then applies voltage and ground to the driver door window motor to move the window glass as requested. If the window being operated is a passenger door window, and no prohibitive class 2 messages have been received, the DDM sends the request, via the power door serial data circuit, to the appropriate passenger door module. The passenger door module then applies voltage and ground to the passenger door window motor to move the window glass as requested.
When a passenger door window is operated from the power window switch mounted locally to its associated door, the passenger door module first checks to see if the DDM has received any prohibitive class 2 serial data messages. If there are no prohibitive messages, the passenger door module powers the associated passenger door window motor.
Both front door windows have the express down feature. This allows the front door windows to be fully opened by momentarily pulling the appropriate window switch lever to the second detente and then releasing.

Oct 30, 2016 | Buick Cars & Trucks

1 Answer

2001 Pontiac Bonneville Power locks and power windows dont work


Your power windows an door locks are controlled by a door module .
The vehicle is equipped with power windows controlled by the door modules. Each passenger door power window can be operated, either from a switch built into the driver door switch assembly (DDSA), or from a switch mounted locally on its associated door. The driver door power window can only be operated from the driver door window switch built into the driver door switch assembly (DDSA).
When the driver door module (DDM) receives a window switch request from the DDSA, the DDM checks the Class 2 serial data to see if the status information is correct (i.e. ignition switch position) to permit window operation to occur. If the status information is correct, the DDM, either supplies power and ground to its associated window motor, or, if the request is for one of the passenger windows, sends a command via the power door serial data circuit to the passenger door module (PDM, LRDM, or RRDM) controlling the window. The passenger door module (PDM, LRDM, or RRDM) controlling the window then supplies power and ground to its associated window motor to move the window as requested.
When one of the local window switches mounted on one of the passenger doors is operated, the associated door module examines the request and checks to see if there are any messages from the DDM prohibiting the movement. If conditions are correct, and no prohibitive messages have been received from the DDM, the associated door module then supplies power and ground to its associated window motor to move the window as requested.
Your best bet would be to take your vehicle to a qualified repair shop !

Aug 06, 2016 | Pontiac Cars & Trucks

2 Answers

2005 Gmc Sierra 5.3 litter SLT. Wire diagram for passanger side power window. No power to door.


Do the power door locks work for that door ? Does you vehicle have door courtesy lights , turn signals on the mirror ? If your vehicle has these other options an they work , you have power to the door . There is an electronic module inside the door ,called passenger door module ! where did you check for power at , the window switch ! These are computer controlled an you would only see a few volts when pushing the switch !

7

  1. Monitor the passenger front window status in the passenger door module inputs list.
  2. Activate the passenger power switch on the passenger door module in the up and down positions.
Does the window status data parameter change accordingly?
Go to Step 8
Go to Step 15

8

  1. Monitor the passenger front window status in the driver door module inputs list.
  2. Activate the passenger front power window switch on the driver door module in the up and down positions.
Does the window status data parameter change accordingly?
Go to Step 9
Go to Step 16
Operate the passenger front power window in the UP and DOWN directions from the master switch.
Does the passenger front power window operate properly from the master switch?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
Go to Step 5

4

  1. Install a scan tool.
  2. Monitor the window lockout data parameter in the driver door module inputs list.
  3. Activate the window lockout switch to both the On and OFF positions.
Does the window lockout data parameter change state appropriately?
Go to Step 5
Go to Step 16
Your best bet is to take this to dealer or a ASE certified repair shop.

Jun 14, 2015 | GMC Cars & Trucks

1 Answer

2002 chevy blazer passenger power window will not power up, dead as a door knob.


if all the windows work but the passenger side then its not a fuse its the power window switch in that door pop the switch out and unplug it then take the switck out of the back door if it is four door and plug it in if it rolls the window up you need a new switch

Oct 07, 2012 | 2002 Chevrolet Blazer

2 Answers

2005 Honda Accord, all three passenger power windows stopped working. The drivers window works and the window lock is not on. When I try the switch on each of the passenger windows i cvan hear a clicking...


you most likely have a power/ground/switch issue in the drivers door. the power for the other three doors must first travel through the switches in the driver door before it goes to the passengers. hence the reason why when somebody rolls down a passenger window and you push the up button on the driver door the window stops moving. the wires can break inside the rubber boot in the door jam. you can also have an internal problem with the driver door switch unit. you would need a wiring diagram to diagnose this concern.

Mar 23, 2010 | 2005 Honda Accord

6 Answers

Windows won't roll down


Does the rear window work from the passenger switch?

Oct 07, 2009 | 2003 Cadillac CTS

1 Answer

Passenger door is died no power


The passenger door switch wire harness may be damaged. All the things you have listed work through the passenger door switch. It can be damaged when water or any other fluid enters the switch assembly.

Aug 11, 2009 | 2007 Chevrolet Avalanche LTZ

1 Answer

1999 Buick Century - passenger side power window does not work


Replace the Driver side window switch. These have a corrosion issue.

Mar 27, 2009 | 1999 Buick Century

1 Answer

92 F150 power window and locks


try taking apart and cleanig all contacts first. make sure you are getting power to switch. Sounds more switches are going bad. They usually last about 5 to 7 years before they start going out.

Jun 11, 2008 | 1992 Ford F150 SuperCab

Not finding what you are looking for?
1997 Honda CR-V Logo

Related Topics:

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...